Toshiba HDD1262 user manual

Summary of the content on the page No. 1

TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA







MK1003GAL (HDD1262)
1.8-INCH HARD DISK DRIVE
USER MANUAL








Rev 02
11/2006

Summary of the content on the page No. 2

CONTENTS Introduction..............................................................................1 Setup ........................................................................................2 Using the HDD .........................................................................3 Specifications ..........................................................................4 Drive Connectors.....................................................................6

Summary of the content on the page No. 3

INTRODUCTION – MK1003GAL (HDD1262) General Features • 1.8" sized drive • 1 Platter • 10 Gigabytes* • 5mm High • 15ms Average Seek Time • ATA (2 - 5) Interface • Ultra DMA 100 • 512KB Buffer • Rotational speed of 4,200rpm • MTTF 300,000 Hours * Toshiba defines a megabyte (MB) as 1,000,000 bytes and a gigabyte (GB) as 1,000,000,000 bytes. 1

Summary of the content on the page No. 4

SETUP – MK1003GAL (HDD1262) Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can cause damage. Electronstatic discharge can also damage the drive. You should ground yourself prior to handling the drive. Figure 1. MK1003GAL Side View Installation Notes • Do not apply any force to the top cover, except the screw areas on top cover. Maximum force to the specified area is 2N. important Note: Disconnect power from your computer system

Summary of the content on the page No. 5

USING THE HARD DISK DRIVE – MK1003GAL (HDD1262) Backing up Data Files To avoid data loss, regularly back up the data files on the hard disk drive. 3

Summary of the content on the page No. 6

SPECIFICATIONS –MK1003GAL (HDD1262) General Model MK1003GAL (HDD1262) Interface ATA-2/3/4/5 Functionality Formatted Capacity 10.0GB* Rotational Speed 4200rpm Avg. Rotational Latency 7.14/ms Spin-up Time 3.6sec (typical) Buffer 512KB Seek Time Average 15 Maximum 26 Internal Transfer Rate 115.6 ~ 204.4 Mbits/sec (max) Host Transfer Rate Ultra DMA mode 100Mbytes/sec PIO Mode 16.6Mbytes/sec Interleave Factor 1:1 * Toshiba defines a megabyte (MB) as 1,000,000 bytes a

Summary of the content on the page No. 7

Physical Height 0.2" (5.0mm) Width 2.13" (54.0mm) Depth 3.09" (78.5mm) Weight 1.8oz (51g) typ Regulatory The drive satisfies the following standards: Underwriters Laboratories (UL) 1950 Canadian Standard Association (CSA) C22.2 No. 950 TUV Rheinland EN 60 950 EMC - EN50081-1 EN50081-1: 1992 EN55022: 1994 Class B EN61000-3-2: 1995 EN61000-3-3: 1995 EMC - EN50082-1 EN61000-4-2: 1995 EN61000-4-3: 1998 ENV50204: 1995 EN61000-4-4: 1995 EN61000-4-5: 1995 EN61000-4-6: 1996 E

Summary of the content on the page No. 8

DRIVE CONNECTORS –MK1003GAL (HDD1262) Figure 1. MK1003GAL HDD - INTERFACE CONNECTOR Interface Connector Drive Side Connector MCD-D50 Series by DDK Connectors Recommended Host Side Connector MCD-D50 Series by DDK Connectors 6

Summary of the content on the page No. 9

Interface Signals DRIVE INTERFACE SIGNALS PIN SIGNAL PIN SIGNAL 1 RESET 2 GROUND 3 DD 7 4 DD 8 5 DD 6 6 DD 9 7 DD 5 8 DD 10 9 DD 4 10 DD 11 11 DD 3 12 DD 12 13 DD 2 14 DD 13 15 DD 1 16 DD 14 17 DD 0 18 DD 15 19 GROUND 20 OPEN 21 DMARQ 22 GROUND 23 DIOW/STOP 24 GROUND 25 DIOR/ 26 GROUND -DMARDY HSTROBE 27 IORDY/ 28 CSEL -DMARDY/- DSTROBE 29 DMACK 30 GROUND 31 INTRQ 32 IOCS16 33 DA1 34 PDIAG 35 DA0 36 DA 2 37 CS0 38 CS1 39 DASP 40 GROUND 41 3.3V (LOGIC) 42 3.3V (MOTO