Beko REFRIGERATEURS user manual

To set the temperature on a Beko refrigerator, follow these steps:
1. Locate the control panel or temperature dial on the front or inside of the refrigerator. It is usually located near the top or at the back of the refrigerator compartment.
2. Turn the control dial or press the buttons to adjust the temperature. Some models have a dial that you can turn clockwise or counterclockwise to increase or decrease the temperature. Other models may have buttons with temperature indicators that you can press to adjust the desired temperature.
3. Refer to the temperature settings recommended in the user manual or on the label inside the refrigerator. These recommended settings usually range from 1 to 7 or have specific temperature indicators like "cool to warm."
4. Set the temperature according to your preference. Keep in mind that the recommended setting for the refrigerator compartment is around 37°F (3°C) to keep your food fresh, while the freezer compartment should be around 0°F (-18°C) to keep items frozen properly.
5. After setting the desired temperature, wait for a few hours for the refrigerator to stabilize and reach the new temperature. Monitor the temperature using a refrigerator thermometer to ensure it is maintained consistently.
Note: The specific steps to set the temperature may vary slightly depending on the model and features of your Beko refrigerator. It is always advisable to consult the user manual provided by the manufacturer for detailed instructions tailored to your specific model.

There could be several reasons why your Beko fridge freezer is not getting cold. Here are a few possible causes:
1. Power issue: Check if the fridge freezer is properly plugged into an electrical outlet and that the outlet is working. Make sure the power cord is not damaged.
2. Temperature settings: Ensure that the temperature settings on the fridge and freezer compartments are set correctly. The settings might have been accidentally changed, causing the appliance not to cool properly.
3. Door seal: Check if the door seal is sealing properly. A loose or damaged seal can result in warm air entering the fridge freezer, preventing it from cooling effectively.
4. Blocked air vents: Inspect the air vents in both the fridge and freezer compartments to see if they are blocked by items placed too close to the vents. Blocked air vents restrict the airflow, hampering the cooling process.
5. Condenser coils: The condenser coils at the back of the fridge freezer may be dirty or clogged with dust and debris. Clean the coils and ensure there is enough space around them for proper airflow.
6. Faulty thermostat: The thermostat controls the temperature inside the fridge freezer. If it is faulty, it may not be reading the temperature correctly or not functioning at all. In this case, you may need to replace the thermostat.
7. Faulty compressor: The compressor is responsible for the cooling process. If it is not working properly, it will not be able to cool the fridge freezer. A professional technician may be required to diagnose and replace a faulty compressor.
If none of these potential solutions resolve the issue, it is recommended to contact a Beko authorized service center or a qualified appliance repair technician to further diagnose and fix the problem.

In a Beko fridge, the higher the number, the colder the temperature. So, 5 would be colder than 1.

The recommended setting for a Beko freezer is typically -18 degrees Celsius (-0.4 degrees Fahrenheit). This setting ensures that the food is frozen and stored at the appropriate temperature. However, it is always best to refer to the user manual specific to your model for accurate instructions.