Summary of the content on the page No. 5
Seagate Technology Support Services For information regarding online support and services, visit http://www.seagate.com/about/contact-us/technical-support/ Available services include: • Presales & Technical support • Global Support Services telephone numbers & business hours • Authorized Service Centers Warranty terms will vary based on type of warranty chosen: “Managed Life” or “Limited Warranty With Media Usage”. Consult your Seagate sales representative for warranty terms and conditions. For
Summary of the content on the page No. 6
1.0 INTRODUCTION ® This manual describes the functional, mechanical and interface specifications for the following Seagate 600 SSD model drives: 2.5" Limited Warranty With 2.5" Limited Warranty With Media, 7mm Model Media, 5mm Model ST480HM000 ST480HM001 ST240HM000 ST240HM001 ST120HM000 ST120HM001 These drives provide the following key features: • Multi-Level Cell (19nm MLC) NAND Flash storage. • Serial ATA 3.1 Host Interface (SATA 6Gb/s). • High instantaneous (burst) data-tra
Summary of the content on the page No. 7
2.0 DRIVE SPECIFICATIONS Unless otherwise noted, all specifications are measured under ambient conditions, at 25°C, and nominal power. For convenience, the phrases the drive and this drive are used throughout this manual to indicate the following drive models: Capacity 480GB 240GB 120GB 2.5” Limited Warranty With Media Usage ST480HM000 ST480HM001 ST240HM000 ST240HM001 ST120HM000 ST120HM001 Product data communicated in this manual is specific only to the model numbers listed in this manual.
Summary of the content on the page No. 8
Drive specification ST480HM000 ST480HM001 ST240HM000 ST240HM001 ST120HM000 ST120HM001 Vibration, random nonoperating 20–2000 Hz: 11.08 Grms 16 Nonrecoverable read errors, max 1 LBA per 10 bits read Annualized Failure Rate (AFR) 0.58% Warranty 3-Year Limited Warranty With Media Usage Lifetime Power cycles 25,000 Supports Hotplug operation per Yes Serial ATA Revision 3.0 specification *One GB equals one billion bytes when referring to drive capacity. Accessible capacity may vary depending o
Summary of the content on the page No. 9
2.4 PERFORMANCE, RECORDING AND INTERFACE TECHNOLOGY 2.4.1 Interface technology 480GB models 240GB models 120GB models Interface Serial ATA (SATA-II) Interface Speeds Supported 6Gb/s, 3Gb/s, 1.5Gb/s Maximum Burst Transfer Rate 600MB/s Hot Plug Support Yes Native Command Queuing Support Yes Trim Support Yes 2.4.2 Recording technology Flash Memory Type NAND MLC Emulated LBA Size (Bytes) 512 Default transfer alignment offset 0 Typical Data Retention with Power removed (at 30°C) 12 months 2.4.3 Pe
Summary of the content on the page No. 10
2.5 PHYSICAL CHARACTERISTICS ST480HM000, ST240HM000 ST480HM001, ST240HM001 & ST120HM000 & ST120HM001 Maximum height 7.00 mm (0.276 in) 5.00 mm (0.197 in) Maximum width 70.10 mm (2.760 in) Maximum length 100.45 mm (3.955 in) Max weight 77 g (0.170lb) 67 g (0.148 lb) 2.6 TIME TO READY 480GB 240GB 120GB Power-on to Ready (sec) <1 (typ) SEAGATE 600 SSD PRODUCT MANUAL, REV. B 6
Summary of the content on the page No. 11
2.7 POWER SPECIFICATIONS The drive receives DC power (+5V) through a native SATA power connector. See 2 on page 16. 2.7.1 Power consumption Power requirements for the drives are listed in the table on page 9. Typical power measurements are based on an average of drives tested, under nominal conditions, at 35°C ambient temperature. • Startup power Startup power is measured from the time of power-on to the time that the drive reaches operating condition and can pro- cess media access commands.
