Bosch INDEGO user manual

Adjusting the cutting height on a Bosch Indego lawn mower is pretty easy. Here are the steps:
1. Locate the cutting-height adjustment button. This is usually located on the top of the mower.
2. Press the button and hold it down.
3. While still holding the adjustment button, slide it upward or downward. Sliding it up will increase the cutting height, while sliding it down will decrease it.
4. Release the adjustment button once you got your desired height.
Remember to power off and disconnect the mower from its power source before adjusting the cutting height to avoid injury.

To clean your Bosch Indego robot lawn mower, follow these steps:
1. Turn off the mower and disconnect the power supply to ensure safety.
. Remove the cutting disc and clean it separately using a brush or cloth to remove any grass clippings or debris.
3. Use a clean and dry cloth to wipe down the surface of the mower, removing any dirt or dust.
4. Pay attention to the wheels and carefully remove any grass or debris stuck in them.
5. If there is a lot of accumulated grass or debris inside the mower, use a vacuum or air blower to clear it out.
6. Check the blades for any signs of damage or dullness. If required, replace the blades following the manufacturer's instructions.
7. Inspect the perimeter wire and connectors to make sure they are not damaged and functioning properly.
8. Clean the sensors and sensors' lenses with a soft cloth to ensure the mower's navigation system is working correctly.
9. For the charging station, remove any grass clippings or debris around it using a brush or cloth.
10. Once the mower and its components are clean and dry, reassemble and reconnect everything.
11. Place the Bosch Indego back on the charging station and ensure it is charging properly before the next use.
Note: Always consult the user manual for specific cleaning instructions and safety precautions for your Bosch Indego model.

To reset your Bosch Indego robot lawnmower, follow these steps:
1. Turn off the Indego by pressing the "Power" button located on top of the device.
. Disconnect the power supply from the charging station and remove the robot from the docking station.
3. Turn the robot lawnmower upside down, so that the wheels are facing upwards.
4. Locate the reset button on the underside of the device. It is a small hole marked with the word "Reset."
5. Use a small, pointed object (such as a paperclip or a pin) to press and hold the reset button for approximately 5 seconds.
6. Release the reset button.
7. Turn the Indego back over and place it back on the docking station.
8. Reconnect the power supply to the charging station.
9. Wait for the Indego to start up and initialize. This process may take a few minutes and the mower may move slightly during start-up.
10. Once the initialization is complete, the Indego should be reset to its factory settings.
Note: Resetting the Bosch Indego will erase all settings and data, including mowing schedules, zone configurations, and personalized settings, so you may need to reconfigure them after the reset.