Summary of the content on the page No. 1
AT3IONT-I DELUXE
AT3IONT-I
Motherboard
Summary of the content on the page No. 2
E5958 Revised Edition July 2010 Copyright © 2010 ASUSTeK Computer Inc. All Rights Reserved. No part of this manual, including the products and software described in it, may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form or by any means, except documentation kept by the purchaser for backup purposes, without the express written permission of ASUSTeK Computer Inc. (“ASUS”). Product warranty or service will not be extended if:
Summary of the content on the page No. 3
Contents Notices .......................................................................................................... v Safety information ...................................................................................... vi About this guide ......................................................................................... vi AT3IONT-I Series specifications summary ............................................. viii Chapter 1: Product introduction 1.1 Before you proceed ........
Summary of the content on the page No. 4
Contents 2.3 Main menu .................................................................................... 2-4 2.3.1 System Time [xx:xx:xx] ................................................... 2-5 2.3.2 System Date [Day xx/xx/xxxx] ......................................... 2-5 2.3.3 SATA 1~4 ........................................................................ 2-5 2.3.4 Storage Configuration ..................................................... 2-6 2.3.5 System Information ...................
Summary of the content on the page No. 5
Notices Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide r
Summary of the content on the page No. 6
Safety information Electrical safety • To prevent electric shock hazard, disconnect the power cable from the electric outlet before relocating the system. • When adding or removing devices to or from the system, ensure that the power cables for the devices are unplugged before the signal cables are connected. If possible, disconnect all power cables from the existing system before you add a device. • Before connecting or removing signal cables from the motherboard, ensure that all power cabl
Summary of the content on the page No. 7
Conventions used in this guide To ensure that you perform certain tasks properly, take note of the following symbols used throughout this manual. DANGER/WARNING: Information to prevent injury to yourself when trying to complete a task. CAUTION: Information to prevent damage to the components when trying to complete a task. IMPORTANT: Instructions that you MUST follow to complete a task. NOTE: Tips and additional information to help you complete a task. Where to find more infor
Summary of the content on the page No. 8
AT3IONT-I Series specifications summary ® CPU Integrated Dual-Core Intel Atom™ 330 processor ® Chipset NVIDIA ION™ Front Side Bus 533 MHz Memory Dual channel memory architecture - 2 x 240-pin DIMM sockets support maximum 4GB unbuffered non-ECC 1066/800 MHz DDR3 memory modules * Refer to www.asus.com or this user manual for the Memory QVL (Qualified Vendors Lists). ** When you install a total memory of 4GB capacity or more, the operating system may only recognize less than 3GB.
Summary of the content on the page No. 9
AT3IONT-I Series specifications summary Rear panel ports 1 x PS/2 Keyboard port 1 x Optical S/PDIF out port 1 x VGA port 1 x HDMI port 1 x LAN (RJ-45) port 6 x USB 2.0/1.1 ports 3 x Audio jacks 1 x DC port* 1 x Bluetooth adapter* 1 x WLAN antenna port* 2 x RCA out ports* * For AT3IONT-I DELUXE only Internal connectors 2 x USB 2.0/1.1 connector supports additional 4 USB 2.0/1.1 ports 1 x CPU fan connector 1 x Chassis fan connector 1 x Power fan connector 4 x Serial ATA con
Summary of the content on the page No. 10
Chapter 1 Product introduction ® Thank you for buying an ASUS AT3IONT-I Series motherboard! Before you start installing the motherboard, and hardware devices on it, check the items in your motherboard package. Refer to page ix for the list of accessories. • AT3IONT-I Series motherboards include AT3IONT-I and AT3IONT-I DELUXE two models. The package contents vary from models. • If any of the items is damaged or missing, contact your retailer. 1.1 Before you proceed Take note of the following
Summary of the content on the page No. 11
1.2 Motherboard overview 1.2.1 Motherboard layout ASUS AT3IONT-I Series motherboards include AT3IONT-I and AT3IONT-I DELUXE two models The layout varies with models. The layout illustrations in this user guide are for AT3IONT-I DELUXE only. Ensure that you install the motherboard into the chassis in the correct orientation. The edge with external ports goes to the rear part of the chassis. 1 2 3 4 17.1cm(6.75in) DC_PWR/ COM1 WiFi Antenna KB_USB56 Super I/O 5 ® CPU_FAN Intel Atom 330 Place t
