Allen & Heath QU-24 user manual

To reset your Allen and Heath Qu-32 digital mixer, you can follow these steps:
1. Power off the mixer by pressing and holding the power button until it shuts down completely.
. Disconnect the power cable from the rear panel of the mixer.
3. Wait for approximately 10 seconds before proceeding.
4. Reconnect the power cable to the mixer.
5. Power on the mixer by pressing the power button.
6. While the mixer is booting up, press and hold the "User" button located in the upper left corner of the touchscreen.
7. Continue holding the "User" button until the mixer has finished booting up completely.
8. Once the mixer has fully booted up, release the "User" button.
9. Your Allen and Heath Qu-32 mixer should now be reset to its factory default settings.
Please note that performing a reset will erase any previously saved settings or configurations, so it's recommended to back up any important data before proceeding.

To turn on your Qu-32 soundboard, follow these steps:
1. Locate the power switch located at the rear panel of the soundboard.
. Make sure the soundboard is plugged into a power source using the provided power cable.
3. Ensure that all connected devices, such as speakers and microphones, are turned off.
4. Flip the power switch to the "On" position.
5. The soundboard's power LED indicator should light up, indicating that it is now turned on.
Note: It is always a good practice to refer to the soundboard's user manual for specific instructions and safety precautions.

To reset an Allen & Heath mixer, you can follow these general steps:
1. Make sure the mixer is powered off.
. Locate the reset button or switch, which is typically found on the back or bottom of the mixer. It may be labeled as "Reset," "Factory Reset," or have a symbol resembling a circular arrow.
3. Use a pen, paperclip, or other small object to press and hold the reset button or switch.
4. While holding the reset button or switch, turn on the power to the mixer.
5. Continue holding the reset button or switch for a few seconds until you see the lights flash or hear a confirmation sound, indicating that the mixer has been reset.
6. Release the reset button or switch.
7. The mixer should now be reset to its factory default settings.
It's important to note that the specific steps may vary depending on the model and series of your Allen & Heath mixer. It's recommended to consult the user manual or documentation specific to your mixer model for accurate instructions.