Asus TUF-GAMING-VG249Q user manual

Here are some general steps to change settings on your ASUS TUF Gaming monitor. Note that the steps may vary slightly depending on the model of your monitor.
1. Ensure your monitor is powered on.
2. Located on the bottom right of your monitor, you will find several buttons. One of these is the power button and the others are for the menu, navigation and selection.
3. Press the menu button to bring up the settings menu.
4. Once the menu appears, use the navigation buttons to move through the menu and select the setting you want to change. Common settings include brightness, contrast, color settings, refresh rate, and more.
5. After selecting the setting, use the navigation buttons again to adjust the setting to your preference.
6. Once you are done adjusting, press the menu button again to exit and save the settings.
7. If you are not sure about the changes, you can also reset the monitor settings to factory default in the monitor menu.
Always remember to consult your user manual for specific instructions.

The best settings for the Asus VG249QGR can vary depending on personal preference and the content you're viewing. However, here are some general guidelines to help you optimize your display:
1. Brightness: Adjust the brightness level according to your surroundings. It's recommended to set it around 80-100 cd/m2 for normal indoor settings.
2. Contrast: Similar to brightness, adjust the contrast level based on your preference. A value of 70-80 is a good starting point.
3. Color Temperature: Set the color temperature to "Warm" or "Normal" for a more natural display. If you prefer cooler tones, you can select "Cool," but it might give a bluish tint.
4. Gamma: You can set the gamma level to 2.2, which is the standard value for most content.
5. Response Time: The Asus VG249QGR has a fast response time. Make sure to set the response time to the lowest value available (either "Standard" or "Faster") for smoother motion in games.
6. VividPixel: This setting enhances image sharpness. Adjust it based on your preference or keep it at the default value of 0.
Remember, these settings serve as a starting point, and you can further adjust them based on your personal taste. Additionally, gaming or content-specific settings may differ, so feel free to experiment to find the optimal settings for your usage.

To connect your ASUS TUF Gaming VG249Q monitor, follow these steps:
1. Turn off your computer and the monitor.
. Locate the ports on the monitor. The TUF Gaming VG249Q typically has HDMI, DisplayPort, and DVI-D ports. Identify the appropriate port you want to use for connection.
3. Depending on your computer's graphics card, choose the corresponding cable that supports your desired port (HDMI, DisplayPort, or DVI-D). Ensure you have the cable ready.
4. Connect one end of the cable to the respective port on your monitor.
5. Connect the other end of the cable to the corresponding port on your computer's graphic card.
6. Ensure the connection is secure on both ends.
7. Power on your computer and the monitor.
8. Use the monitor's control buttons to navigate the on-screen display (OSD) menu and select the appropriate input source. You can usually find these buttons on the rear or the bottom edge of the monitor.
9. With the OSD menu, select the input source that matches the port you connected (e.g., HDMI, DisplayPort, or DVI-D).
10. The monitor should now display the content from your computer.
If the monitor does not automatically display anything, check the cable connections, ensure the monitor is powered on, and ensure the correct input source is selected in the monitor's OSD menu. Additionally, make sure your computer is set to output video to the connected monitor.
Note: Make sure you have the necessary drivers installed for your graphics card to ensure optimal performance.