Allen & Heath QU-16 user manual

To update the firmware on your Allen & Heath Qu-32 mixer, follow the steps below:
1. Visit the Allen & Heath website (www.allen-heath.com) and navigate to the Support section.
. In the Support section, search for the Qu-32 model and locate the Firmware updates or Downloads page.
3. Look for the latest firmware update available for your Qu-32 mixer and download it to your computer. Ensure you download the correct update file for your specific mixer model.
4. Once the firmware file is downloaded, prepare a USB flash drive formatted in FAT32 or exFAT.
5. Copy the firmware update file to the root directory of the USB flash drive (do not place it in any folders).
6. Ensure the Qu-32 mixer is turned off and connect the USB flash drive to the USB port located on the rear panel of the mixer.
7. Power on the Qu-32 mixer while holding down the "User" key in the "Setup" section of the mixer's surface.
8. The mixer will display a prompt to confirm the firmware update. Press the "Yes" button to proceed.
9. The firmware update process will commence and may take several minutes. Do NOT power off the mixer during this process.
10. Once the firmware update is complete, the mixer will restart automatically.
11. After the restart, the mixer will display the new firmware version on the home screen, confirming a successful update.
Remember to consult the specific Allen & Heath documentation and user manual for your Qu-32 mixer for any additional or updated instructions.

To turn on your Qu-32 soundboard, follow these steps:
1. Locate the power switch located at the rear panel of the soundboard.
. Make sure the soundboard is plugged into a power source using the provided power cable.
3. Ensure that all connected devices, such as speakers and microphones, are turned off.
4. Flip the power switch to the "On" position.
5. The soundboard's power LED indicator should light up, indicating that it is now turned on.
Note: It is always a good practice to refer to the soundboard's user manual for specific instructions and safety precautions.

To reset an Allen & Heath mixer, you can follow these general steps:
1. Make sure the mixer is powered off.
. Locate the reset button or switch, which is typically found on the back or bottom of the mixer. It may be labeled as "Reset," "Factory Reset," or have a symbol resembling a circular arrow.
3. Use a pen, paperclip, or other small object to press and hold the reset button or switch.
4. While holding the reset button or switch, turn on the power to the mixer.
5. Continue holding the reset button or switch for a few seconds until you see the lights flash or hear a confirmation sound, indicating that the mixer has been reset.
6. Release the reset button or switch.
7. The mixer should now be reset to its factory default settings.
It's important to note that the specific steps may vary depending on the model and series of your Allen & Heath mixer. It's recommended to consult the user manual or documentation specific to your mixer model for accurate instructions.