Summary of the content on the page No. 1
3-254-963-21 (3)
Headrest Monitor
GB
Operating Instructions
ES
Manual de instrucciones
CT
XVM-H65
2003 Sony Corporation
Summary of the content on the page No. 2
2
Summary of the content on the page No. 3
Table of contents Welcome! .............................................................................................................................. 4 Precautions ........................................................................................................................... 5 Attaching and detaching the monitor .............................................................................. 7 Location of controls ....................................................................
Summary of the content on the page No. 4
Welcome! Thank you for purchasing the Sony Headrest Monitor. • PAL or NTSC colour system compatible • Full, Zoom, and Widezoom screen modes available, in addition to the normal screen mode. • The low reflection liquid crystal panel reduces the glare from outside lighting sources. • Adjustable brightness control, according to lighting conditions • Backlight dimmer control produces sharp contrast image, free from reversed or blurred colours. •2 Audio/Video inputs and 1 Audio/Video output are provi
Summary of the content on the page No. 5
Precautions To avoid the risk of serious injury or accident, read the following precautions before installing and operating the unit. On safety Comply with your local traffic rules and regulations. • While driving - The driver must not watch or operate the monitor. It may lead to distraction and cause an accident. - The driver must not use the headphones. It may lead to distraction and cause an accident. Park the car in a safe place when the driver watch and operate the monitor, or use headphon
Summary of the content on the page No. 6
Where to install Before installing this unit, please check your local traffic rules and regulations. Do not install this unit where: - It will obstruct the driver’s view. - It will obstruct the operation of the airbag system. - It will obstruct the operation of the vehicle, especially the steering wheel, shift lever, or brake pedal. -A driver or passengers may injure themselves when getting into or out of the car. If you have any questions or problems concerning your unit that are not covered in
Summary of the content on the page No. 7
Attaching and detaching the monitor Detaching the monitor from the case Note Be careful not to pull out the cable too much when detaching the monitor from the case. 1 Insert a plastic card between the case and the top of the monitor. The catches are released, and you can detach the monitor from the case. Catches Plastic card 2 Pull out the Monitor cable on the rear while pressing 1. 1 Monitor cable Attaching the monitor to the case Set the monitor to the case securely until you hear click sound.
Summary of the content on the page No. 8
Location of controls Monitor 1 Receptor for the card remote 3 POWER button commander/Transmitter for the 4 Monitor cable connector cordless headphones 5 POWER SELECT switch 2 IR ON/OFF button* For details, refer to page 6. Press to turn on or off the transmitter for the cordless headphones. * If interference occurs while using several cordless headphones If several monitors are installed, and used simultaneously, interference may occur. In this case, press (IR on/off) on the unit to turn off the
Summary of the content on the page No. 9
Card remote commander RM-X122 ATT POWER ATT POWER INPUT MENU INPUT MENU VOL MODE VOL MODE TOP MENU ALBUM+ LIST TOP MENU ALBUM+ LIST MENU SETUP MENU SETUP ENTER ENTER DISPLAY DISPLAY ALBUM– ALBUM– OFF OFF AUDIO SUBTITLE AUDIO SUBTITLE For the monitor operations: For DVD operations: When a Sony mobile DVD player is 1 ATT button connected to this unit, you can control Press to quickly attenuate the the basic functions with the card remote volume. commander. 2 VOL (volume) +/– buttons 8 V/v (ALBUM +
Summary of the content on the page No. 10
Operation Selecting the input source You can select the input source and colour system. ATT POWER POWER INPUT MENU VOL MODE INPUT TOP MENU ALBUM+ LIST MENU SETUP ENTER DISPLAY ALBUM– OFF POWER AUDIO SUBTITLE 1 Press (POWER). The power is turned on. Tip If your car has no ACC (accessory) position on the ignition key switch, and the POWER SELECT switch is set to the B position, the monitor does not turn on by pressing (POWER) on the card remote commander (page 6). 2 Press (INPUT) to select the des
Summary of the content on the page No. 11
