Summary of the content on the page No. 1
miro TD490 Manual
miro Displays GmbH · TRIFORUM · Haus A1 · Frankfurter Str. 233 · D-63263 Neu-Isenburg · Tel.0180-5 22 35 26 (0.12 Euro/Min) · Fax 06102-3667-77 · e-mail:kontakt@miro.de
Summary of the content on the page No. 2
TABLE OF CONTENTS INTRODUCTION FCC Compliance Statement..............................................................i Safety Instructions ..........................................................................iii General Information..........................................................................1 Equipment Checklist ........................................................................2 Monitor Features .............................................................................
Summary of the content on the page No. 3
FCC COMPLIANCE STATEMENT Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferen- ce in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordan- ce with the instructions, may cause harmful interference to radio commu- nications. However, there
Summary of the content on the page No. 4
SAFETY INSTRUCTIONS HANDLING Due to its fragile glass panel, this monitor must be handled with caution and not exposed to impact or shock. Never touch the display area or rub it with a hard stiff object or tool, as the panel is easily scratched. CLEANING The display area is highly prone to scratching. Do not use ketone-type cleaners (i.e. acetone), ethyl alcohol, toluene, ethyl acid or methyl chloride to clean the panel. Doing so may result in permanent damage. Water, IPA (Iso Prophyl Alcohol) a
Summary of the content on the page No. 5
SAFETY INSTRUCTIONS GENERAL INFORMATION CAUTION Your new LCD monitor incorporates the latest state-of-art color Liquid 1. Do not open any covers on the monitor. No user serviceable Crystal Display (LCD) technology providing a wider viewing angle with parts are inside. higher contrast ratio for IBM compatible PC and Apple Macintosh. 2. In an emergency, disconnect the AC power plug. Your new LCD monitor has many advantages : safe from electromagnetic 3. To avoid electrical shock, disconnect the p
Summary of the content on the page No. 6
MONITOR FEATURES EQUIPMENT CHECKLIST TM Before operating your display, please check to make sure that all of the * Supports Analog IBM compatible PC, Apple Macintosh (Adapter items listed are present in your package: optional) * Supports DPMS for monitor power management • Color TFT LCD Monitor * Supports DDC1/2B • Accessory Box: * Digital and Analog Input 1. AC to DC Adapter & Power Cord * USB 2.0 Hub - 1up 4down * Built-In Speakers, 2W x 2 * On Screen Control : Auto Image Adjust, Contras
Summary of the content on the page No. 7
INSTALLATION INSTALLATION Follow these instructions to install and remove the swivel base. Follow these steps to install the monitor 1. Before you connect the cables, make sure the monitor and system INSTALL: REMOVE: unit power switches are OFF. 2. Plug one end of the 15-pin signal cable to the rear of your system and the other end in the “Analog” video signal connector of LCD monitor. The adapter may be required for certain Apple Macintosh computers. Tighten the two screws on the cable conne
Summary of the content on the page No. 8
CONTROL BUTTONS INSTALLATION VESA WALL MOUNT Front Controls This monitor can be attached to a wall mounting arm (not included). Disconnect power before performing this procedure. Follow these steps: 1. Remove the VESA cover from the monitor. 2. Remove the stand rear cover from the base. 3. Unplug the connector. 4. Pull out the cable from the hook of base. 5. Support the base and remove the four screws. 6. Remove the base. Button Description: 1. Auto Adjust / Exit Before activating the OSD menu,
Summary of the content on the page No. 9
MENU DESCRIPTIONS ON-SCREEN DISPLAY This LCD monitor features an On-Screen Display (OSD) menu. These icons are designed to make your monitor display settings easier. When highlighted, the icons illustrate the control function to assist you in identifying which control needs adjustment. Before activating the OSD menu, the “Auto Adjust” button (1) can be used to automatically adjust the display to the horizontal and vertical position, Clock and Focus. (Press button for 2 seconds.) Note: When setti
Summary of the content on the page No. 10
MENU DESCRIPTIONS POWER MANAGEMENT The power management feature of this monitor is comprised of two LANGUAGE stages: On or Out Of Range (Green), OFF (Amber). To choose language used in the menus and control screens. Power Mode H-Sync V-Sync Video LED Color SCALING MODE Normal Pulse Pulse Active Green To adjust the input signal to the screen size by using the following options: Out Of Range Pulse Pulse Active Green - Fill All: To adjust the signal to the full screen. Off Pulse No pulse Blanked
Summary of the content on the page No. 11
