Bosch SMS65E32GB user manual

There could be several reasons why your Bosch dishwasher is not starting. Here are some troubleshooting steps you can try:
1. Check the power supply: Make sure the dishwasher is properly plugged into a functioning outlet. If it is plugged in, try plugging in another device to ensure the outlet is working.
2. Check the door latch: Ensure that the dishwasher door is fully closed and latched properly. If the door is not closing properly, the dishwasher will not start.
3. Check the control panel: Inspect the control panel for any error codes or indicators that may be displayed. Refer to the dishwasher's manual for information on what the error codes mean and how to resolve them.
4. Check the water supply: Make sure the water supply valve under the sink is fully open. If the dishwasher does not detect a sufficient water supply, it will not start.
5. Check for a tripped circuit breaker: If the dishwasher is not receiving power, check the circuit breaker in your electrical panel to see if it has tripped. If it has, reset it and try again.
6. Check the float switch: It is possible that the float switch, which detects the water level, is stuck or malfunctioning. Look for any visible debris or blockages around the float and clean it if necessary.
7. Check for a clogged or blocked drain: If the dishwasher is not draining properly, it may prevent the dishwasher from starting. Check the drain hose and ensure it is not clogged or kinked. Clean or unclog the drain if necessary.
If none of these steps resolve the issue, it might be a malfunctioning component within the dishwasher itself. In such cases, it is advisable to contact a professional technician or the Bosch customer service for further assistance.

On a Bosch dishwasher, "0 01" can refer to the duration of the selected washing program. In this case, "0" indicates zero hours and "01" represents one minute. This means that the selected program will run for one minute.

To reset the "check water" error on a Bosch dishwasher, you can try the following steps:
1. Start by turning off the dishwasher and unplugging it from the power source. If it is hardwired, you can turn off the circuit breaker that supplies power to the dishwasher instead.
2. Leave the dishwasher unplugged or powered off for about 5 minutes to allow the electronic control board to reset.
3. After the 5 minutes are up, plug the dishwasher back in or turn on the circuit breaker.
4. Once the dishwasher is powered on, close the door and select a new cycle.
5. Allow the dishwasher to run for a few minutes until it starts filling with water.
6. Check if the "check water" error message has cleared from the display. If it has, then the reset was successful.
If the error message persists after following these steps, there may be an underlying issue with the dishwasher's water supply or water inlet valve. In this case, it is recommended to consult the user manual for further troubleshooting or contact Bosch customer support for assistance.