Antec NEW SOLUTION NSK 1380 user manual

Summary of the content on the page No. 1

New Solution Series
NSK 1380
User’s Manual
Manuel de l’utilisateur
Anwenderhandbuch
Manuale per l’operatore
Manual del usuario

Summary of the content on the page No. 2

At Antec, we continually refine and improve our products to ensure the highest quality. As such, your new case may differ slightly from the description in this manual. This isn’t a problem; it’s simply an improvement. As of the date of publication, all features, descriptions, and illustrations in this manual are correct. Disclaimer This manual is intended only as a guide for Antec’s Computer Enclosures. For more comprehensive instructions on installing the motherboard and peripherals, please

Summary of the content on the page No. 3

3. This case comes with three brass standoffs and three clip-on standoffs preinstalled for easy installation. Line up the holes on your motherboard with the standoffs, to install the motherboard slide the board towards the rear of the case until the hook on each of the clip-on standoffs “clipped” the holes on the motherboard. Note: Not all motherboards will match with all of the provided screw holes, and this is not necessary for proper functionality. 4. Remove the motherboard by liftin

Summary of the content on the page No. 4

Motherboard Pin Layout 12 Pin Signal Names Pin Signal Names 1 USB Power 1 2 USB Power 2 3 Negative Signal 1 4 Negative Signal 2 Positive Signal 1 Positive Signal 2 5 6 Ground 1 Ground 2 7 8 9 10 Key (No Connection) Empty Pin 9 10 Connecting the Audio Ports (AC’97 and HDA) There is an Intel standard 10-pin AC’97 connector and an Intel 10-pin HDA (High Definition Audio) connector. You can connect either the AC’97 or the HDA connector to your motherboard depending on the spec of the motherboard.

Summary of the content on the page No. 5

To Install the internal 3.5” drives: You can install up to three hard drives internally. We recommend installing your main drive under the 5.25” bay horizontally. 1. Insert the HDD to the drive bay under the 5.25” bay and fasten the drive with the special screws (the one with the rubber grommet.) Note: The special screws will absorb the vibration Picture 4 from the hard drive to lower the noise. There are two strips of thermal interface tape on each side of the bay to dissipate heat awa

Summary of the content on the page No. 6

Antec, Inc. 47900 Fremont Blvd. Fremont, CA 94538 USA tel: 510-770-1200 fax: 510-770-1288 Antec Europe B.V. Stuttgartstraat 12 3047 AS Rotterdam The Netherlands tel: +31 (0) 10 462-2060 fax: +31 (0) 10 437-1752 Customer Support: US & Canada 1-800-22ANTEC customersupport@antec.com Europe +31 (0) 10 462-2060 europe.techsupport@antec.com www.antec.com © Copyright 2007 Antec, Inc. All rights reserved. All trademarks are the property of their respective owners. Reproduction in whole or in part withou