Summary of the content on the page No. 1
®
DiamondMax Plus 40
54098U8, 53073U6, 52049U4,
51536U3, 51024U2
Part #1429/A
All material contained herein Copyright © 2000 Maxtor Corporation.
® ®
MaxFax™ is a trademark of Maxtor Corporation. DiamondMax , Maxtor
®
and No Quibble Service are registered trademarks of Maxtor Corporation.
Other brands or products are trademarks or registered trademarks of their
respective holders. Contents and specifications subject to change without
notice. All rights reserved.
Corporate Headquarters
510 Cottonw
Summary of the content on the page No. 2
Before Y Before Y Before Y Before Y Before You Begin ou Begin ou Begin ou Begin ou Begin ® Thank you for your interest in the Maxtor DiamondMax Plus 40 AT hard disk drives. This manual provides technical information for OEM engineers and systems integrators regarding the installation and use of DiamondMax hard drives. Drive repair should be performed only at an authorized repair center. For repair information, contact the Maxtor Customer Service Center at 800-2MAXTOR or 408-922-2085. Before unpa
Summary of the content on the page No. 3
DIAMONDMAX PLUS 40 PRODUCT MANUAL Contents Contents Contents Contents Contents Section 1 Section 1 Section 1 — Introduction Introduction Introduction Section 1 Section 1 Introduction Introduction Maxtor Corporation 1 - 1 Products 1 - 1 Support 1 - 1 Manual Organization 1 - 1 Abbreviations 1 - 1 Conventions 1 - 2 Key Words 1 - 2 Numbering 1 - 2 Signal Conventions 1 - 2 Section 2 Section 2 Section 2 Section 2 Section 2 — Product Description Product Description Product Description Product Descript
Summary of the content on the page No. 4
DIAMONDMAX PLUS 40 PRODUCT MANUAL Section 3 Section 3 Section 3 — Product Specifications Product Specifications Product Specifications Section 3 Section 3 Product Specifications Product Specifications Models and Capacities 3 - 1 Drive Configuration 3 - 1 Performance Specifications 3 - 1 Physical Dimensions 3 - 2 Power Requirements 3 - 3 Power Mode Definitions 3 - 3 Spin-up 3 - 3 Seek 3 - 3 Read/Write 3 - 3 Idle 3 - 3 Standby 3 - 3 Sleep 3 - 3 EPA Energy Star Compliance 3 - 3 Environmental Limit
Summary of the content on the page No. 5
DIAMONDMAX PLUS 40 PRODUCT MANUAL Section 5 Section 5 Section 5 — AT Interface Description AT Interface Description AT Interface Description Section 5 Section 5 AT Interface Description AT Interface Description Interface Connector 5 - 1 Pin Description Summary 5 - 1 Pin Description Table 5 - 2 PIO Timing 5 - 3 DMA Timing 5 - 4 Ultra DMA Timing Parameters 5 - 5 Section 6 Section 6 Section 6 — Host Software Interface Host Software Interface Host Software Interface Section 6 Section 6 Host Softwa
Summary of the content on the page No. 6
DIAMONDMAX PLUS 40 PRODUCT MANUAL Write Verify Sector(s) 7 - 4 Write Sector Buffer 7 - 4 Write DMA 7 - 5 Write Multiple 7 - 5 Ultra DMA 7 - 5 Set Feature Commands 7 - 5 Set Features Mode 7 - 5 Power Mode Commands 7 - 7 Standby Immediate 7 - 7 Idle Immediate 7 - 7 Standby 7 - 7 Idle 7 - 7 Check Power Mode 7 - 7 Set Sleep Mode 7 - 7 Default Power-on Condition 7 - 7 Initialization Commands 7 - 9 Identify Drive 7 - 9 Initialize Drive Parameters 7 - 12 Seek, Format, and Diagnostic Commands 7 - 13 S.M
Summary of the content on the page No. 7