TIMING GUIDE TIMING GUIDE The LCD is a multi-frequency display. On analog input it operates at Timing Table horizontal frequencies between 24KHz - 93KHz and vertical frequencies between 55Hz - 85Hz; on digital input it operates at horizontal frequencies Resolution Frequency between 24KHz - 83KHz and vertical frequencies between 55Hz - 85Hz Preset Horizontal Vertical Horizontal Vertical signal input Because of its microprocessor-based design, it offers auto- M1 640 480 31.5kHz 60Hz analog / d
Summary of the content on the page No. 12
SPECIFICATIONS PIN ASSIGNMENT Connector (15-pin) Connector (24-pin) LCD Type 19” (48.2cm) Active Matrix Panel, 0.294mm pixel pitch Color Filter R, G, B Analog Interface Digital Interface Colors up to 16.7M Glass surface Anti-glare coating Pin 1 Red Pin 1 TMDS Data 2- Viewing Pin 2 Green Pin 2 TMDS Data 2+ Angles Left / Right 170° Pin 3 Blue Pin 3 TMDS Data 2/4 Shield (CR>5) Up / Down 170° Pin 4 Ground Pin 4 TMDS Data 4- Pin 5 Ground Pin 5 TMDS Data 4+ Contrast Ratio Typ. 700 : 1 Pin 6 Red
Summary of the content on the page No. 13
TROUBLESHOOTING TROUBLESHOOTING No power. Double (split) screen image. ü Flip the power switch ON. The Power LED turns on. ü Make sure your graphics card is set to Non-Interlaced mode. ü Make sure AC power cord is securely connected to the power jack and to a power outlet. Entire screen image rolls (scrolls) vertically. ü Make sure the input signals are within the LCD monitor’s specified Power on but no screent image. frequency range. ü Make sure the video cable attached with this monitor is tig
Summary of the content on the page No. 14
For European Countries APPENDIX In Europe you must use a cord set which is appropriate for the recepta- cles in your country. The cord set is HAR-Certified, and a special mark Safety Guidelines that will appear on the outer sheath, or on the insulation of one of the inner conductors. Warning: This device must be operated with the original power supply CAUTION: The socket-outlet should be isntalles near the equipment AC PLUG CORD PRECAUTIONS FOR THE UNITED KINGDOM and should be easily accessible.
Summary of the content on the page No. 15
Compliance Information for U.S.A. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferen- ce in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordan- ce with the instructions, may cause harmful interference to radio commu- nications. However, th
Summary of the content on the page No. 16
INHALTSVERZEICHNIS EINFÜHRUNG Sicherheitsrichtlinien..........................................................................i Vorsichtsmaßregeln für den Gebrauch des Monitors ........................i Pflege des Monitors ........................................................................iii Aufstellplatz des Monitors................................................................iv Allgemeine Informationen ................................................................1 Prüfliste Zubehör
Summary of the content on the page No. 17
SICHERHEITSRICHTLINIEN VORSICHTSMAßREGELN FÜR DEN GEBRAUCH DES MONITORS Bei Ihrem Monitor handelt es sich um ein hochwertiges elektronisches Gerät. Zu Ihrer eigenen Sicherheit und um die Funktionalität des Monitors zu gewährleisten, empfehlen wir folgende Warnhinweise sorgfältig zu beachten. Behandeln Sie den Montior vorsichtig. • Reiben Sie nicht mit einem harten Gegenstand am Monitor und setzen Sie ihn keinen Schlägen aus, da er sonst beschädigt und die Anzeige zerkratzt werden kann. • Üben S
Summary of the content on the page No. 18
SICHERHEITSRICHTLINIEN SICHERHEITSRICHTLINIEN Gehen Sie sorgsam mit dem Netzkabel um. PFLEGE DES MONITORS • Speziell beim unachtsamen Gebrauch des Netzkabels besteht die • Reinigen Sie das Gehäuse des Monitors gelegentlich mit einem Gefahr eines elektrischen Stromschlages. weichen, leicht mit Wasser angefeuchteten Tuch. • Stellen Sie keine schweren Gegenstände auf das Netzkabel, • Verwenden Sie zur Reinigung der Bildfläche des Monitors auf keinen schließen Sie keine Zweigleitungen an, verknoten
Summary of the content on the page No. 19
SICHERHEITSRICHTLINIEN ALLGEMEINE INFORMATIONEN AUFSTELLPLATZ DES MONITORS Wir gratulieren zum Kauf dieses hochauflösenden LCD-Monitors. • Vermeiden Sie direktes Sonnenlicht und ultraviolette (UV-) Strahlung, die eine nachteilige Auswirkung auf Gehäuse und Teile haben. Ihr LCD-Monitor ist mit der neuesten Farb-Flüssigkeitskristallanzeige Vermeiden Sie extreme Hitze oder Kälte. (LCD-) Technologie ausgestattet. Sie bietet Ihnen bei einer Auflösung von • Setzen Sie den Monitor niemals einer Tempera
Summary of the content on the page No. 20
GERÄTEMERKMALE PRÜFLISTE ZUBEHÖR Bevor Sie Ihren Monitor in Betrieb nehmen, überprüfen Sie bitte den Inhalt QUALITATIV HOCHWERTIGE FLÜSSIGKRISTALL-ANZEIGEEINHEIT der Verpackung auf Vollständigkeit. Folgende Komponenten sollten im • Die 19-Zoll-Anzeigeeinheit (0.294mm Pixelabstand) und die Blend- Lieferumfang enthalten sein: schutz-Hartbeschichtung gewährleisten geringe Reflexionen, Antistatik, hohe Auflösung und starken Kontrast mit Echtfarb-Anzeige • TFT Farbflachbildschirm (bis zu 16.7 Mio.