Summary of the content on the page No. 1
INSTALLATION & OPERATING
INSTRUCTIONS
GarnetE SERIES
ELECTRIC STOVE
SAVE THESE INSTRUCTIONS
Note: Read these instructions completely
before beginning installation. Failure to follow
them could cause heater malfunction resulting
in serious injury and/or property damage.
CAUTION:
Do not expose this heater to the elements
(such as rain, etc.).
WARNING! WARNING!
All electric heaters have hot and arcing or sparking parts This heater is tested and listed for use only with the
inside. Do not use it in
Summary of the content on the page No. 2
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 TABLE OF CONTENTS A. Listing Approvals ........................................................................................................................................................... 3 B. Heater Dimensions ...................................................................................................................................................... 3 C. Location and Clearances .............................
Summary of the content on the page No. 3
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 A. LISTING APPROVALS U.S. And Canada Certification The GarnetE Series heater has been tested in accordance with the UL2021 Standards for fixed and location-dedicated electric room heaters in the United States, the current CSA C22.2 NO. 46 in Canada and has been listed by Underwriters Laboratories Inc. for installation as described in this manual. All components are UL or CSA safety certified. If you need assistance during
Summary of the content on the page No. 4
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 C. LOCATION AND CLEARANCES WARNING! WARNING! Due to high temperatures, this heater should be located Never locate this heater where it may fall into a bathtub or out of high traffic areas. Keep combustible materials such other water container. as furniture, pillows, bedding, papers, clothes and curtains at least 3 ft (.9M) from the front of the heater. CAUTION: Do not expose heater to the elements (such as rain, etc.). Not
Summary of the content on the page No. 5
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 D. WIRING WARNING! Always use properly grounded, fused and polarized outlets. Always use ground fault protection where required by electrical code. Figure 2 - Wiring Diagram E. FINAL INSTALLATION 1. Remove Top a. Grasp both sides of the top and lift straight up. b. Place the top in a safe location so it does not get scratched or chipped. 2. Remove Front a. Grasp the middle of the front and lift straight up. b. Place the
Summary of the content on the page No. 6
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 4. White Rock Installation a. Remove the bag of rock from the stove. b. Open the bag and place the rock over the glass to create an ember bed. You need not use the entire bag. See Figure 4. 5. Replace the Components Reverse the procedures in Steps 1-3 of this section. Figure 4 - Place White Rock 5/04 6 4035-161 Rev A GarnetE SERIES ELECTRIC FIREPLACE
Summary of the content on the page No. 7
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 F. OPERATING INSTRUCTIONS The operating controls are located on the back of the heater. 1. Main Power Switch a. When the main power switch is turned on, it provides power to all functions. b. When used in conjunction with RC-ELEC-QUAD remote control the switch should remain in the “ON” position. 2. Intensity Switch Controls the intensity of the ember bed and flame. 3. Heater Switch a. The heater switch provides power to th
Summary of the content on the page No. 8
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 2. Cleaning the Back Glass The glass is cleaned in the factory during the assembly process. During shipment, installation, handling, etc., the glass surface may collect dust particles. These can be removed by buffing lightly with a clean dry cloth. To remove fingerprints or other marks, the glass can be cleaned with a damp cloth using a good quality household glass cleaner. The glass should be completely dried with a lint
Summary of the content on the page No. 9
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 H. TROUBLESHOOTING Issues Possible Causes Solutions Heater doesn't turn on with the main 1. Power switch is "OFF." 1. Turn the power switch to the "ON" position. switch or remote transmitter. 2. Circuit breaker is tripped. 2. May need to put the heater on a dedicated service or reduce the number of appliances on the circuit. 3. Heater is unplugged from wall outlet. 3. Plug the cord into an outlet. 4. Loose wiring. 4. Chec
Summary of the content on the page No. 10
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 I. REPLACEMENT PARTS Replacement parts are available from your distributor/dealer. Log Set 5/04 10 4035-161 Rev A GarnetE SERIES ELECTRIC FIREPLACE
Summary of the content on the page No. 11
Hearth & Home Technologies Inc. 1445 North Hwy., Colville, WA 99114-2008 # Description of Part GARNETE Qty. R 1 Top Casting ** Specify Color 1 ** 2 Side Casting ** Specify Color 2 ** 3 Front Casting ** Specify Color 1 ** 4 Front Screen Assembly 4035-151 1 Y 5 Heater Assembly 4035-155 1 Y 6 Socket Assembly 4035-152 1 Y 7 Air Deflector 4035-305 1 Y 8 Air Channel 4035-321 2 Y 9 Flame Panel 4035-308 1 Y 10 Lens 4035-804 1 Y 11 Back Glass 4035-801 1 Y 12 Retainer 4035-311 2 Y 13 Halogen Bulb 33961 1
Summary of the content on the page No. 12
INDEX A F L S Arrow 2 Fan 9 Listing Approvals 3 Safety 1, 2, 4, 5, 7, 8 Final Installation 5 Loose Wiring 9 Space Requirements 4 B Fire 1 Stove Openings 2 Back Glass 8 M Firebox 7 Switch Bathrooms 2, 4 Main Power Switch 7 Flame Intensity 9 Heater 7, 9 Bulbs 8, 9 Main Switch 9 Flammables 1, 2 Intensity 7 Maintenance 2 C Main 9 G Maintenance Instructions 7 Certification 3 Main Power 7 Grilles 2 Motor 9 Circuit Breaker 9 Ground Fault Protection 2 T N Cleaning 2, 7, 8 Th
