Summary of the content on the page No. 1
30DSERIES
E32D5
(Digital Operation)
Installation and Operation Manual
234782-1
Summary of the content on the page No. 2
MANUFACTURED BY Moffat Limited Christchurch New Zealand INTERNATIONAL CONTACTS AUSTRALIA Moffat Pty Limited E.Mail: vsales@moffat.com.au Main Office: (tel) (03) 9518 3888 (fax) (03 9518 3833 Service: (tel): 1800 622 216 Spares: (tel): 1800 337 963 Customer Service: (tel): 1800 335 315 (fax): 1800 350 281 CANADA Serve Canada Web: www.servecanada.com E.Mail: info@servecanada.com Sales: (tel): 800 551 8795 (Toll Free) Service: (tel): 800 263 1455 (
Summary of the content on the page No. 3
Contents List E32 Turbofan Convection Oven. Model Numbers Covered in this Manual E32D5 - Turbofan Oven - 5 Tray Convection Oven. Introduction........................................................................................................... 2 Safety Information Specifications......................................................................................................... 3 Installation..........................................................................
Summary of the content on the page No. 4
Introduction Before using your new oven, please read this instruction This manual must be kept by the owner for future manual carefully, pay particular attention to any information reference. labelled ‘WARNING’, ‘CAUTION’, ‘IMPORTANT’ or A record of the Date of Purchase, Date of Installation ‘NOTE’ in this manual. and Serial Number of the oven should be recorded in the area provided below. Indicates a hazardous situation The serial number of this oven can be found on the War ning
Summary of the content on the page No. 5
Specifications E32D5 208V, 50/60Hz, 5.8 kW Oven Power Ratings 220 - 240V, 50/60Hz, 6.5 kW Tray Capacity 5 x US Full Pan Oven Tray Details 1 Tray Spacing 85 mm / 3 / ” 3 Max Water Pressure 80 psi / 550 kPa. Water Connection 3 Connection Size / ” BSP 4 3
Summary of the content on the page No. 6
Installation Installation Requirements Important: • Installation shall comply with local electrical, health and safety requirements. • It is most important that this oven is installed correctly and that oven operation is correct before use. • If you have any questions regarding the proper installation and / or operation of this oven, please contact your local Turbofan distributor. Electrical Power Oven Rating Serial Number Oven Current Draw Model Number MOFFAT LIMITED MODEL E22
Summary of the content on the page No. 7
Installation Electrical Connection Commissioning Warning Before leaving the new installation; Check the oven functions in accordance with the This oven must be earthed / grounded. operating instructions specified in the ‘Operation’ section of this manual. Each oven should be connected to an adequately protected Ensure that the operator has been instructed in the areas power supply with an appropriate three wire power cord. of correct operation and shutdown procedure for the
Summary of the content on the page No. 8
Installation Reversing the Oven Door 11. Remove the inner glass latching studs and fit to NOTE: This operation should only be carried out by a opposite side of door using suitably competent person. Loctite 243 to secure. 12. Turn the door handle over Remove Latching Studs Remove the Oven Door Inner Glass. and fit to the other end of the door where the hinges 1. Open the oven door and were removed from. Ensure Remove Screw and open the door inner glass. Retaining Clip.