Setting the screen mode In addition to the normal mode, full, zoom, and widezoom modes are also available. ATT POWER INPUT MENU VOL MODE MODE TOP MENU ALBUM+ LIST MENU SETUP ENTER DISPLAY ALBUM– OFF AUDIO SUBTITLE Press (MODE) repeatedly. The current mode is displayed on the screen first. Each time the button is pressed, the screen mode swiches in the following sequence: Normal Normal Full Full Normal (regular) Full An image with an aspect ratio An image with an aspect ratio of 4 to 3 (regular i
Summary of the content on the page No. 12
Changing the display settings You can adjust the display settings manually if the display is hard to see from the position where you are seated. ATT POWER INPUT MENU MENU VOL MODE TOP MENU ALBUM+ LIST MENU SETUP ENTER DISPLAY ALBUM– OFF AUDIO SUBTITLE 1 Press (MENU). The “Picture” screen appears. The setting value of the Picture 32 item selected appears in this area. PressVv,or MENU. Each time you press (MENU), the setting screen changes in the following sequence: B Picture B Brightness B Color
Summary of the content on the page No. 13
1 When “Color” is selected When “Hue” is selected* 2 Color 32 Hue CTR * PressVv,or MENU. PressVv,or MENU. Press v to Press V to Press v for Press V for n n decrease the increase the less colour more colour saturation saturation intensity intensity When “Dimmer” is selected When “Video Adjust” is selected Video Adjust; Dimmer; On Reset PressVv,or MENU. PressVv,or MENU. When this function is set to on, the “Picture”, “Brightness”, “Color”, brightness of the screen will be “Hue” and “D
Summary of the content on the page No. 14
Adjusting the volume You can adjust the volume of the wired headphones and the connected equipment with the supplied card remote commander. ATT POWER ATT INPUT MENU VOL VOL+/– MODE TOP MENU ALBUM+ LIST MENU SETUP ENTER DISPLAY ALBUM– OFF AUDIO SUBTITLE Press (VOL)(+) or (VOL)(–) on the card remote commander. Quickly attenuating the sound Press (ATT) on the card remote commander. ATT On To restore the previous volume level Press (ATT) again. Connecting headphones There is an output jack (mini ph
Summary of the content on the page No. 15
Connections Installation diagram Refer to the installation diagram and ask a qualified technician for the installation of the unit. Front Left Tweeter speaker Left Headrest Head unit Monitor Tweeter Right Front Right speaker Headrest Monitor Sony mobile DVD player Rear Left DVX-11A speaker Subwoofer Rear Right speaker Notes on the locations for PS one™ Be sure to securely fasten all Do not set PS one™: equipment to the car chassis, etc., to — on a dashboard, or in a place subject to prevent them
Summary of the content on the page No. 16
Connection diagram Refer to the connection diagram for the proper connections. You can make connections shown in A area. Please ask a qualified technician for the other connections. Headrest Monitor XVM-H65 (6.5-inch wide colour LCD Monitor) Connection box XA-113 (optional) Headrest Monitor XVM-H65 (optional) Monitor cable (5 m) (optional) Connection box XA-113 Audio L/R/ 7.5 V (max 2 A) DC Output (for PS one™) Video Input 1 Front: Audio L/R/ Headphone jack Video Input 2 (stereo mini) 1 DVD (MV)
Summary of the content on the page No. 17
Black GND (1 m) To a metal surface of the car chassis Black GND (1 m) Monitor cable Yellow Back-up (5 m) (5 m) To car battery (12 V) Fuse (8 A) Filter box Red ACC (5 m) To ignition switch (ACC position) Fuse (1 A) RCA pin cord Blue/White striped (optional) POWER REM (5 m) To a power amplifier Max. supply current 0.3 A 4 Pin Power connector Precautions on PS one™ • Be sure to fasten PS one™ in a safe place securely. • For your safety, do not use PS one™ while driving your car. • Make sure that th
Summary of the content on the page No. 18
Additional Information Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. 1 c 2 Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Replacing the lithiu
Summary of the content on the page No. 19
About the liquid crystal display (LCD) panel Do not press on the LCD panel on the unit as doing so can distort the picture or cause a malfunction. The picture may become unclear, or the LCD panel may be damaged. Notes on cleaning — Clean the LCD panel with a slightly damp soft cloth. — Do not use solvents such as benzine, thinner, commercially available cleaners or antistatic spray. • Do not use the unit in temperatures under 5 °C or over 45 °C. • If your car was parked in a cold or hot place, t
Summary of the content on the page No. 20
Specifications Monitor Card remote commander RM-X122 System Liquid crystal colour display Power requirements Drive system TFT-LCD active matrix CR2025 lithium battery system Operable range Picture size 6.5 inches wide screen (16:9) Approx. 2.5 m 144 × 77 mm, 163 mm Dimensions 52 × 125 × 10 mm (w/h, d) (w/h/d) Picture segment Mass Approx. 40 g 336,960 (w 1440 × h 234) dots (including batteries) Power requirements 12 V DC car battery Supplied accessories (negative ground) Connection box XA-113 (1)