DIAMONDMAX PLUS 40 PRODUCT MANUAL Figures Figures Figures Figures Figures Figure Title Page 2 - 1 PCBA Jumper Location and Configuration 2 - 6 3 - 1 Outline and Mounting Dimensions 3 - 2 4 - 1 Multi-pack Shipping Container 4 - 2 4 - 2 Single-pack Shipping Container (Option A) 4 - 3 4 - 3 Single-pack Shipping Container (Option B) 4 - 3 4 - 4 Master, Slave and Cable Select Settings 4 - 5 4 - 5 5.25-inch Mounting Brackets and Rails 4 - 6 4 - 6 IDE Interface and Power Cabling Detail 4 - 7 4 - 7 Mast
Summary of the content on the page No. 8
DIAMONDMAX PLUS 40 – INTRODUCTION SECTION 1 Introduction Introduction Introduction Introduction Introduction Maxtor Corporation Maxtor Corporation Maxtor Corporation Maxtor Corporation Maxtor Corporation Maxtor Corporation has been providing high-quality computer storage products since 1982. Along the way, we’ve seen many changes in data storage needs. Not long ago, only a handful of specific users needed more than a couple hundred megabytes of storage. Today, downloading from the Internet and C
Summary of the content on the page No. 9
DIAMONDMAX PLUS 40 – INTRODUCTION Conventions Conventions Conventions Conventions Conventions If there is a conflict between text and tables, the table shall be accepted as being correct. Key Words Key Words Key Words Key Words Key Words The names of abbreviations, commands, fields and acronyms used as signal names are in all uppercase type (e.g., IDENTIFY DRIVE). Fields containing only one bit are usually referred to as the “name” bit instead of the “name” field. Names of drive registers begin
Summary of the content on the page No. 10
PRODUCT DESCRIPTION SECTION 2 Product Product Description Description Product Product Product Description Description Description ® Maxtor DiamondMax Plus 40 AT disk drives are 1-inch high, 3.5-inch diameter random access storage devices which incorporate an on-board ATA-5/Ultra DMA 66 controller. High capacity is achieved by a balanced combination of high areal recording density and the latest data encoding and servo techniques. Maxtor's latest advancements in electronic packaging and integr
Summary of the content on the page No. 11
PRODUCT DESCRIPTION Product Product Product Product Product Features Features Features Features Features Functional / Interface Functional / Interface Functional / Interface Functional / Interface Functional / Interface Maxtor DiamondMax Plus 40 hard drives contain all necessary mechanical and electronic parts to interpret control signals and commands from an AT-compatible host computer. See Section 3 Product Specifications, for complete drive specifications. Zone Density Recording Zone Dens
Summary of the content on the page No. 12
PRODUCT DESCRIPTION The LBA is checked for violating the drive capacity. If it does not, the LBA is converted to physical drive cylinder, head and sector values. The physical address is then used to access or store the data on the disk and for other drive related operations. Defect Management Zone (DMZ) Defect Management Zone (DMZ) Defect Management Zone (DMZ) Defect Management Zone (DMZ) Defect Management Zone (DMZ) Each drive model has a fixed number of spare sectors per drive, all of which ar
Summary of the content on the page No. 13
PRODUCT DESCRIPTION Major HDA Components Major HDA Components Major HDA Components Major HDA Components Major HDA Components Drive Mechanism Drive Mechanism Drive Mechanism Drive Mechanism Drive Mechanism A brush-less DC direct drive motor rotates the spindle at 7,200 RPM (±0.1%). The dynamically balanced motor/spindle assembly ensures minimal mechanical run-out to the disks. A dynamic brake provides a fast stop to the spindle motor upon power removal. The speed tolerance includes motor performa
Summary of the content on the page No. 14
