Summary of the content on the page No. 1
22-Inch Full-HD
LCDDisplay
- User Guide
-
Model No. : VS12400
Summary of the content on the page No. 2
Impor tant Safety Instructions .................................................................................................................................................1 Declaration of RoHS Compliance ..........................................................................................................................................2 Copyright I nf ormation ..............................................................................................................................
Summary of the content on the page No. 3
Important Safety Instructions 1. Read these instructions completely before using the equipment. 2. Keep these instructions in a safe place. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this equipment near water. Warning: do not expose this apparatus to rain or moisture. this guide for further instructions. manufacturer’s instructions. 9. Do not attempt to circumvent the safety provisions of the polarized or grounding-type plu
Summary of the content on the page No. 4
Declaration of RoHS Compliance This product has been designed and manufactured in compliance with Directive 2002/95/EC of the European Parliament and the Council on restriction of the use of certain hazardous substances Proposed Maximum Substance Actual Concentration Concentration 0.1% < 0.1% 0.1% < 0.1% 0.01% < 0.01% 6+ Hexavalent Chromium (Cr 0.1% < 0.1% 0.1% < 0.1% 0.1% < 0.1% Certain components of products as stated above are exempted under the Annex of the RoHS
Summary of the content on the page No. 5
Copyright Information omissions contained herein; nor for incidental or consequential damages resulting from furnishing notice. Product Registration For Your Records Product Name: VT2230-1NT ViewSonic LCD Display Model Number: VS12400-1P Document Number: VT2230-1NT_UG_ENG Rev. 1A 11-12-08 Serial Number: ______________________________________ ______________________________________ Purchase Date: Product disposal at end of product life properly at
Summary of the content on the page No. 6
Antenna Installation Instructions 1. Outdoor Antenna Grounding 2. Lightning This will prevent damage to the product due to lightning and power-line surges. Do not disconnect the antenna or the power cord during a heavy storm lighting may strike while you are holding the cable 3. Power Lines An outside antenna system should not be located in the vicinity of overhead power lines or other electric
Summary of the content on the page No. 7
Overview of the LCD Display Congratulation in purchasing the LCD Color Display. This product has been designed to provide you with a rich audio and video experience. This monitor enables you to watch broadcast or cable television ,channels, connect VCR, VCD or DVD player to watch your favorites movies, or connect a computer to use the display as a monitor. The LCD Display is equipped with convenient control buttons located on the front panel and a handy remote control to let you adjust the s
Summary of the content on the page No. 8
Front view Power Indicator LED 1 SOURCE Switch among the input source. 2 MENU 1 3 VOL +/- 2 Increase or decrease the volume. 4 CH / 3 Increase or decrease channel number. 4 Power indicator LED indicates if the LCD power is turned on (blue) or in stand-by state (orange). ViewSonic 6 VT2230-NT
Summary of the content on the page No. 9
Rear view 11 12 13 10 1 2 3 4 5 6 7 8 9 NO ITEM FUNCTION 1 AC-IN Connect to the AC outlet. Connect to the HDMI output of your PC or portable computer or 2 HDMI IN A/V device. PC -IN Connect to the VGA output of your PC or portable computer. 3 PC AUDIO IN Connect to the audio output of your computer. 4 5 AUDIO OUT Connect to the audio input jack of your Audio device. 6 COMPONENT IN Connect to the component output jack of your component device. 7 COMPONENT AUDIO IN AV AUDIO IN Connect to th
Summary of the content on the page No. 10
Remote Control 1 POWER Turn power ON or OFF. 2 COLOR KEYS 1 Context sensitive OSD hotkeys. 3 SOURCE HOTKEYS 2 Press the hotkeys to select the input source. Press DTV once for DTV source; press twice to enter 3 digital radio. 4 FREEZE Freeze the present image on the screen. 5 RETURN Switch to the previous viewed channel. 6 EXIT Exit OSD menus. 4 7 OSD MENU UP/FAST FORWARD 5 Move up in OSD menus/fast forward media. 6 8 OSD MENU RIGHT/SKIP FORWARD 7 Move right in OSD menus/skip to next media.
