Summary of the content on the page No. 1
Operating and Installation
Instructions
Gas Combiset
CS 1028
®
®
en - US, CA
To prevent accidents and
appliance damage,
read these instructions
before
installation or use. M.-Nr. 07 369 720
Summary of the content on the page No. 2
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. – WHAT TO DO IF YOU SMELL GAS Do not try to light any appliance. Do not touch any electrical switch. Do not use any phone in your building. Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s
Summary of the content on the page No. 3
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Guide to the combiset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Burner ..........................................................10 Before using the combiset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
IMPORTANT SAFETY INSTRUCTIONS Children WARNING- When using your gas Children should not be left appliance follow basic unattended in an area where the precautions, including the appliance is in use. Never allow following: children to sit or stand on any part of the appliance. This gas combiset conforms to all Caution: Do not store items of interest uniform safety codes and to children in cabinets above the regulations. appliance. Children climbing on the appliance to reach these items could Re
Summary of the content on the page No. 5
IMPORTANT SAFETY INSTRUCTIONS Technical safety Install the appliance so that the power cord and gas piping do not Installation, repair and maintenance come into contact with any portion of work should be performed by a Miele the combiset which may become hot authorized service technician. Work by during use. unqualified persons could be dangerous and may void the warranty. Do not use an extension cord to connect this appliance to electricity. Before installing the combiset, Extension cor
Summary of the content on the page No. 6
IMPORTANT SAFETY INSTRUCTIONS Before servicing, turn off the gas Safety valve and disconnect the power supply The appliance is hot during use and by either removing the fuse, unplugging remains so for some time after being the unit or manually “tripping” the switched off. Be careful not to touch the circuit breaker. appliance if it may still be hot. This equipment has not been Protect your hands with oven mitts designed for maritime use or for use in or potholders when using the mobile i
Summary of the content on the page No. 7
IMPORTANT SAFETY INSTRUCTIONS Do not use pans that extend past Always position pan handles and the burner grate. Using larger pans utensils inward so they do not extend may cause the flames to spread out over adjacent work areas, burner or the and damage the surrounding edge of the combiset. countertop or other countertop Do not store items on the appliance appliances. when not in use. Items could melt or For safety and stability, do not use catch fire from residual heat or if the pans w
Summary of the content on the page No. 8
IMPORTANT SAFETY INSTRUCTIONS Make certain that the power cords of small appliances do not come in contact with the appliance. The insulation of the cable could become damaged. Danger of electric shock! In the event of damage or defect, turn off the appliance immediately. Turn off the gas shut off valve and disconnect completely from the electrical supply. Contact the Miele Technical Service Department. Do not use the appliance until it has been repaired. Ensure power is not supplied to the
Summary of the content on the page No. 9
Guide to the combiset Burner grate Burner Control knob 9
Summary of the content on the page No. 10
Guide to the combiset Burner Burner cap Burner head Cover plate Ignitor Ignition safety control (Thermocouple) Burner base 10
Summary of the content on the page No. 11
Before using the combiset Cleaning the combiset Metal components have a protective coating which may give off a slight odor Before using for the first time clean the the first time your new appliance is appliance as follows: heated. Remove any protective foil. The harmless odor will dissipate after a Wash the removable parts of the gas short time and does not indicate a burner in a mild solution of warm faulty connection or appliance defect. water and liquid dish soap. Dry and reassemble t
Summary of the content on the page No. 12
Operation Turning on and off / Regulating Turning on The control knob is used to turn on the burner and to regulate the strength of the flame. The gas supply is turned off Ignition setting Highest flame Lowest flame To turn on the burner, press the control knob down and turn it The knob must only be turned left to counterclockwise to the ignition turn the appliance on and right to position to turn on. turn it off. When the flame ignites, keep the control pressed in for 8-10 seconds
Summary of the content on the page No. 13
Operation Adjusting the flame Using the cooktop during a power failure The burner can be variably adjusted between the lowest and highest flame If there is an interruption to the by turning the control knob. electrical supply, the gas can be ignited using a match. Press the control knob down and turn it counterclockwise to the ignition position. While holding down the knob, light Since the outer portion of the flame is the gas at the burner with a match. much hotter than the center, the flam
Summary of the content on the page No. 14
Pans Pan size Suitable pans – Set the combiset to a high flame Unlike pans used on an electric when using a large diameter pan and combiset, the bases do not need to be low flame when using a small even for good results. diameter pan. Thick pan bases will give more even results, as hot spots are reduced due to better heat distribution. Thin pan bases will conduct the heat faster but not as evenly as thick pan bases. Stir the food frequently to – Generally, wide / shallow pans will prevent burnin
Summary of the content on the page No. 15
Safety features Ignition Safety Control This gas combiset incorporates an Ignition Safety Control which stops the supply of gas if the flame goes out. To reignite the burner, turn the control knob clockwise to “”, then turn on the burner as usual. This safety feature is not operated by electricity, it will be active even if the appliance is in use during a power failure. 15
Summary of the content on the page No. 16
Cleaning and care Combiset Never use a steam cleaner to clean Let the appliance cool to a safe this combiset. Pressurized steam temperature before removing the could cause permanent damage to grates. the surface and to components for which the manufacturer cannot Clean the grates, combiset and accept responsibility. knobs with a sponge and a mild solution of warm water and liquid Do not use any sharp or pointed dish soap. Do not wash parts in the objects which could damage the dishwasher. seal
Summary of the content on the page No. 17
Cleaning and care Burner Reassembling the burner Do not clean any parts of the burner in a dishwasher. The burner can be dismantled and cleaned when cool. Remove the burner parts and wash them in a solution of warm water and liquid dish soap. Dry them thoroughly. Make sure that the flame holes are clean and completely dry. Wipe the burner base clean with a damp cloth and then dry. Gently wipe the ignitor and ignition safety control with a slightly damp cloth, and then wipe dry. Do not let th
Summary of the content on the page No. 18
Frequently asked questions Repairs should only be carries out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. The burner does not ignite after several attempts. Possible fault Solution The burner is not assembled correctly. See "Cleaning and Care - Reassembling the burner". The gas supply is not turned on. Turn on the gas supply. T
Summary of the content on the page No. 19
Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. Adhere rating label sticker supplied with the appliance below. 19
Summary of the content on the page No. 20
Technical Service MieleCare (USA only) MieleCare, our Extended Service Contract program; gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory trained professionals can guarantee the safety, reliability and longevity of your Miele appliance.
