Summary of the content on the page No. 1
Sim p lif y
Q
®
QLA 4010/4010C User’s Guide
1-Gb iSCSI to PCI-X Host Bus Adapters
IS0053302-00 B Page i
Summary of the content on the page No. 2
QLA4010/4010C User’s Guide 1-Gb iSCSI to PCI-X Host Bus Adapters Q Information furnished in this manual is believed to be accurate and reliable. However, QLogic Corporation assumes no responsibility for its use, nor for any infringements of patents or other rights of third parties which may result from its use. QLogic Corporation reserves the right to change product specifications at any time without notice. Applications described in this document for any of these products are for illustrativ
Summary of the content on the page No. 3
Table of Contents Section 1 Introduction 1.1 How to Use this Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 1.2 General Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 1.3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 1.4 Technical Support. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 1.4.1 Availab
Summary of the content on the page No. 4
Table of Contents Q Page viii PRELIMINARY PC0056105-00 C
Summary of the content on the page No. 5
Section 1 Introduction 1.1 How to Use this Guide ™ ® The SANblade QLogic host bus adapters (HBAs) supported in this document are described in the following paragraphs: ® ■ QLA 4010 (single channel, full-height bracket, optical media) ® ■ QLA 4010C (single channel, full-height bracket, copper media) The QLA4010 HBA is 32/64-bit, 33/66/133-MHz PCI-X to iSCSI over Gigabit Ethernet on optical media. The QLA4010C HBA is 32/64-bit, 33/66/133-MHz PCI-X to iSCSI over Gigabit Ethernet on twisted
Summary of the content on the page No. 6
1 – Introduction Features Q 1.3 Features ■ Compliance with PCI Local Bus Specification revision 2.2 and PCI-X Specification revision 1.0a ■ Supports the IETF iSCSI standard, with soft upgrades as the standard evolves ■ 32/64-bit, 33/66/133-MHz universal PCI-X ■ 1-Gbps, full-duplex Ethernet ■ Complete TCP/IP protocol off-load ■ iSCSI initiator and target modes ■ RJ45 Gigabit Ethernet connector (QLA4010C HBA) ■ Small form factor (LC) fiber optic connector (QLA4010 HBA) 1.4 Technical Support Cust
Summary of the content on the page No. 7
1 – Introduction Technical Support Q 1.4.3 Contact Information Address: QLogic Corporation 6321 Bury Drive Eden Prairie, Minnesota 55346 USA Telephone: +1 952-932-4040 Fax: +1 952-932-4018 Email: Technical Service support@qlogic.com Technical Training tech.training@qlogic.com HBA Support Web Site: support.qlogic.com IS0053302-00 B 1-3
Summary of the content on the page No. 8
1 – Introduction Technical Support Q Notes 1-4 IS0053302-00 B
Summary of the content on the page No. 9
Section 2 QLA4010/4010C 2.1 Installation in the Computer NOTE: For a Solaris SPARC operating system, the driver must be installed before installation of the HBA. See the associated readme.txt file for detailed instructions on how to install the driver. Before you install the QLA4010/4010C HBA in your computer, you need the following: ■ A screwdriver (usually a Phillips #1) ■ An optical mutimode cable with an LC-style duplex connector for the QLA4010 HBA. ■ A Cat5e or Cat6 straight-thro
Summary of the content on the page No. 10
2 – QLA4010/4010C Installation in the Computer Q NOTE: ■ Some motherboards have two kinds of PCI bus slots: master and slave. The QLA4010/4010C HBA must be in a PCI bus master slot. (Some motherboards have PCI bus master slots that are shared with onboard devices. QLA4010/4010C HBAs do not work in shared slots.) ■ PCI connectors vary among system HBA manufacturers. The QLA4010/4010C HBA is a 64-bit PCI device that can function in a 32-bit PCI slot as long as the slot conforms to the PCI sp
Summary of the content on the page No. 11
2 – QLA4010/4010C Label Q 2.2 Specifications Tables 2-1 and 2-2 define the QLA4010/4010C HBA specifications. Table 2-1. QLA4010/4010C HBA Operating Environment Environment Minimum Maximum Operating temperature 0 °C/32 °F 55 °C/131 °F Storage temperature –20 °C/–4 °F 70 °C/158 °F Relative humidity (noncondensing) 10% 90% Storage humidity (noncondensing) 5% 95% Table 2-2. QLA4010/4010C HBA Specifications Type Specifications Universal PCI specifications PCI Local Bus Specification, revision 2.2 PC
Summary of the content on the page No. 12
2 – QLA4010/4010C Agency Certification Q 2.4 Agency Certification The following sections contain a summary of EMC/EMI test specifications performed on QLA4010/QLA4010C (IS0410401/IS0510401) to comply with radiated emission, radiated immunity and product safety standards. 2.4.1 QLA4010 2.4.2 EMI and EMC Requirements The QLA4010 conforms to the following requirements: ■ FCC Part 15, Class B ❑ Radiated Emission Class B ❑ Conducted Emission Class B ❑ ICES-003 Class B ■ 89/336/EEC EMC Directive CE
Summary of the content on the page No. 13
2 – QLA4010/4010C Agency Certification Q 2.4.3 Product Safety Requirements ■ UL, cUL ❑ UL60950 ❑ CSA C22.2 No.60950 Third Edition 2000 ❑ Class I laser product per DHHS 21CFR J ■ 73/23/EEC Low Voltage Directive ❑ TUV: ❑ EV60950-1:2001 ❑ EN60825-1:1994+A11+A2 2.4.4 QLA4010C 2.4.5 EMI and EMC Requirements The QLA4010C conforms to the following requirements: ■ FCC Part 15, Class B ❑ Radiated Emission Class B ❑ Conducted Emission Class B ❑ ICES-003 Class B ■ 89/336/EEC EMC Directive CE ❑ EN55022:1998
Summary of the content on the page No. 14
2 – QLA4010/4010C Agency Certification Q ■ VCCI, Class B ■ CNS 13438, Class B ■ AS/NZS 3548, Class B 2.4.6 Product Safety Requirements ■ UL, cUL ❑ UL60950 Third Edition 2000 ❑ CSA C22.2 No.60950 ■ 73/23/EEC Low Voltage Directive ❑ TUV: ❑ EV60950-1:2001 2-6 IS0053302-00 B
