Smeg PTS605NU3 user manual

Summary of the content on the page No. 1

Important Safety Instruction
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS – Your safety and the safety of others are very important.
We have provided many important safety messages throughout this manual and on the appliance.
Read all instructions before using the appliance and always obey all safety messages.
RECOGNIZE SAFETY INFORMATION
This is a safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and
others.
UNDERSTAND SIGNAL WORDS
A si

Summary of the content on the page No. 2

Conversion Kit Check that the main gas supply line to the cooktop is shut off and that the power supply cord is disconnected. 1) Remove access cap “A” by using a screwdriver or a quarter, turning the access cap counter-clockwise. The gas pressure regulator has two settings which are indicated on two sides of the cap. Turn the cap and reinstall it in the regulator with "LP" visible from the outside of the regulator. The regulator must be checked at a minimum water column of 1 inch (2.5 cm) abov

Summary of the content on the page No. 3

Conversion Kit Remove all the burner components in the numerical order shown below: � Remove the pan stands (Fig.1) by lifting them from the back (1) and extracting them (2). (On 70 cm cooktops remove the central pan stand first; on 60 cm cooktops the right-hand pan stand must be removed first); � remove all the knobs (3, Fig. 2) by pulling them outward; � lift all the burner components off the cooktop (4-5, Pic. 2); � use the wrench 6 (Fig. 3) to open the bayonet fastenings of the burner fi

Summary of the content on the page No. 4

Conversion Kit To adjust the cooktop for LP gas or to return to Natural Gas use, refer to the tables below. 4) PTS605U - Natural gas PTS605U - LP Qt Injector Qr Qt Injector Qr by-pass BTU Ø mm BTU BTU Ø mm BTU mm Left Central 14000 1.60 4400 Left Central 14000 1.10 4400 0.65 Central Central 3400 0.80 1500 3400 0.54 1500 0.33 Front Front Central Central 6000 1.05 1800 6000 0.73 1800 0.37 Rear Rear Right Right 9000 1.26 3400 9000 0.89 3400 0.50 Central Central PTS727U - Natural gas PTS

Summary of the content on the page No. 5

Conversion Kit Remove the screw A and push the support B fully down. Remove the nozzle C with a wrench and insert the suitable nozzle following the instructions in the tables referring to the type of gas to be used. The nozzle must not be tightened with a torque of more than 3 Nm. Return the support B to its original position, so that the nozzle C is perfectly covered. Regulate the air flow by moving the Venturi pipe D until the distance “X” stated in point "5.5 Adjusting the primary air flow” i

Summary of the content on the page No. 6

Conversion Kit Leak testing of the appliance must be conducted according to the following instructions: Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connections indicate a leak. If a leak appears, shut off gas valve controls and adjust the connections. Then check the connections again. NEVER TEST FOR GAS LEAKS WITH A MATCH OR OTHER FLAMES. 8) Remove all of the detergent solution from the cooktop. Electronic Ignition System - initial lighting Cooktop burn