Summary of the content on the page No. 12
1.3 Central Processing Unit (CPU) ® The motherboard comes with an onboard Dual-Core Intel Atom™ 330 processor and a specially designed CPU heatsink. ® Intel Atom330 AT3IONT-I SERIES CPU 1.4 System memory 1.4.1 Overview The motherboard comes with two Double Data Rate 3 (DDR3) Dual Inline Memory Modules (DIMM) sockets. The figure illustrates the location of the DDR3 DIMM sockets: Channel Sockets Channel A DIMM_A1 Channel B DIMM_B1 AT3IONT-I SERIES 240-pin DDR3 DIMM sockets 1-3 Chapter 1: Product
Summary of the content on the page No. 13
1.4.2 Memory configurations You may install 512MB, 1GB, and 2GB unbuffered non-ECC DDR3 DIMMs into the DIMM sockets. • You may install varying memory sizes in Channel A and Channel B. The system maps the total size of the lower-sized channel for the dual-channel configuration. Any excess memory from the higher-sized channel is then mapped for the single-channel operation. • Always install DIMMs with the same CAS latency. For optimum compatibility, it is recommended that you obtain memory mod
Summary of the content on the page No. 14
DDR3-1333 MHz capability DIMM SS/ support Vendor Part No. Size Brand Chip No. Timing Voltage DS A* B* A-Data AD31333001GOU 1024MB SS A-Data AD30908C8D-151C E0906 - - • • A-Data AD31333002GOU 2048MB DS A-Data AD30908C8D-151C E0903 - - • • A-Data AD31333G002GMU 2048MB DS - - 8-8-8-24 1.65-1.85V • • Apacer 78.A1GC6.9L1 2048MB DS APACER AM5D5808DEWSBG - - • • CORSAIR CM3X1024-1333C9DHX 1024MB SS - - 9-9-9-24 1.60V • • CORSAIR CM3X1024-1333C9 1024MB SS - - - - • • CORSAIR TR3X3G1333C9 G 3072MB(Kit o
Summary of the content on the page No. 15
DDR3-1333 MHz capability DIMM SS/ support Vendor Part No. Size Brand Chip No. Timing Voltage DS A* B* ASINT SLY3128M8-EDJE 1024MB SS ELPIDA J1108BASE-DJ-E - - • • ASINT SLZ3128M8-EDJE 2048MB DS ELPIDA J1108BASE-DJ-E - - • • BUFFALO FSX1333D3G-K2G 1024MB SS - - 7-7-7-20 - • • BUFFALO FSX1333D3G-2G 2048MB DS - - 7-7-7-20 - • • Century PC3-10600 DDR3-1333 9-9-9 1024MB SS Micron 8FD22D9JNM - - • • Century PC3-10600 DDR3-1333 9-9-9 2048MB DS Micron 8DD22D9JNM - - • • Elixir M2Y2G64CB8HA9N-CG 2048MB
Summary of the content on the page No. 16
1.5 Expansion slot In the future, you may need to install expansion cards. The following sub-sections describe the slot and the expansion cards that it supports. Unplug the power cord before adding or removing expansion cards. Failure to do so may cause you physical injury and damage motherboard components. 1.5.1 Installing an expansion card To install an expansion card: 1. Before installing the expansion card, read the documentation that came with it and make the necessary hardware settings
Summary of the content on the page No. 17
1.6 Jumpers 1. Clear RTC RAM (3-pin CLRTC) This jumper allows you to clear the Real Time Clock (RTC) RAM in CMOS. You can clear the CMOS memory of date, time, and system setup parameters by erasing the CMOS RTC RAM data. The onboard button cell battery powers the RAM data in CMOS, which include system setup information such as system passwords. CLRTC Normal Clear RTC (Default) AT3IONT-I SERIES Clear RTC RAM To erase the RTC RAM: 1. Turn OFF the computer and unplug the power cord. 2. Move the
Summary of the content on the page No. 18
1. WLAN antenna port (for AT3IONT-I DELUXE only). This port Connects to the WLAN antenna. 2. PS/2 Keyboard port (purple). This port is for a PS/2 keyboard. 3. Video Graphics Adapter (VGA) port. This 15-pin port is for a VGA monitor or other VGA-compatible devices. 4. Onboard Bluetooth module(for AT3IONT-I DELUXE only). This onboard Bluetooth module allows wireless connection and data transfer between your system and other Bluetooth devices. ® • Under Windows 7 OS, to achieve the complete Bl
Summary of the content on the page No. 19
Refer to the audio configuration table below for the function of the audio ports in the 2, 4, 6, or 8-channel configuration. Audio 2, 4, 6, or 8-channel configuration Port Headset 2-channel 4-channel 6-channel 8-channel Light Blue (Rear panel) Line In Rear Speaker Out Rear Speaker Out Rear Speaker Out Lime (Rear panel) Line Out Front Speaker Out Front Speaker Out Front Speaker Out Pink (Rear panel) Mic In Mic In Bass/Center Bass/Center Lime (Front panel) – – – Side Speaker Out To configure an 8
Summary of the content on the page No. 20
1.7.2 Internal connectors 1. Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4) These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk drives and optical disk drives. The Serial ATA 3Gb/s is backward compatible with the Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the standard parallel ATA (133 MB/s). SATA1 SATA3 GND GND RSATA_RXN1 RSATA_TXP3 RSATA_TXN3 RSATA_RXP1 GND GND RSATA_TXN1 RSATA_RXP3 RSATA_TXP1 RS
