Summary of the content on the page No. 1
User’s Manual
™
from Emerson Network Power
Embedded Computing
ATCA-9305: ATCA® Blade with Dual Cavium Processors April 2009
Summary of the content on the page No. 2
The information in this manual has been checked and is believed to be accurate and reliable. HOWEVER, NO RESPONSIBILITY IS ASSUMED BY EMERSON NETWORK POWER, EMBEDDED COMPUTING FOR ITS USE OR FOR ANY INACCURACIES. Specifications are subject to change without notice. EMERSON DOES NOT ASSUME ANY LIABILITY ARISING OUT OF USE OR OTHER APPLICATION OF ANY PRODUCT, CIRCUIT, OR PROGRAM DESCRIBED HEREIN. This document does not convey any license under Emerson patents or the rights of others. Emerson.
Summary of the content on the page No. 3
Regulatory Agency Warnings & Notices The Emerson ATCA-9305 meets the requirements set forth by the Federal Communications Commission (FCC) in Title 47 of the Code of Federal Regulations. The following information is provided as required by this agency. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference th
Summary of the content on the page No. 4
Regulatory Agency Warnings & Notices (continued) EC Declaration of Conformity According to EN 45014:1998 Manufacturer’s Name: Emerson Network Power Embedded Computing Manufacturer’s Address: 8310 Excelsior Drive Madison, Wisconsin 53717 Declares that the following product, in accordance with the requirements of 2004/108/EEC, EMC Directive and 1999/5/EC, RTTE Directive and their amending directives, Product: ATCA Blade Model Name/Number: ATCA-9305/10009986-xx has been designed and manufactured
Summary of the content on the page No. 5
Regulatory Agency Warnings & Notices (continued) iii 10009109-01 ATCA-9305 User’s Manual
Summary of the content on the page No. 6
Regulatory Agency Warnings & Notices (continued) iv ATCA-9305 User’s Manual 10009109-01
Summary of the content on the page No. 7
Contents StratixGX Interconnect . . . . . . . . . . . . . 3-10 1Overview PLD Registers . . . . . . . . . . . . . . . . . . 3-10 Components and Features . . . . . . . . . . . 1-1 Data Registers . . . . . . . . . . . . . 3-10 Functional Overview . . . . . . . . . . . . . . . . 1-3 Address Registers . . . . . . . . . . 3-12 Additional Information . . . . . . . . . . . . . . 1-4 Control Register. . . . . . . . . . . . 3-12 Product Certification . . . . . . . . . . . . . 1-4 Version Register. . . . .
Summary of the content on the page No. 8
Contents (continued) Reset Command 4 . . . . . . . . . . . . . . . 5-7 Watchdog Timer Use Field and Expiration Flags . . . . . . . . . . . . . . . . 7-12 Reset Command 5 . . . . . . . . . . . . . . . 5-7 Using the Timer Use Field and Reset Command Sticky #1 . . . . . . . . 5-7 Expiration Flags . . . . . . . . . . . . 7-13 Reset Command Sticky #2 . . . . . . . . 5-8 Watchdog Timer Event Logging . . 7-13 Boot Device Redirection . . . . . . . . . . 5-8 Monitor Support for Watchdog Miscellaneous
Summary of the content on the page No. 9
Contents (continued) Get Message Listener List . . . . . . . .7-45 cmp . . . . . . . . . . . . . . . . . . . . . . . . . . 9-12 System Firmware Progress Sensor . . . 7-45 cp . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-12 Entities and Entity Associations . . . . . . 7-46 find . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-12 Sensors and Sensor Data Records . . . . 7-48 md . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-12 FRU Inventory . . . . . . . . . . . . . . .
Summary of the content on the page No. 10
Contents (continued) iminfo . . . . . . . . . . . . . . . . . . . . . . . . .9-22 sleep. . . . . . . . . . . . . . . . . . . . . . . . . . 9-25 isdram . . . . . . . . . . . . . . . . . . . . . . . .9-22 switch_reg . . . . . . . . . . . . . . . . . . . . 9-25 loop. . . . . . . . . . . . . . . . . . . . . . . . . . .9-22 version . . . . . . . . . . . . . . . . . . . . . . . . 9-25 memmap . . . . . . . . . . . . . . . . . . . . . .9-22 vlan. . . . . . . . . . . . . . . . . . . . . . . . . . . 9-25
Summary of the content on the page No. 11
Figures Figure 1-1: General System Block Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Figure 2-1: ATCA-9305 Front Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2 Figure 2-2: Component Map, Top (Rev. 01) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 Figure 2-3: Component Map, Bottom (Rev. 01). . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 12
(blank page) x ATCA-9305 User’s Manual 10009109-01
Summary of the content on the page No. 13
Tables Table 1-1: Regulatory Agency Compliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4 Table 1-2: Technical References . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-6 Table 2-1: Circuit Board Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1 Table 2-2: Typical Power Requirements. . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 14
Tables (continued) Table 7-14: Set FRU LED State Command . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-21 Table 7-15: Get FRU LED State Command . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-22 Table 7-16: Vendor Command Summary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-24 Table 7-17: Get Status Command . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 15
Tables (continued) Table 8-3: Zone 3 Connector, J30 Pin Assignments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-3 Table 8-4: Zone 3 Connector, J31 Pin Assignments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-4 Table 8-5: Zone 3 Connector, J33 Pin Assignments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-4 Table 9-1: Debug LED Codes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 16
(blank page) xiv ATCA-9305 User’s Manual 10009109-01
Summary of the content on the page No. 17
Registers Register 3-1: Data 31:24 (0x0) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-10 Register 3-2: Data 23:16 (0x1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11 Register 3-3: Data 15:8 (0x2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11 Register 3-4: Data 7:0 (0x3). . . . . .
Summary of the content on the page No. 18
(blank page) ii ATCA-9305 User’s Manual 10009109-01
Summary of the content on the page No. 19
Section 1 Overview The ATCA-9305 is an Advanced Telecom Computing Architecture (AdvancedTCA®, ATCA®) blade based on dual Cavium OCTEON™ CN5860 processors and the Freescale™ Semicon- ductor MPC8548 management processor. This blade is targeted at security and packet-pro- cessing applications in the wireless and transport market segments. These markets include data-plane packet-processor, security co-processor, video compression, and pattern match- ing. The ATCA-9305 complies with the SCOPE recom
Summary of the content on the page No. 20
Overview: Components and Features Real-time Clock: The STMicroelectronics M41T00S RTC provides counters for seconds, minutes, hours, day, 2 date, month, years, and century. The M41T00S serial interface supports I C bus and has a super-cap backup capable of maintaining the clock for a minimum of two hours. Software: The Cavium CN5860 processor provides a GNU compiler that implements the MIPS64 Rel 2 instruction set in addition to the specialized instructions and a Linux® Board Specific Pack- a