Summary of the content on the page No. 1
Contents
1 INSTRUCTIONS FOR SAFE AND PROPER USE ________________________________4
2 INSTALLATION OF THE APPLIANCE__________________________________________6
3 ADAPTATION TO DIFFERENT TYPES OF GAS _________________________________9
4 FINAL OPERATIONS______________________________________________________14
5 DESCRIPTION OF FRONT PANEL CONTROLS ________________________________16
6 USE OF THE COOKING HOB _______________________________________________18
7 USE OF THE OVEN_______________
Summary of the content on the page No. 2
Introduction 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOM
Summary of the content on the page No. 3
Introduction LOWER THE GLASS COVER SLOWLY AND BY HAND. WARNING: THE GLASS COVER MAY SHATTER IF IT OVERHEATS. SWITCH OFF ALL RINGS AND WAIT FOR THEM TO COOL DOWN BEFORE CLOSING THE COVER. DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. THE APPLIANCE IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN TO GO NEAR OR PLAY WITH IT. WHEN OPERATING THE GRILL ALL ACCESSIBLE PARTS COULD BECOME VERY HOT: KEEP OUT OF THE WA
Summary of the content on the page No. 4
Instruction for the installer 2 INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Depending on the type of installation, it is in class 1 (Fig. A) or class 2 - sub-class 1 (Fig. B-C) Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990. It can be placed ag
Summary of the content on the page No. 5
Instruction for the installer 2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. If the appliance is hooked-up to the supply by means of a fixed connection, install a multipolar cut- out device on the line, with contact opening distance equal to or greater than 3 mm, located near the appliance and in an easily reachable
Summary of the content on the page No. 6
Instruction for the installer 2.3 Connecting to natural and LPG gas (Please see connection diagram) Make the connection to the appliance using flexible bayonet style hose in accordance to B.S. 669. The hose connection at the rear of the appliance has a ½” BSP internal thread. Please use seal C between the flexible connection L and the appliance supply tube B. When making the connection, make sure that no stress of any kind is applied to the cooker and that the hose does not
Summary of the content on the page No. 7
Instruction for the installer 3 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The cooker hob is set for natural gas G20 (2H) at a pressure of 20 mbar for cookers with maxi oven, and for LPG G30/G31 (3+) at a pressure of 28/37 mbar for cookers with gas-bottle compartments. In the case of functioning with other types of gas the burner nozzles must be changed and the minimum flam
Summary of the content on the page No. 8
Instruction for the installer 3.2 Burner and nozzle characteristics table (50-60 cm models) Rated heating Burner LPG – G30/G31 28/37 mbar capacity (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter mm flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1.0 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid (3) 3.0 85 45 800 218 214 Rapid (5) 2.3 75 45 800 167 164 Triple crown 3.2 91 65 1500 233 229 Oven 3.2
Summary of the content on the page No. 9
Instruction for the installer 3.3 Burner and nozzle characteristics table (90 cm models) Rated Burner heating LPG – G30/G31 28/37 mbar capacity (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter mm flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid 3 85 45 800 218 214 Triple crown 3.2 91 65 1500 233 229 Fish pan 1.9 68 45 800 138 136 Oven 3.2 87 48 850 233 229 Maxi oven 5.2 110 59 1200 378 371
Summary of the content on the page No. 10
Instruction for the installer 3.4 Arrangement of burners on cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Rapid (60 X 60) 4. Triple crown 5. Rapid (60 X 50) 3.5 Arrangement of burners on cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Rapid 4. Triple crown 5. Large electric hob (1500W) 6. Small electric hob (1000W) 7. Fish pan 8. Triple crown 12
Summary of the content on the page No. 11
