Beats POWERBEATS2-WIRELESS user manual

To check the battery status of your Powerbeats 2 Wireless, you can follow these steps:
1. Ensure that your Powerbeats 2 is turned on and connected to your device (phone, tablet, etc.).
. Open the Bluetooth settings on your device.
3. Look for Powerbeats 2 in the list of connected devices and tap on the "i" (information) icon next to it.
4. A new page will open, showing you detailed information about your Powerbeats 2, including the battery level.
Alternatively, you can download the Beats by Dre app on your device, which will provide you with more detailed information about your Powerbeats 2, including battery status, firmware updates, and more.
Note that battery levels may also be indicated through voice prompts or LED lights on the Powerbeats 2 headphones themselves.

Here are steps to use your Powerbeats 2 Wireless:
1. Charging: Before first use, be sure to charge your Powerbeats 2 Wireless. Use the provided USB cable and plug it into a power source.
2. Pairing: The first time you turn on your Powerbeats, it will automatically go into pairing mode. Go to the Bluetooth settings on your phone or other device, locate your Powerbeats 2 on the list of available devices and select it to pair.
3. Turn on and off: To power on your Powerbeats 2, simply press and hold the power button located on the top of the left earpiece until you see the LED light at the bottom of the earpiece flash a white color. To turn them off, press and hold the same button until the LED light blinks red and then turns off.
4. Playback Controls: The controls for music playback are on the cable connecting the two earpieces. There’s a remote with three buttons: volume up, volume down and a center button. The center button plays and pauses music with one press, skips forward a track with two quick presses, and skips back a track with three quick presses.
5. Taking Calls: When a call comes in, press the center button once to answer. Press it again to end the call. If you want to reject the call, press and hold the center button for about two seconds.
6. Charging: The LED indicator will glow red when the battery is low. To charge your Powerbeats, connect them to a power source using the provided USB cable. It will turn white when fully charged.
Remember to take care of your Powerbeats 2 Wireless by storing them in a safe place when they're not in use and avoid exposing them to extreme temperatures and damp environments.
Also, make sure your device is within the Bluetooth range and there are less obstructions between the device and your Powerbeats to ensure consistent connectivity.

The Powerbeats2 Wireless headphones come with a set of buttons that can be used to control various functions. Here's a breakdown of the buttons and their functions:
1. Power Button/Calls: The power button is located on the left earbud. You can use it to turn the headphones on and off, as well as to answer or end phone calls with a single press.
2. Volume Control: The volume control buttons are also located on the left earbud. You can increase and decrease the volume by pressing the "+" and "-" buttons, respectively. Holding down the "+" button can also skip to the next track, while holding down the "-" button can go back to the previous track.
3. Play/Pause: The play/pause button is located on the left earbud, in between the volume control buttons. Pressing this button once will play or pause your audio or media.
4. Beats Button: The Beats button is found on the right earbud. Pressing it activates the Beats signature sound, enhancing the audio experience.
5. Pairing Button: The pairing button is located on the right earbud. You can use it to enter Bluetooth pairing mode or to reset the headphones.
6. Charging Port: On the bottom of the right earbud, there is a charging port where you can connect the charging cable to charge the Powerbeats2 Wireless.