Brother DCP-7065DN user manual

To replace the drum on Brother DCP-7065DN, follow the steps below:
1. Make sure that the DCP-7065DN is turned on, and then open the front cover.
. Take out the toner cartridge and drum unit assembly from the machine.
3. Press the green lock lever and take the toner cartridge out of the drum unit.
4. Unpack the new drum unit from its packaging.
5. Put the toner cartridge firmly into the new drum unit until you hear it lock into place.
6. Clean the primary corona wire by sliding the green tab from left to right and right to left several times.
7. Insert the toner cartridge and drum unit assembly back into the DCP-7065DN.
8. Close the front cover.
That's it! You have successfully replaced the drum on Brother DCP-7065DN.

To reset your Brother DCP-7065DN printer, you can follow these steps:
1. Turn off the printer and unplug it from the power source.
. Wait for 10 seconds and then plug the printer back into the power source.
3. Press and hold the "Menu" button on the printer's control panel.
4. While holding the "Menu" button, turn on the printer using the power switch.
5. Keep holding the "Menu" button until the LCD screen shows "Machine Error XX" (XX can be any number, usually "46" for reset).
6. Release the "Menu" button and then press the number keys 9, 9.
7. The LCD screen should now display "Maintenance."
8. Press the "Arrow Up" or "Up" button until you see "Shipping Mode."
9. Press "OK" or "Set" to enter the Shipping Mode.
10. The printer will display a message saying, "Resetting..."
11. Once the reset process is complete, the printer will restart.
After the reset, your Brother DCP-7065DN printer should be back to its factory default settings. Keep in mind that performing a reset may erase any stored settings or data on the printer, so make sure to backup any important information before proceeding.