Instruction for the installer 3.6 Adjustment of the oven burner (only for gas oven models) To adjust the oven burners follow the procedure described below from inside the oven: • Open the oven door; • Remove the oven dish and shelf. • Lift up the oven floor and remove. 3.6.1 Replacement of the oven burner nozzle • Loosen the fixing screws A on the oven burner. • Push the burner B towards the right to get to the nozzle. • Use a 13 socket wrench to change the
Summary of the content on the page No. 12
Instruction for the installer 4 FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with the nozzles. 4.1 Regulation of the hob burner minimum level for natural gas Light the burner and turn it to the mi
Summary of the content on the page No. 13
Instruction for the installer 4.5 Mounting the rear top skirtboard (where applicable) • Loosen nuts B. • Position the skirt above the top, taking care to align pins C with holes D. • Secure the skirt to the top by tightening screws A. 4.6 Wall fixing • Stretch out the chain attached to the cooker horizontally so that the other end touches the wall. • Mark the wall in the position where the hole is to be drilled. • Drill the hole, insert the finned dowels
Summary of the content on the page No. 14
Instruction for the user 5 DESCRIPTION OF FRONT PANEL CONTROLS All the oven controls are grouped together on the front panel. The table below provides a description of the symbols used. FRONT RIGHT BURNER CENTRAL BURNER BACK RIGHT BURNER GAS OVEN THERMOSTAT KNOB BACK LEFT BURNER OVEN LIGHT / ROTISSERIE / GRILL SWITCH FRONT LEFT BURNER ELECTRIC OVEN FUNCTION KNOB BACK CENTRAL BURNER OVEN FUNCTION FRONT CENTRAL BURNER
Summary of the content on the page No. 15
Instruction for the user ELECTRIC OVEN THERMOSTAT KNOB (CERTAIN MODELS ONLY) Selection of cooking temperature is carried out by turning the knob clockwise to the required temperature, between 50° and 260°C. The tell-tale light comes on to indicate that the oven is warming up. When it goes out it means that the required temperature has been reached. Regular flashing means that oven temperature is being constantly maintained at the programmed level. STATIC ELECTRIC OVEN
Summary of the content on the page No. 16
Instruction for the user 6 USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. Before lighting the burners lift the glass cover; before lowering the cover, turn off all the burners and wait for them to cool down. The optional grid
Summary of the content on the page No. 17
Instruction for the user 6.3 Diameter of containers (60 cm models) BURNERS Ø min. and BURNERS Ø min. and (60 X 50) max. (in cm.) (60 X 60) max. (in cm.) 1. Auxiliary 12 – 14 1. Auxiliary 12 – 14 2. Semi-rapid 16 – 22 2. Semi-rapid 16 – 24 5. Rapid 18 – 24 3. Rapid 18 – 26 4. Triple crown 18 – 26 6.4 Diameter of containers (90 cm models) BURNERS Ø min. and max. (in cm.) 1. Auxiliary 12 – 14 2. Semi-rapi
Summary of the content on the page No. 18
Instruction for the user 6.5 Switching on the electric hob 6.5.1 Switching on the electric hobs The cookers are equipped with hobs of different diameters. These are controlled by a switch and are turned on by turning the knob to the desired position. On the front panel above each knob a small drawing shows which hob corresponds to each knob. A yellow warning light lights up when the hob is switched on. 6.5.2 How to use the electric hobs The rapid hobs offe
Summary of the content on the page No. 19
Instruction for the user 7 USE OF THE OVEN For those models with electronic programmer, before using the oven make sure that the display shows the symbol . For those models with analogue clock and timer, place on the symbol . 7.1 Warnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature (260°C for electric oven and 275°C for gas oven) for as long as it takes to burn off any production oil residues whic
Summary of the content on the page No. 20
Instruction for the user 7.4 Use of the electric grill 7.4.1 Using the grill in cookers with electric oven For short cooking procedures, such as the final crisping of meat which is already cooked, select the static grill function and turn the thermostat knob to the maximum temperature. The fan grill function (certain models only) allows actual cooking procedures to be carried out, thanks to the fan function which ensures that the heat penetrates into the food. For thi