Summary of the content on the page No. 9
Installation 16. Remove the Blanking Screw and Door Catch from the front of the oven and swap around. Door Catch Blanking Screw 17. Fit the door spacers removed at Item 13 opposite to the lower hinge pivot bolt. Oven Door Re-Fitting Fit the Door. 1. Refit the oven door by Top Door Pivot Bolt. locating the bottom of the door onto the bottom hinge plate pivot bolt and spacers. 2. Fit the top of the door into the top hinge plate and secure with the top pivot bolt. Fit Inner
Summary of the content on the page No. 10
Operation Operation Guide Warning Warning Take care when opening the oven door Some parts of this oven will become VERY during baking. Let hot air and steam escape HOT during use and could cause burns if before removing or replacing food as the touched. steam produced can cause steam burns. • Turbofan Ovens have been designed to provide simple operation. • This oven is intended for use in a commercial kitchen and must only be put to the use for which it was intended, i.e. cooking
Summary of the content on the page No. 11
Operation Using the Oven - Manual Mode To check actual oven temperature during preheat or cooking, press 1. TURN ‘ON’. ‘Temperature’ button. Actual temperature will display briefly on Press ‘On-Off’ button. ‘Temperature Display’ before the display reverts to the pre-set temperature. Temperature Dislay. Temperature Display will show actual temperature. Heating ‘On’ Indicator 2. SET TEMPERATURE. + to increase the temperature. - to decrease the temperature. A
Summary of the content on the page No. 12
Operation Cooking in Program Mode 1. TURN ‘ON’. Press ‘On-Off’ button. Press ‘Programs’ button. Program Mode Indicator Heating ‘On’ Temperature Dislay. Indicator Temperature Display will show program selected. To check actual oven temperature during preheat or cooking, press ‘Temperature’ button. Actual 2. SELECT A PROGRAM. temperature will display briefly on ‘Temperature Display’ before the + to scroll forward through programs. display reverts to the pre-se
Summary of the content on the page No. 13
Operation Setting the Oven Programs Oven can be pre-programmed with up to 20 Program’s. When you receive your oven, the controller is not programmed. To set programs, carry out the following for each program required:- 1. ENTER PROGRAMMING MODE. Press ‘Programs’ button to enter ‘Programming’ mode. 2. SELECT PROGRAM REQUIRED. Heating ‘On’ Rotate ‘Temperature Control’ to Indicator program required. Temperature Display will show program selected. Press and hold ‘Tempe
Summary of the content on the page No. 14
Operation Oven Racks The oven is supplied with four general purpose oven racks. • Self Supporting: When fitted, the oven racks are self supporting and will not drop or angle down when the racks are withdrawn during operation, when loading and unloading products onto racks or when attending to the product being cooked during it’s cook cycle. NOTE: Ensure that the racks are correctly fitted to the oven with the raised part of the rack to the rear of the oven and the hooks on the under
Summary of the content on the page No. 15
Operator Accessible Parameters Setting the Operator Accessible Parameters 1. ENTER THE OPERATOR PARAMETER MODE. Press 'Steam' and 'Start / Stop' buttons together. ‘Temperature’ Display will show ‘PAS’. The ‘Time’ Display will flash. 2. SET PASSWORD. Rotate ‘Timer Control’ to set password; (123) (Operator Password). Press ‘Light On / Off’ button to confirm password. ‘Temperature’ Display will show one of Parameter Codes. ‘Time’ Display will show value of the pa
Summary of the content on the page No. 16
Cleaning b. Lift up and unhook the rear of the rack from the Cleaning Guidelines locating peg at the rear of the oven. Caution Always turn off electrical power at the mains supply before commencing cleaning. This oven is not water proof. Do not use water jet spray to clean interior or exterior of the appliance. To achieve the best results, cleaning must be regular and R/Hand Rear thorough. If any small faults occur, have them looked at Locating Peg promptly. Don't wait until
Summary of the content on the page No. 17
Cleaning Side Racks Re-Fitting Lamp Glass Right Rack a. Remove the LH side rack as shown previously. a. Align the bottom of the rack with the 2 brackets in b. Unscrew (anti-clockwise) and remove the lamp glass the bottom RH side of the oven. from the oven. L/Hand Front RH Lower Mounting Brackets Locating Peg b. Tilt the rack upwards and hook the top rear of the rack onto the locating peg in the top rear of the oven. Unscrew Anti-Clockwise R/Hand Rear Locating Peg c. Remove seal
Summary of the content on the page No. 18
Cleaning Door Seal Door Glass Cleaning a. To remove the door seal, pull the 1 piece seal • Ensure that the oven door is cool before cleaning forward until it pulls out of the location groove the oven door glass. around the oven. Note the way the seal is fitted to the oven, with the lip facing inwards. a. Open the oven door. b. Lift up the bottom of the inner glass at the centre of the door to unlock from the inner glass retaining catches and swing the glass inwards towards the
Summary of the content on the page No. 19
Fault Finding This section provides a reference to the more common You may encounter a problem not covered in this section, problems that may occur during the operation of your please contact your service provider who will require the oven. This fault finding guide is intended to help you following information:- correct and accurately diagnose problems with your oven. • The Model and Serial Number of the oven, can be When fault finding a problem, always use a process of found on the T
Summary of the content on the page No. 20
Electrical Schematics Electrical Schematic E32D5 Turbofan Oven 18
