Summary of the content on the page No. 1
MODEL CGESBM ELECTRIC STOVE
WITH MANUAL CONTROL
SAFETY INFORMATION AND OPERATION MANUAL
Read these instructions completely before operating
electric stove. Failure to follow them could cause a
heater malfunction resulting in serious injury and/or
property damage.
Save this manual for future reference.
For more information, visit www.desatech.com
Summary of the content on the page No. 2
TABLE OF CONTENTS Safety Information ............................................... 2 Cleaning and Maintenance .................................. 4 Listing Approvals ................................................. 3 Technical Service ................................................ 7 Unpacking and Testing the Unit ........................... 3 Replacement Parts .............................................. 7 Product Dimensions & Specifications .................. 3 Troubleshooting ............
Summary of the content on the page No. 3
SAFETY INFORMATION PRODUCT DIMENSIONS & Continued SPECIFICATIONS 12. Always disconnect the unit from the power supply before performing any cleaning, light 12.5" bulb replacement, maintenance, relocating the 19.5" heater or when the unit is not in use for long periods of time. 13. When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage the unit. 19.625" LISTING APPROVALS This heater has been tested in accor
Summary of the content on the page No. 4
To decrease the desired temperature, turn the GROUNDING temperature dial counter clockwise towards INSTRUCTIONS number 1. The heater has a built-in thermo- This stove is for use on 120 volts. The cord has a stat so it will shut off automatically once the plug as shown in Figure 2. An adapter is available set temperature is reached. It will also turn on for connecting three-blade grounding-type plugs automatically if the room temperature drops to two-slot receptacles. The green groundin
Summary of the content on the page No. 5
CLEANING AND Replacing Top Contrasting Bulb MAINTENANCE 1. The top contrasting light is mounted on the underside of the top “shelf”. Continued 2. Carefully remove spring clip. Hold socket and There are a total of 7 halogen light bulbs (type pull out the old bulb. GX6.35 rated 120 volts, 35 watts) in your unit. 3. Hold socket and push in new bulb (DO NOT • 2 bulbs provide illumination for the ember bed exceed wattage). Replace spring clip. beneath the log set • 2 bulbs provide illumination
Summary of the content on the page No. 6
CLEANING AND Flame Cylinder Drum (Half) MAINTENANCE Bulbs with Continued Spring Clips Replacing Flame Generation Bulbs 1. Remove the 6 screws from back of stove shown in Figure 7. Remove back plate. 2. Locate the flame generation cylindrical drum. It is constructed of two removable halves; ei- ther of which can be removed from the unit. Back of Unit 3. Squeeze half of drum cylinder until it's top edge clears the top drum track. Remove bot- Figure 8 - Flame Generation Cylinder tom edge of
Summary of the content on the page No. 7
When calling DESA Heating Products, have ready TECHNICAL SERVICE • your name You may have further questions about your elec- tric stove. If so, contact DESA Heating Productsʼ • your address Technical Service Department at 1-866-672-6040. • model and serial numbers of your heater When calling please have your model and serial • how heater was malfunctioning numbers of your heater ready. • purchase date You can also visit DESA Heating Productsʼ techni- Usually, we will ask you to return the par
Summary of the content on the page No. 8
WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty. We make no other warranty, expressed or implied. LIMITED WARRANTY ELECTRIC STOVE DESA Heating Products warrants this product to be free from defects in materials and components for one (1) year from the date
