ActionTec V1000H user manual

To reset the Actiontec V1000H router, you can follow these steps:
1. Locate the Reset button: On the back panel of the router, look for a small hole labeled "Reset" or a button with a circular arrow symbol. The location may vary slightly depending on the specific model of the V1000H.
2. Press and hold the Reset button: Using a paperclip or a small, pointed object, press and hold the Reset button for about 10 seconds. Keep the button pressed until the router starts to reboot.
3. Release the Reset button: After holding the Reset button for the designated time, release it.
4. Wait for the router to reset: Allow a few minutes for the Actiontec V1000H router to complete the resetting process and reboot. During this time, the router's lights will flash and eventually stabilize.
5. Connect and reconfigure: Once the router has finished rebooting, you will need to reconnect your devices and reconfigure any custom settings you had previously configured. You may need to consult the user manual or contact your internet service provider for assistance with reconfiguration.
Please note that performing a reset will erase any custom configurations and

The Actiontec V1000H is a DSL modem that supports Internet speeds of up to 25 Mbps. However, the actual speed you will experience may vary depending on your DSL service provider and the quality of your DSL connection.

The WPS (Wi-Fi Protected Setup) button on the Actiontec V1000H router is used to establish a secure wireless connection between the router and a device, such as a smartphone or computer, without entering the Wi-Fi password. By pressing the WPS button on the router and then activating the WPS function on the device, they will automatically connect to each other securely. This simplifies the process of connecting devices to the Wi-Fi network.

1. Connect the device you'll use to configure the router to one of your Actiontec router's Ethernet ports.
2. Launch a web browser on the connected device and type "192.168.1.1" into the address bar, then press "Enter."
3. You'll be prompted to enter a username and password. If you haven't changed it before, the default username should be “admin” and the default password should be “password” or "admin". If you've changed your login credentials and you can't remember them, you'll need to reset the router to factory settings.
4. Click on "OK" to log into your Actiontec router menu interface.
5. Once you've logged in, you can change settings as necessary, such as wireless security, firewall settings, and more.
6. Make sure to save any changes before closing your browser.
Note: This step-wise instruction could differ as per the model version. Please refer to the respective user manual of the product for precise instructions.