Packard Bell Grafite & Carbon CS036A00 user manual

Summary of the content on the page No. 1

Packard Bell
Grafite & Carbon
Disassembly Manual

Summary of the content on the page No. 2

11111 1 Table of Contents About this Guide.................................................................................................................2 For More Information...........................................................................................................2 Technician Notes.................................................................................................................2 Disassembly........................................................................

Summary of the content on the page No. 3

2 About this Guide This guide contains systematic disassembly instructions for the Packard Bell Grafite & Carbon. The instructions are illustrated where necessary with images of the part that is being disassembled. Packard Bell B.V. reserves the right to make changes to the Grafite & Carbon without notice. For More Information For more information about the Packard Bell Grafite & Carbon, visit Packard Bell‘s support web site at www.packardbell.com. The support web site also has links to addition

Summary of the content on the page No. 4

33333 3 Front Cover Perform the following steps to remove the front cover: 1. Make sure the power is off. 2. Turn the device upside down. Note: Use an anti-static mat or something soft like a piece of cloth underneath the device to prevent damage to the exterior of the casing. 3. Insert a flat-blade screwdriver in the 2 orifices to release the front cover and slide the cover up and out of the compartment. Fig. 1 Removing the front cover. Top Cover To remove the top cover, first remove the front

Summary of the content on the page No. 5

44444 4 2. Slide the top cover to the front of the device and remove the cover. Fig. 2 Removing the top cover. Hard Disk Drive To remove the hard disk drive, first remove the front cover (see Front Cover on page 3), remove the top cover (see Top Cover on page 3), and then perform the following steps: 1. Remove the 4 screws (2 on either long side) securing the hard disk drive in the device. Note: One of the screws on each side of the hard disk drive holds a spacer clip. Fig. 3 Removing the hard d

Summary of the content on the page No. 6

55555 5 2. Slide the hard disk drive towards the front to disconnect it from the I/O board. Fig. 4 Removing the hard disk drive. 3. Lift the hard disk drive out of the device (see Fig. 4). I/O Board To remove the I/O board, first remove the front cover (see Front Cover on page 3), remove the top cover (see Top Cover on page 3), remove the hard disk drive (see Hard Disk Drive on page 4), and then perform the following steps: 1. Remove the 2 screws securing the I/O board. Fig. 5 Removing the I/O b

Summary of the content on the page No. 7

66666 6 Notice The information in this guide is subject to change without notice. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from Packard Bell B.V. PACKARD BELL B.V. SHALL NOT BEHELD LIABLEFOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINEDHEREIN; NORFOR INCIDENTAL ORCONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USEOF THISMATERIAL. Copyright ©