Beko DTKCE90021W user manual

The location of the reset button on a Beko appliance may vary depending on the specific model and type of appliance. However, in many Beko appliances, including dishwashers, washing machines, and refrigerators, the reset button is typically located either on the control panel or near the power cord. It is recommended to refer to the user manual or contact Beko customer support for precise instructions related to the specific model of the appliance.

To clean the filter on your Beko dryer, follow these steps:
1. Locate the filter. It is usually located inside the door opening or on top of the machine. Refer to your user manual if you're having trouble finding it.
2. Open the filter. Some models have a handle or latch to open it, while others may require you to gently pull it out.
3. Remove any visible lint. Use your fingers or a soft brush to remove lint or debris from the filter. Make sure to do this carefully and gently to avoid damaging the filter.
4. Rinse the filter. If your filter is washable, you can rinse it under warm running water to remove any remaining lint or residue. Avoid using harsh chemicals or abrasive cleaners.
5. Dry the filter. After rinsing, shake off any excess water and pat it dry with a clean, lint-free towel. Ensure the filter is completely dry before placing it back in the dryer.
6. Reinstall the filter. Insert the clean and dry filter back into its original position. Make sure it fits securely and is properly aligned.
7. Clean the area around the filter. While the filter is out, take the opportunity to wipe down the surrounding area with a damp cloth to remove any dust or debris.
8. Close the door. If you had to open the dryer door to access the filter, close it securely.
Regularly cleaning the filter is essential to maintain the efficiency and performance of your dryer. Be sure to consult your specific model's user manual for any additional instructions or precautions related to cleaning the filter.

To reset your Beko sensor dryer, you can follow these steps:
1. Ensure that the dryer is not running or in the middle of a cycle. If it is, wait for it to finish or press the "Cancel" button to stop it.
2. Locate the power cord of the dryer and unplug it from the electrical outlet.
3. Wait for about 1-2 minutes to allow the internal systems to fully power down.
4. Plug the power cord back into the electrical outlet.
5. Press the power button to turn on the dryer.
6. Your Beko sensor dryer should now be reset and ready to use.
If the issue or error persists after resetting the dryer, it might be helpful to consult the user manual or contact Beko customer service for further assistance.

There could be a few reasons why your Beko dryer is not heating up. Here are some potential causes:
1. Power supply: Check that the dryer is properly plugged in and that the electrical outlet is functioning correctly. Ensure that the circuit breaker or fuse for the dryer is not tripped.
2. Heating element: The heating element is responsible for producing the heat in the dryer. If it is faulty or broken, the dryer will not generate heat. You may need to replace the heating element.
3. Thermal fuse: The thermal fuse is a safety feature that prevents the dryer from overheating. If it is blown, the dryer will not heat up. You may need to replace the thermal fuse.
4. Thermostat: The thermostat regulates the temperature in the dryer. If it is malfunctioning, it can cause the dryer to not heat up properly. The thermostat may need to be repaired or replaced.
5. Ventilation: Poor or clogged ventilation can lead to overheating or insufficient airflow in the dryer, which can result in no heat. Ensure that the dryer vent hose is clear of any blockages and that the venting system is clean.
If you have tried these troubleshooting steps and the issue persists, it is recommended to contact a professional technician or the manufacturer's customer service for further assistance.