Summary of the content on the page No. 12
Table 3 240GB DC power requirements Parameter ST240HM000, ST240HM001 (6.0Gb) Voltage +5V Power Regulation +/- 5% (watts) Average Idle Current 0.22 1.10 Average Sleep Current 0.10 0.50 Maximum Start Current 0.95 DC (Peak DC) 0.52 AC (Peak AC) 0.38 Peak Operating Current (random read): Typical DC 0.32 1.57 Maximum DC 0.34 1.68 Maximum DC (peak) 0.78 3.90 Peak Operating Current (random write): Typical DC 0.41 2.03 Maximum DC 0.46 2.27 Maximum DC (peak) 1.22 6.10 Peak Operating Current (sequentia
Summary of the content on the page No. 13
Table 4 120GB DC power requirements Parameter ST120HM000, ST120HM001 (6.0Gb) Voltage +5V Power Regulation +/- 5% (watts) Average Idle Current 0.22 1.10 Average Sleep Current 0.10 0.50 Maximum Start Current 0.95 DC (Peak DC) 0.54 AC (Peak AC) 0.70 Peak Operating Current (random read): Typical DC 0.34 1.67 Maximum DC 0.35 1.72 Maximum DC (peak) 0.82 4.10 Peak Operating Current (random write): Typical DC 0.51 2.54 Maximum DC 0.56 2.18 Maximum DC (peak) 1.42 7.10 Peak Operating Current (sequentia
Summary of the content on the page No. 14
2.7.2.1 Typical current profiles Figure 1. Typical 5V Startup and Operation Current Profile SEAGATE 600 SSD PRODUCT MANUAL, REV. B 10
Summary of the content on the page No. 15
2.8 ENVIRONMENTAL SPECIFICATIONS 2.8.1 Temperature Temperature is defined as the drive's internal temperature as reported by SMART attribute 194 for operation or the drive case temperature for non-operating. Above 1000 feet (305 meters), the maximum temperature is derated linearly to 112°F (44°C) at 10,000 feet (3048 meters). Operating: 0° to 70°C (32° to 158°F) Nonoperating: –40° to 75°C (–40° to 167°F) 2.8.2 Temperature gradient Operating: 20°C per hour (30°F per hour max), without conde
Summary of the content on the page No. 16
2.8.6.1 Operating vibration The maximum random vibration levels that the drive may experience while meeting the performance standards specified in this document are specified below. This specification does not cover connection issues that may result from testing at this level. 20–2000 Hz 11.08 Grms 2.8.6.2 Nonoperating vibration The maximum random nonoperating vibration levels that the drive may experience without incurring physical damage or degradation in performance when subsequently pu
Summary of the content on the page No. 17
2.10 RELIABILITY 2.10.1 Annualized Failure Rate (AFR) and Mean Time Between Failures (MTBF) The product shall achieve an Annualized Failure Rate - AFR - of 0.58%. AFR and MTBF are population statistics that are not relevant to individual units. AFR and MTBF specifications are based on the following assumptions: • 8760 power-on-hours per year. • 250 average power cycles per year. • Operations at nominal voltages. • Systems will provide adequate cooling to ensure the case temperatures do not e
Summary of the content on the page No. 18
2.11 AGENCY CERTIFICATION 2.11.1 Safety certification These products are certified to meet the requirements of UL60950-1, CSA60950-1 and EN60950 and so marked as to the certify agency. 2.11.2 Electromagnetic compatibility Drives that display the CE mark comply with the European Union (EU) requirements specified in the Electromagnetic Compatibility Directive (2004/108/EC) as put into place 20 July 2007. Testing is performed to the levels specified by the product standards for Information Te
Summary of the content on the page No. 19
2.12 ENVIRONMENTAL PROTECTION Seagate designs its products to meet environmental protection requirements worldwide, including regulations restricting certain chemical substances. 2.12.1 European Union Restriction of Hazardous Substances (RoHS) Directive The European Union Restriction of Hazardous Substances (RoHS) Directive, restricts the presence of chemical substances, including Lead, Cadmium, Mercury, Hexavalent Chromium, PBB and PBDE, in electronic products, effective July 2006. This d
Summary of the content on the page No. 20
3.0 CONFIGURING AND MOUNTING THE DRIVE This section contains the specifications and instructions for configuring and mounting the drive. 3.1 HANDLING AND STATIC-DISCHARGE PRECAUTIONS After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic discharge (ESD) hazards. Observe the following standard handling and static-discharge precautions: Caution: • Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touch
Summary of the content on the page No. 1
Product Manual
®
Seagate 600 SSD
Standard 2.5” 7mm Standard 2.5” 5mm
Limited Warranty With Limited Warranty With
Media Usage models Media Usage models
ST480HM000 ST480HM001
ST240HM000 ST240HM001
ST120HM000 ST120HM001
100722309
Rev. B
May 2013
Summary of the content on the page No. 2
Document Revision History Revision Date Description of changes Rev. A 04/11/2013 Initial release. Rev. B 05/13/2013 1, 3, 4 and 13. © 2013 Seagate Technology LLC. All rights reserved. Publication number: 100722309, Rev. B May 2013 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Seagate 600 SSD and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affili
Summary of the content on the page No. 3
Contents Seagate Technology Support Services . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.0 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 1.1 About the Serial ATA interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 2.0 Drive specifications . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
FIGURES Figure 1. Typical 5V Startup and Operation Current Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Figure 2. Attaching SATA cabling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 6 Figure 3. Mounting configuration dimensions (7mm models) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Figure 4. Mounting configuration dimensions (5mm models) . . . . . . . . . . . . . . . . . .
