Summary of the content on the page No. 1
PRIMERGY Econel30
System configurator and order-information guide
November 2003
Contents
Instructions
Configuration diagram
Configurator
0 System software
I Basic unit
II Processor
III Memory
IV Graphics
V Accessible drives
VI Hard disk drives
VII SCSI Controller
VIII Disk array
IX Communikation/Network
X Miscellaneous
XI Country specific power cord
Change report
PRIMERGY Server
Summary of the content on the page No. 2
System configurator and order-information guide PRIMERGY Econel30 Status 2003-10-28 Instructions This document contains basic product and configuration information that will enable you to configure your system via PC-/ System-Architect. Only these tools will ensure a fast and proper configuration of your PRIMERGY server or your complete PRIMERGY Rack system. You can configure your individual PRIMERGY server in order to adjust your specific requirements. The System configurator is div
Summary of the content on the page No. 3
Bank 1 Bank 2 System configurator and order-information guide PRIMERGY Econel30 Status 2003-10-28 Configuration diagram for "PRIMERGY Econel30" system unit SIDE VIEW FRONT VIEW System unit ( I ) Pentium 4 / Celeron Standard Power supply Processor ( II ) Memory ( III ) 5.25"x1.6" DVD Extension slots 5.25"x1.6" Graphics ( IV ) SCSI Controller ( VII ) Disk array Communication/Network ( IX ) 5.25"x1.6" Miscellaneous ( X ) 3.5"x1" Floppy disk AGP
Summary of the content on the page No. 4
System configurator and order-information guide Start "PRIMERGY Econel30" PRIMERGY Econel30 Status 2003-10-28 SW Configurator mit OEM-Software ohne OEM-Software für PRIMERGY-Server für PRIMERGY-Server Bis auf OEM-SW von Vmware und F5 ist die Verwendung von OEM-Betriebssystem- Software später nicht mehr erlaubt. For all SW products listed below please refer to the corresponding software configurator accessible via the Extranet under "PC Configurations, Configurator for PRIMERGY SW",
Summary of the content on the page No. 5
System configurator and order-information guide Start "Econel30" PRIMERGY Econel30 Status 2003-10-28 Section Basic unit I System unit consisting of: * Housing including power supply * Systemboard with - Ultra DMA-100 Controller on-board (for 2x 2 drives) - 7 slots:1x AGP, 6x PCI * 1 drive bay 3.5" (occupied by 1 floppy disk 3.5"/ 1.44MB) * 3 bays 5.25" for accessible drives (one is occupied by 1 DVD) * 4 bays for IDE/SCSI HDs (internal) * Audio on-board * AGP-graphics card ATI
Summary of the content on the page No. 6
System configurator and order-information guide A PRIMERGY Econel30 Status 2003-10-28 Section Processor II Included in the basic unit! Section Memory III There are 2 memory slots. They can be equiped with 256MB, 512MB, 1GB. Mix and match is possible. One memory slot is occupied! S26361-F2580-E256 S26361-F2580-E512 S26361-F2580-E513 Memory 256MB DDR-RAM PC2100 Memory 512MB DDR-RAM PC2100 Memory 1GB DDR-RAM PC2100 ECC unbuffered ECC unbuffered ECC unbuffered consisting of one module con
Summary of the content on the page No. 7
System configurator and order-information guide B PRIMERGY Econel30 Status 2003-10-28 Section Removable Media Drives V There is 1 drive bay 3.5" occupied by 1 floppy disk 3.5"/ 1.44MB and 3x 5.25" bays for accessible drives. S26361-F3008-E1 SCSI Basic Unit or CD-RW / DVD drive SCSI Controller are 1x 48/24/48/16 IDE needed for Backup only W2K and Linux Drives. 1.6 * 5.25", anthracite bezel max. 1x per system S26361-F2238-E3 Tape drive SLR 100 50GB, 5MB/s, U2W SCSI Connector: HD68 wi
Summary of the content on the page No. 8
System configurator and order-information guide C PRIMERGY Econel30 Status 2003-10-28 Section SCSI Controller VII There are 7 slots (max. 340 mm): 1x AGP (ocuppied by AGP graphics card), 6x PCI long A. SCSI Controller for backup drives S26361-F2644-E3 SCSI Controller UW SCSI Controllers only for backup drives with LSI Chip 53C1000R In SCSI Basic Units not necessary 1 channel LVD, for internal backup drive max. 160MB/s; with cable 64/66 PCI, min 166mm, PCI standard profile int: HD68 L
Summary of the content on the page No. 9
System configurator and order-information guide D PRIMERGY Econel30 Status 2003-10-28 Section Communication / Network IX S26361-F2643-E1 Fast Ether. Contr. 10/100TX Intel Pro 100 Server Adapter AFT under NT, W2k also with on-board LAN, WOL, load bal. 32/33 Bit PCI, min 120 mm ext: for RJ45-connector SW: VLAN, Fast Etherchannel max. 1x per system freigegeben. 2x S26361-F2730-E1 S26361-F2732-E1 S26361-F2839-E1 Gigabit Ethernet Contr. 1000TX Gigabit Ethernet Contr. 1000SX Gigabit Ethern
Summary of the content on the page No. 10
System configurator and order-information guide E PRIMERGY Econel30 Status 2003-10-28 Section Miscellaneous X Section Country pack XI Power cord for floorstand versions for following countries: 1,8 m, grey T26139-Y1740-E10 D, A, B, F, NL, FIN, N, S, E, P, RUS, TR T26139-Y1742-E10 USA, Canada T26139-Y1743-E10 Switzerland T26139-Y1744-E10 UK, IR T26139-Y1745-E10 Italy T26139-Y1746-E10 Denmark T26139-Y3850-E10 Option "no powercord" Keyboards for following countries: S26381-K397-E110 USA
Summary of the content on the page No. 11
System configurator and order-information guide PRIMERGY Econel30 Status 2003-10-28 Change Report Date Order number Changes 2003-10-28 S26361-K831-V330 IDE Basic unit Celeron 2.0 , 256MB DDR-RAM PC2100 , 1x 40 GB IDE HD - no longer available 2003-10-28 S26361-F2572-E3 Tape drive SLR 60 - no longer available 2003-10-28 S26361-F2236-E3 Tape drive SLR 7 - no longer available 2003-10-10 S26381-K297-..... Order numbers of all keyboards from S26381-K297-E... to S26381-K397-E... changed 20
