Asus ZENPAD-10-Z300M user manual

To force start your Asus ZenPad 10 Z300M tablet, you can follow these steps:
1. Locate the power button on your tablet. It is usually located on the right side or top edge of the device.
. Press and hold the power button for about 10-15 seconds. Keep holding the button even if the screen turns black or off.
3. After holding the power button for the specified time, release it.
4. Wait for a few seconds and then press and hold the power button again for a few seconds until the device starts to power up.
5. Once the Asus logo appears on the screen, release the power button.
Your tablet should now start up normally. If it does not respond or start up after following these steps, you may need to perform a factory reset or contact Asus support for further assistance.

The Asus ZenPad 10 (Z300M) was released in June 2016.

If you do not have the password to access your Asus Zenpad tablet, you can still reset it using the following instructions:
1. Power off your Zenpad tablet by holding down the power button and selecting "Power off" or "Shut down".
2. Once the tablet is completely powered off, press and hold the Volume Up and Power buttons simultaneously until the Asus logo appears on the screen.
3. Release both the Volume Up and Power buttons when the logo appears, and you will enter the device's recovery mode.
4. In the recovery mode, use the volume buttons to navigate to the "Wipe data/factory reset" option. Press the Power button to select it.
5. On the next screen, again use the volume buttons to scroll and select the "Yes - delete all user data" option, and press the Power button to confirm.
6. The factory reset process will now begin, and the tablet will reboot once it is complete.
After the device restarts, it will be reset to its factory settings and you will be able to set it up again without a password. However, please note that performing a factory reset will erase all data from the tablet, so ensure you have a backup of important files.

To connect your Asus Zenpad-10-Z300M tablet to your TV, you can follow these steps:
1. Check the ports on your TV: Confirm whether your TV has an HDMI port or VGA port. HDMI is recommended for better video and audio quality.
2. Purchase the required adapter: If your TV has an HDMI port, buy an HDMI-to-HDMI cable. If your TV has a VGA port, you will need to purchase a VGA-to-VGA cable along with an audio cable (3.5mm jack).
3. Connect the cables: Using the appropriate cable (HDMI or VGA), connect one end to the corresponding port on your Asus Zenpad and the other end to the respective port on your TV.
4. Set your TV to the correct input: Use your TV remote to navigate to the input/source menu and select the input source that matches the port you connected the tablet to (HDMI 1, HDMI 2, VGA, etc.).
5. Enable display output on your Asus Zenpad:
- For HDMI connection: Initially, your tablet might automatically mirror the display on the TV, but if it doesn't, go to "Settings" on your tablet, select "Display", and then choose "Wireless & networks."
- For VGA connection: Go to "Settings" on your tablet, select "Display," and then tap on "Cast screen."
6. Your tablet's screen should now be mirrored on your TV. You can play videos, stream content, or do anything on your tablet, which will appear on the TV as well.
Note: Some apps or websites may have restrictions on screen mirroring due to copyright protection. Additionally, the steps may slightly vary depending on the specific model of your Asus Zenpad and your TV, so be sure to refer to their user manuals if needed.