Summary of the content on the page No. 1
Installation Instructions
Slide In Gas Cooktop
5995447108
E36GC76EPS E48GC76EPS
Summary of the content on the page No. 2
Safety 2 IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING WARNING WARNING WARNING WARNING WARNIN
Summary of the content on the page No. 3
Safety 3 SAFETY PRECAUTIONS WARNING WARNING WARNING WARNING WARNING • Read all instructions before using the appliance. • Improper installation, adjustment, alteration, service, or maintenance can cause personal injury or property damage. Refer to these instructions and the accompanying Use & Care Manual. For assistance or additional information, consult a qualified installer, service agency, manufacturer (dealer), or the gas supplier. • For your safety: - Do not obstruct the flow of combustion
Summary of the content on the page No. 4
Safety 4 WARNING WARNING WARNING WARNING WARNING • Based on safety considerations, the top burner flame should be adjusted so it does not extend beyond the edge of the cooking utensil. • If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or death. • What to do if you smell gas: - Do not try to light any appliance. - Do not touch any electrical switch, do not use any phone in your building. - Immediately call the gas
Summary of the content on the page No. 5
Finding Information 5 READ AND SAVE THESE INSTRUCTIONS Attach your sales NO NO NO NO NOTE TE TE TE TE receipt to this page for future Installer: Leave instructions with owner. reference. Owner: Read your cooktop Use & Care Manual. It contains important safety information for operating this appliance. It also has many suggestions for getting the best results from your cooktop. Read all instructions before installing the cooktop. For your safety, please read and observe all safety instructions. Th
Summary of the content on the page No. 6
Finding Information 6 TABLE OF CONTENTS Safety ..................................................................... 2 Definitions ........................................................... 2 Important Safety Instructions ............................... 2 Safety Precautions .............................................. 3 Finding Information ............................................ 5 Please Read And Save This Guide .................... 5 Questions? ..........................................
Summary of the content on the page No. 7
Preparing for Installation 7 VERIFY PACKAGE CONTENTS • Literature Pack Griddle Bolts/Washers Simmer Plate Burner Grate Pack Wok Stand Burner Set Stainless Steel Cleaner Gas Pressure Regulator LP Conversion Kit Burner Cap Pack CABINET/COUNTERTOP PREPARATION The installation of this built-in appliance must be completed by a qualified appliance technician or contractor. Proper installation is the owner’s responsibility. Carefully check the location where the cooktop i
Summary of the content on the page No. 8
Preparing for Installation 8 IMPOR IMPOR IMPOR IMPOR IMPORTTTTTANT ANT ANT ANT ANT • When installing the cooktop into a laminated (Formica, etc.) or synthetic (Corian, etc.) countertop, radius the corners of the cutout to prevent cracking of the countertop. • Follow the countertop manufacturer’s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc. • If cabinet storage space is to be provided directly above the cooktop, the risk of personal
Summary of the content on the page No. 9
Summary of the content on the page No. 10
Summary of the content on the page No. 11
Making the Gas/Electric Connection 11 REQUIREMENTS WARNING WARNING WARNING WARNING WARNING • If the gas or electric service provided does not meet the product specifications, do not proceed with the installation. Call the selling dealer, the gas supplier, or a licensed electrical or plumbing contractor. • The grounding plug must not, under any circumstances, be cut or removed. • This appliance must be installed by a licensed plumber or gas fitter when installed within the Commonwealth of Massach
Summary of the content on the page No. 12
Making the Gas/Electric Connection 12 LIQUIFIED PETROLEUM (PROPANE) GAS CONVERSION This appliance can be used with Natural Gas and Propane Gas. It is shipped from the factory for use with natural gas. A kit for converting to LP gas is supplied with your cooktop. The kit is marked “FOR LP/PROPANE GAS CONVERSION”. Follow the installation instructions which are inside the envelope. The conversion must be performed by a qualified service technician in accordance with the kit instructions and all loc
Summary of the content on the page No. 13
Making the Gas/Electric Connection 13 Electrical Supply Requirements The correct voltage, frequency and amperage must be supplied to the appliance from an isolated, grounded circuit which is protected by a properly sized circuit breaker or time-delay fuse. The cooktop must be connected to the power supply with copper wire only. The use of aluminum wire may result in unsatisfactory connections. Flexible armored or nonmetallic, sheathed copper cable (with a grounding wire) should be used to supply
Summary of the content on the page No. 14
Installation 14 INSTALLING THE COOKTOP Place and center the cooktop within the cutout. Secure the cooktop to the countertop utilizing the two (2) 1/4-20 bolts provided. Do not overtighten the screws. IMPOR IMPOR IMPOR IMPOR IMPORTTTTTANT ANT ANT ANT ANT Do not use a hardening compound or caulking to permanently seal the cooktop into place, as the unit must be readily removable for service. If such a hardening compound is used, removal of the unit will be at the customer’s expense. CONNECTING THE
Summary of the content on the page No. 15
Installation 15 GAS AND ELECTRIC REQUIREMENTS TABLE The required voltage, frequency and amperage ratings are listed on the product data plate outside on the cooktop bottom. The gas and electric requirements are also shown in the table below. Model No. Electrical Total Gas type Manifold Minimum gas circuit connected pressure supply required load pressure Natural 4” Water Column 5” Water Column E36GC76EPS Liquid Propane 10” Water Column 11” Water Column 120VAC, 0.7 Amps 60Hz, 15A (0.084 Kw) Natura
Summary of the content on the page No. 16
Summary of the content on the page No. 17
Installation 17 MAKING THE ELECTRICAL CONNECTION WARNING WARNING WARNING WARNING WARNING • Ensure that the power supply is disconnected before proceeding. • Verify that the power supply matches the ratings found on the appliance data plate before proceeding. • The complete appliance must be properly grounded at all times when electrical power is applied. • Do not ground the appliance with the neutral (white) house supply wire. A separate ground wire must be utilized. • If aluminum house supply w
Summary of the content on the page No. 18
Operation 18 VERIFYING THE OPERATION WARNING WARNING WARNING WARNING WARNING • If the cooktop fails to operate properly, ensure that the electrical power supply and gas supply are turned on and that all installation steps have been carefully followed. Call a qualified service technician if the cooktop still does not operate properly. • The cooktop and shut-off valve must be disconnected from the gas supply piping during any pressure testing exceeding 1/2 pound per square inch (3.5 kPA). • The co
Summary of the content on the page No. 19
Operation 19 Turn on the main gas supply to the cooktop by opening the gas shut-off valve. Test each burner separately by pressing and turning one control knob at a time counterclockwise to the “LITE/HI” position. All ignitors will spark simultaneously. (It will take approximately four seconds for ignition to occur, at which time all igniters will stop sparking. If ignition does not occur within four seconds, turn off the knob, wait for at least five (5) minutes to allow any gas to dissipate, th
Summary of the content on the page No. 20
www.electroluxusa.com 1-877-4Electrolux www.electroluxca.com
