Summary of the content on the page No. 1
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-R2212
CD-RW/DVD-ROM COMBINATION MOBILE DRIVE
USER MANUAL
Summary of the content on the page No. 2
CONTENTS Introduction..............................................................................1 Setup ........................................................................................3 Using the CD-RW/DVD-ROM Combo Drive............................4 Troubleshooting.......................................................................6 Specifications ..........................................................................7 Drive Connectors..................................
Summary of the content on the page No. 3
INTRODUCTION – SD-R2212 General Features CD-R disc write at 8X, 12X & 16X Lead (Pb) Free Printed Circuit Board 3-way Disc Eject (eject button, software, emergency eject hole) Average Access Time CD 90ms DVD-ROM 100ms DVD-RAM 170ms Horizontal or Vertical Mount 2MByte Buffer Playback interchangeability for CD-ROM and DVD-ROM discs Regionalization (RPC2 compliance) (DVD) BUS Interface ATAPI Types of Disc Formats Supported – Write: • Applicable Write Format CD-R, CD-RW: Di
Summary of the content on the page No. 4
Front Panel Figure 1.SD-R2212 CD-RW/DVD Combo Drive Front Panel Loading Load disc using tray. Tray Busy The LED lights green or amber when the drive is operating (LED is amber when drive is Indicator writing.) Eject The Eject button is used to open the disc tray so you can install or remove a disc. Button Emergency The emergency eject hole is to be used only when the Loading Tray will not open when Eject button is pressed. Eject Hole
Summary of the content on the page No. 5
SETUP – SD-R2212 Toshiba recommends that only trained professionals install this CD-RW/DVD-ROM Combo drive into your laptop/notebook. Installation Notes • The SD-R2212 CD-RW/DVD-ROM Combo drive has no jumpers that need to be set • Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30° (drive with volume control in up position). • When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive. • When mounting d
Summary of the content on the page No. 6
USING THE CD-RW/DVD-ROM Combo Drive – SD-R2212 Drive Operation Inserting Media To insert media perform the following steps: Figure 1.Inserting Disc 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc. 3. Gently close the disc tray. Removing Media To remove media disc from the drive, perform the following steps: 1. Open the loading tray by
Summary of the content on the page No. 7
Regional Coding Region Protection Coding (RPC) of DVD Discs: this feature is supported on DVD Players and is used with DVD-Video Discs (i.e. movies). Currently, the motion picture industry has divided the world into different regional "zones." These regions or "zones" correlate to the regional markets into which the motion picture industry releases movies. Simply put, RPC Codes are placed on Movie Discs marketed throughout the world based on the region of the world where they are being so
Summary of the content on the page No. 8
TROUBLESHOOTING – SD-R2212 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instructions to open tray. Drive is not recognized by • Is the drive connected properly? Are all cables plugged in system properly (e.g. Power Cable, Interface Cable and Audio Cables). • Is the software driver loaded? On a step-by-step (F8) Boot of the system is the CD-RW/DVD-ROM Combo drive recognized? (BIOS / DOS reports "device driver not found
Summary of the content on the page No. 9
SPECIFICATIONS –SD-R2212 General Interface: ATAPI Compatible CD-RW/DVD-ROM Standard - Write: Write Formats: Disc at once, Track at once, session at once, Packet Write CD-R, CD-RW: Write Disc: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, CD-R, CD-RW: MIXED MODE CD, CD-I, CD-I BRIDGE (Photo-CD, Video-CD), Multi- session CD (Photo-CD, CD-Extra, Portfolio) Compatible DVD-ROM Standard - Read: DVD: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (ver 1.0 & 2.0, read) DVD-
Summary of the content on the page No. 10
Performance Rotational Speed DVD (Single) 4,670rpm (3.3 - 8X) DVD (Dual) 3,792rpm (2.5 - 6X) DVD-R, DVD-RW 2,240rpm (1.7 - 4X) DVD-RAM (ver 2.1) 1,400 - 3,300rpm (1X) DVD-RAM (ver 2.1) 2,200 – 4,800rpm (2X) CD-ROM, CD-R 5,100rpm (10.3 - 24X) CD-DA Transfer 2,350 – 4,300rpm (8.6 – 12x) Video-CD, CD-DA 1,200 - 2,000rpm (4 - 6X) CD-RW (read) - normal 1,200 - 2,000rpm (4 - 6X) CD-RW (read) - high speed 2,560 - 4,000rpm (8 - 12X) CD-R (write) 3,200 - 5,000rpm (8 - 24X) CD-RW (writ
Summary of the content on the page No. 11
Environmental Ambient Temperature Operating 5° to 50° C (41° to 122° F) Storage -10° to 60° C (14° to 140° F) Shipping -40° to 65° C (-40° to 149° F) Temperature Gradient Operating 11° C /hour (max) Storage/Shipping 20° C /hour (max) Relative Humidity Operating 8% to 80% Storage/Shipping 5% to 95% (wet bulb 40° C max) Vibration 2 Operating (5 to 500 Hz) (read) 2.45 m/s (0.25G) (O-P) 2 Operating (5 to 500Hz) (write) 2.45 m/s (0.25G) (O-P) 2 Non-operating (10 to 500Hz)
Summary of the content on the page No. 12
Drive Connectors –SD-R2212 Figure 1.SD-R2212 DVD Writeable Drive Rear Panel – Connector ATAPI A 50-pin ATAPI interface connector is found at the rear of the SD-R2212 CD-RW/DVD- ROM Combo drive. Connecting cable should use Japan Aviation Electronics Industry Connector Limited KX14-50Series L or equivalent connector. Table 1.Interface Pin Assignments PIN I/O SIGNAL NAME PIN I/O SIGNAL NAME NO. NO. 1 O Audio L-CH 2 O Audio R-CH 3 Audio Ground 4 Digital Ground 5 I /RESET 6 I
