Beko DFN28R20W user manual

There could be a few reasons why your Beko dishwasher is not drying properly:
1. Incorrect settings: Make sure that you have selected the appropriate drying cycle on your dishwasher. Some models have a separate drying cycle or an option to enable dry heat.
2. Rinse aid is not being used: Ensure that you have filled the rinse aid dispenser in your dishwasher. Rinse aid helps to remove water spots and speed up the drying process.
3. Clogged spray arms: If the spray arms inside your dishwasher are clogged with debris or mineral deposits, it can affect the distribution of water and hinder the drying process. Clean the spray arms regularly to ensure proper water flow.
4. Overloading the dishwasher: If you are overloading the dishwasher by placing too many dishes or items too close together, it can prevent the hot air from circulating properly during the drying cycle. Try reducing the number of items in each load and spacing them out to allow for better airflow.
5. Temperature issue: Check if the water heater in your home is set to a suitable temperature. If the water entering the dishwasher is not hot enough, it can affect the drying process. Adjust the water heater temperature accordingly.
6. Malfunctioning heating element: The heating element in your dishwasher is responsible for providing the necessary heat for drying. If it is defective or damaged, it may not be able to generate enough heat to dry your dishes properly. In this case, you may need to contact a professional technician to replace the heating element.
If none of these solutions solve the problem, it may be advisable to consult the user manual or contact Beko customer support for further assistance.

To reset your Beko dishwasher, you can follow these steps:
1. Turn off the dishwasher by pressing the power button or by unplugging it from the power source.
. Wait for 1-2 minutes and then turn it back on.
3. Open the dishwasher door and locate the control panel.
4. Press and hold the "Start" or "Cancel" button for about 5 seconds.
5. Release the button once the lights on the control panel start flashing or the display shows an error message.
6. Wait for a few seconds until the lights stop flashing.
7. Close the dishwasher door and the reset process should be complete.
Note: If the above steps do not work, you can refer to the user manual of your specific Beko dishwasher model for resetting instructions, as they may vary slightly depending on the model.

Flashing lights on your Beko dishwasher can indicate various issues. Here are a few possible explanations for the flashing on light:
1. Water supply issue: If the dishwasher is not receiving enough water or if the water supply is disrupted, it might cause the on light to flash. Check the water supply valve's position, ensure it is fully open, and ensure the water inlet hose is not kinked or blocked.
2. Drainage problem: An obstructed or blocked drainage system can trigger the on light to flash. Check the drain hose for any clogs or kinks. Additionally, check if the sink's drain is clear and not causing any backups.
3. Filters and spray arms: A flashing on light could indicate a problem with the dishwasher's filters or spray arms. Ensure the filters are clean and properly installed. Also, check that the spray arms are clear of any buildup or debris.
4. Other faults: Issues with the dishwasher's electronic control board, motor, or other components can also cause the on light to flash. If none of the basic troubleshooting steps resolve the issue, it is recommended to consult the user manual or contact Beko's customer support for further assistance.

On average, a Beko dishwasher is designed to last between 10-15 years with regular use and proper maintenance. However, the lifespan of a dishwasher can vary depending on factors such as usage patterns, water quality, and maintenance.