PRODUCT DESCRIPTION Subsystem Configuration Subsystem Configuration Subsystem Configuration Subsystem Configuration Subsystem Configuration Dual Drive Support Dual Drive Support Dual Drive Support Dual Drive Support Dual Drive Support Two drives may be accessed via a common interface cable, using the same range of I/O addresses. The drives are jumpered as device 0 or 1 (Master/Slave), and are selected by the drive select bit in the Device/Head register of the task file. All Task File registers a
Summary of the content on the page No. 15
PRODUCT SPECIFICATIONS SECTION 3 Product Specifications Product Specifications Product Specifications Product Specifications Product Specifications Models and Capacities Models and Capacities Models and Capacities Models and Capacities Models and Capacities MODEL 56 4098U854 3073U53 2049U52 1536U 51024U 45 0,98030 0,7327 0,4915 5,36 10,24 Formatted Capacity (MB LBA Mode) 6 9 Maxtor defines one megabyte as 10 or one million bytes and one gigabyte as 10 or one billion bytes. Drive Configuration Dr
Summary of the content on the page No. 16
PRODUCT SPECIFICATIONS Physical Dimensions Physical Dimensions Physical Dimensions (maximum) Physical Dimensions Physical Dimensions PD ARAMETERSC TANDAR METRI Hs eight1s .028 inche 26.1 millimeter Ls ength5s .787 inche 147 millimeter Ws idth4s .00 inche 101.6 millimeter Ws eight1s .3 pound 0.59 kilogram 1.028 max [26.1 mm max 6 x 6-32 1.638 ± .010 1.122 ± .020 .25 ± .01 UNC -28 [41.6 ± 0.25 mm] [28.5 ± 0.5 mm] [6.35 ± 0.25 mm THREAD 4.00 ± .01 [101.6 ± 0.5 mm] 5.787 max [147 mm max] 4 x 6-32 1
Summary of the content on the page No. 17
PRODUCT SPECIFICATIONS Power Requirements Power Requirements Power Requirements Power Requirements Power Requirements
Power Mode Definitions Power Mode Definitions Power Mode Definitions Power Mode Definitions Power Mode Definitions Spin-up Spin-up Spin-up Spin-up Spin-up The
Summary of the content on the page No. 18
PRODUCT SPECIFICATIONS Shock and Vibration Shock and Vibration Shock and Vibration Shock and Vibration Shock and Vibration PG ARAMETEROG PERATIN NON-OPERATIN Ms echanical Shock 60 Gs, 2.0 ms, no error 250 Gs, 2.0 ms, no damage Rotational Shock 20,000 Rad/sec,0.5 - 1.0 ms, no damage 2 2 RG andom Vibration 10 - 45 Hz at 0.004 /Hz 10 Hz at 0.05 G /Hz 2 2 48 - 62 Hz at 0.008 G /Hz 20 Hz at 0.055 G /Hz 2 2 65 - 300 Hz at 0.004 G /Hz 300 Hz at 0.05 G /Hz 2 2 301 - 500 Hz at 0.0006 G /Hz 301 Hz at 0.00
Summary of the content on the page No. 19
PRODUCT SPECIFICATIONS EMC/EMI EMC/EMI EMC/EMI EMC/EMI EMC/EMI Radiated Electromagnetic Field Emissions - EMC Compliance Radiated Electromagnetic Field Emissions - EMC Compliance Radiated Electromagnetic Field Emissions - EMC Compliance Radiated Electromagnetic Field Emissions - EMC Compliance Radiated Electromagnetic Field Emissions - EMC Compliance The hard disk drive mechanism is designed as a subassembly for installation into a suitable enclosure and is therefore not subject to Subpart J of
Summary of the content on the page No. 20
INSTALLATION SECTION 4 Handling and Installation Handling and Installation Handling and Installation Handling and Installation Handling and Installation Hard Drive Handling Precautions Hard Drive Handling Precautions Hard Drive Handling Precautions Hard Drive Handling Precautions Hard Drive Handling Precautions If the handling precautions are not followed, damage to the hard drive may result - which may void the warranty. During handling, NEVER drop, jar, or bump a drive. Handle the drive by
