Black Box Ethernet NIC user manual

Summary of the content on the page No. 1

USER’S GUIDE
LH1350C-xx-R3
LH1350C-ST-R3
LH1350C-SC-R3
100Base-FX, Fast Ethernet Fiber NICs
The Black Box LH1350C series of fast
Ethernet NICs (Network Interface
Cards) provide a 100Base-FX fiber port
to deliver low-cost fiber optic
connectivity to the desktop in fiber-rich
LAN environments. With driver support
for most operating systems and PCI 2.2
plug-and-play capability, these fast
Ethernet NICs can be installed in
virtually any PC on the network.
Part Number Port One - Duplex Fiber-Optic 1

Summary of the content on the page No. 2

LH1350C Serial Fast Ethernet NICs Install the LH1350C module -- continued Installation 5. Ensure that the module is firmly seated in the slot. Description 6. Use the screws from step “3” to secure the module to the workstation or The LH1350C module has a bootable ROM socket. The two LED indicators, file server housing. LINK/ACT and FDX located on the bracket, show network/board link, activities, collision, and full-duplex statuses. See Figure 1. LH1350C module configuration For motherboards wit

Summary of the content on the page No. 3

LH1350C Serial Fast Ethernet NICs Cable Specifications Technical Specifications For models LH1350C-ST-R3, LH1350C-SC-R3 Fiber cable Standards: IEEE 802.3 Bit error rate: <10-9 Expansion bus standard: PCI 2.1, 2.2 Single mode fiber (recommended): 9 µm Data rate 100Mbps fiber media Multimode fiber (recommended): 62.5/125 µm LED: LINK/ACT (on the bracket) Multimode fiber (optional): 100/140, 85/140, 50/125 µm ON = communication link; FLASHING = activity LH1350C-ST-R3, LH1350C-SC-R3 1300 nm mul

Summary of the content on the page No. 4

LH1350C Serial Fast Ethernet NICs Troubleshooting Contact Us Technical support Diagnostics LEDs and Boot ROM Technical support is available at techsupport@transition.com LEDS • US and Canada: 1-724-746-5500 (24 hours) The LINK/ACT LED lights when a fiber cable or twisted pair cable connection Email is good. It blinks to indicate activity. Ask a question anytime by sending an email: info@blackbox.com. The collision and full-duplex LED report board operating status. Address Boot ROM Black Bo

Summary of the content on the page No. 5

Compliance Information CISPR22/EN55022 Class A, CE Mark, CISPR22/EN55022 Class A + EN55024, CE Mark FCC regulations This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used