Summary of the content on the page No. 11
17 SOURCE Select the video source signal. 18 NUMBER KEYS Press the number keys to enter channel numbers. 17 19 WIDE Switch the display mode between various wide modes. 20 OSD MENU LEFT/SKIP BACKWARD Move left in OSD menus/skip to previous media 21 Enter the program guide of DTV OSD. 18 22 OSD MENU DOWN/REWIND Move down in OSD menus/rewind media. 23 CHANNEL Press the or keys to increase or decrease the channel number. 24 PICTURE MODE 19 Switch among four picture modes to change the p
Summary of the content on the page No. 12
Getting started device of your LCD Display and view your favorite programmes or movies .These sections describe the basic procedures required to set up your Display for easy and convenient viewing. Inserting the remote control batteries Insert the two AAA batteries provided into the remote control as described below: 1. Pull the latch on the battery compartment cover on the rear of the remote control and remove the cover. 2. Insert the two supplied AAA batteries .Check the + an
Summary of the content on the page No. 13
DVI Cable Connections PC Connector Supported Resolutions Standard Resolution Hor. Hor. Hor. Ver. Ver. Freq. Ver. Pixel Total Freq. Priority Total (Hz) Priority Clock (KHz) (MHz) DOS 720x400@70Hz 900 31.47 449 70.09 28.32 VESA 640x480@60Hz 800 31.46 525 59.95 25.17 VESA 640x480@75Hz 840 37.50 500 75.00 31.50 VESA 800x600@60Hz 1056 37.87 628 60.31 40.00 VESA 800x600@75Hz 1056 46.87 625 75.00 49.50 MAC 832x624@75Hz 1152 48.943 667 74.836 57.283 VESA 1024x768@60Hz 1344 48.36 806 60.00
Summary of the content on the page No. 14
Other Connections 1 2 3 4 5 HDMI 1 Connect to devices with HDMI output such as Blu-ray players, DVD players, Cable boxes, VCR / VCD play- ers, PCs, and portable PCs. Audio cable 2 Connect to devices with audio output such as DVD re- corders, VCRs, and Home theater audio equipment. Component cable 3 Connect to devices such as DVD players, Digital TV receivers, and Digital satellite receivers. A/V connector 4 Connect to devices with A/V output such as VCRs, VCD players, and DVD players. S-vide
Summary of the content on the page No. 15
Notes: Refer to these notes before connecting any audio / video equipment to this Display: • Refer to the manuals of your Display, stereo, or other equipment. • Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you have completed connecting everything. Never make or change connections when equipment still connected to a power outlet. • Connect DVD player directly to the Display. For example, do not connect DVD player to VCR and then connect
Summary of the content on the page No. 16
Basic Operation Turn the LCD Display ON 1 5 Press the POWER key to turn on or off the pow- er of the LCD Display. The indicate light is blue as power ON and orange as power OFF. Select Channel 2 3 Press decrease the channel number. Adjust Volume 2 3 Press the volume. Mute 4 5 1 Press key to disable the audio output. Switch the input source 5 5 Press or key to list input source. Press key to choose the input source, select 5 and switch the wanted input source. Press P
Summary of the content on the page No. 17
MTS 6 Press key to switch monaural and stereo modes. This function enable you to receive a second language or unrelated audio. WIDE 7 Press key repeatedly to switch the dis- play modes: 16:9, 4:3, Full, Panorama, Crop, Standard. Only DTV and PC Modes support changes to aspect ratio. SLEEP TIMER 8 Press repeatedly to set the sleep timer from 15 to 60 mins. Sound Mode 9 Press key repeatedly to select sound mode. 7 Display 10 Press key to display channel number (in 10 6 8 9 ® ViewSonic
Summary of the content on the page No. 18
Using the OSD Menu base setting. OSD menu can be viewed using both the remote control and the control buttons on the control panel. 1 Press key on the control panel or key on the remote control to view OSD menu. 2 Press key to select the function. 3 Press key to enter the sub menu. 4 Press key to select the item and press to adjust. 5 Press key on the control panel or key on the remote control to exit OSD menu. After change settings on the OSD menu, the new settings are
Summary of the content on the page No. 19
Press key on the control panel or key on the Picture Adjustment remote control to view OSD menu. 1 The Picture adjustment enable you to adjust Brightness, Contrast, Sharpness, Color, Hue, Color Temp, and Dynamic Contrast. Press key to select [Picture] mode. 2 Press Press or +/- key to select User, Standard, Vivid, Soft. 3 In preset Picture Modes, it is allowed to adjust each subpicture-item setting. Press key to select item and press key or +/- key to adjust setting. ViewSonic 17 VT
Summary of the content on the page No. 20
Press key on the control panel or key on the remote control to exit OSD menu. levels of light on your screen. It should 4 be used in conjunction with the con- trast option. - ference between the dark and light level on your screen. sharpness level on your screen. - nant color intensity on your screen. Adjust this setting until the colors on the screen look natural. balance. Adjust this setting so that col- ors on the screen are neither too green or too magenta. (No
