Summary of the content on the page No. 1
Dell™ PowerVault™
NX3100 Systems
Getting Started
With Your System
Guide de mise en route
Introdução ao Uso do Sistema
Introducción al sistema
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Dell™ PowerVault™ NX3100 Systems Getting Started With Your System Regulatory Model E13S Series
Summary of the content on the page No. 4
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. © 2010 Dell Inc. All rights reserved. Reproduction of these materials in any manner w
Summary of the content on the page No. 5
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking the System Unpack your system and identify each item. Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system. Getting Started With Your System 3
Summary of the content on the page No. 6
Optional – Connecting the Keyboard, Mouse, and Monitor Connect the keyboard, mouse, and monitor (optional). The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector. Connecting the Power Cable(s) Connect the system’s power cable(s) to the system and, if a monitor is used, connect the monitor’s power cable to the monitor. 4 Getting Started With Your System
Summary of the content on the page No. 7
Securing the Power Cable(s) Bend the system power cable into a loop as shown in the illustration and secure the cable to the bracket using the provided strap. Plug the other end of the power cable into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Turning On the System Press the power button on the system and the monitor. The power indicators should light. Getting Started With Your System 5
Summary of the content on the page No. 8
Installing the Optional Bezel Install the bezel (optional). Supported Operating System ® ® Your system is preinstalled with Microsoft Windows Storage Server 2008 (x64) Edition. NOTE: For the latest information on supported operating systems, see support.dell.com. 6 Getting Started With Your System
Summary of the content on the page No. 9
Other Information You May Need WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included within this document or as a separate document. � The rack documentation included with your rack solution describes how to install your system into a rack. � The Hardware Owner’s Manual provides information about system features and describes how to troubleshoot the system and install or replace system components. This document is available
Summary of the content on the page No. 10
NOM Information (Mexico Only) The following information is provided on the device described in this document in compliance with the requirements of the official Mexican standards (NOM): Importer: Model number: E13S Series Supply voltage: 100–240 V CA Frequency: 50/60 Hz Current consumption: 7.5–4.0 A Technical Specifications Processor ® ® Processor type Two Intel Xeon processors 5500 or 5600 series Expansion Bus Bus type PCI Express Generation 2 Expansion slots using riser cards NOTE: Depend
Summary of the content on the page No. 11
Memory Architecture 1066 or 1333 MHz DDR3 registered or unbuffered Error Correcting Code (ECC) DIMMs Memory module sockets Eight 240-pin Memory module capacities 1 GB, 2 GB, 4 GB, or 8 GB Minimum RAM 1 GB with a single processor (one DIMM per processor) Maximum RAM 64 GB (8 GB dual- and quad-rank DIMMs) Drives Hard drives Up to twelve 3.5-inch or 2.5-inch, hot-swappable SAS, SATA, or SSD drives and up to two cabled 2.5-inch SAS drives Optical drive External USB DVD-ROM Connectors Back NIC Two
Summary of the content on the page No. 12
Power AC power supply (per power supply) Wattage 750 W (optional redundant power supply) Voltage 100–240 VAC, autoranging, 50–60 Hz Heat dissipation 2450 BTU/hr maximum Maximum inrush current Under typical line conditions and over the entire system ambient operating range, the inrush current may reach 55 A per power supply for 10 ms or less. Batteries System battery CR 2032 3.0-V Lithium coin cell Physical Height 8.67 cm (3.42 inches) Width 44.52 cm (17.53 inches) Depth 66.46 cm (26.17 inches)
Summary of the content on the page No. 13
Environmental (continued) Relative humidity Operating 20% to 80% (noncondensing) with a maximum humidity gradation of 10% per hour Storage 5% to 95% (noncondensing) Maximum vibration Operating 0.26 G at 5–350 Hz for 15 min Storage 1.54 G at 10–250 Hz for 15 min Maximum shock Operating One shock pulse in the positive z axis (one pulse on each side of the system) of 31 G for 2.6 ms in the operational orientation Storage Six consecutively executed shock pulses in the positive and negative x, y
Summary of the content on the page No. 14
12 Getting Started With Your System
Summary of the content on the page No. 15
Systèmes Dell™ PowerVault™ NX3100 Guide de mise en route Modèle réglementaire de série E13S
Summary of the content on the page No. 16
Remarques, précautions et avertissements REMARQUE : une REMARQUE indique des informations importantes qui peuvent vous aider à mieux utiliser votre ordinateur. PRÉCAUTION : une PRÉCAUTION vous avertit d'un risque d’endommagement du matériel ou de perte de données en cas de non-respect des instructions. AVERTISSEMENT : un AVERTISSEMENT vous avertit d'un risque d'endommagement du matériel, de blessure corporelle ou de mort. ____________________ Les informations que contient ce document sont
Summary of the content on the page No. 17
Installation et configuration AVERTISSEMENT : avant d'exécuter la procédure ci-dessous, lisez les consignes de sécurité fournies avec le système. Déballage du système Sortez le système de son emballage et identifiez chaque élément. Assemblez les rails et installez le système dans le rack en suivant les consignes de sécurité et les instructions d'installation du rack fournies avec votre système. Guide de mise en route 15
Summary of the content on the page No. 18
Facultatif – Connexion du clavier, de la souris et du moniteur Connectez le clavier, la souris et le moniteur (si nécessaire). Aidez-vous des icônes des connecteurs situés à l'arrière du système pour savoir où insérer chaque câble. N'oubliez pas de serrer les vis situées sur le connecteur du câble du moniteur, s'il en est équipé. Branchement du ou des câbles d'alimentation Connectez le ou les câbles d'alimentation au système et, si vous utilisez un moniteur, connectez son câble d'alimentation
Summary of the content on the page No. 19
Fixation du ou des câbles d'alimentation Faites une boucle comme indiqué dans l'illustration, puis fixez-le à l'aide de la sangle fournie. Branchez ensuite l'autre extrémité du câble d'alimentation sur une prise secteur mise à la terre ou sur une source d'alimentation autonome (telle qu'un onduleur ou une unité de distribution de l'alimentation). Mise sous tension du système Appuyez sur le bouton d'alimentation du système et sur celui du moniteur. Les voyants d'alimentation s'allument. Guide
Summary of the content on the page No. 20
Installation du cadre en option Installez le cadre (si nécessaire). Système d'exploitation pris en charge ® ® Microsoft Windows Storage Server 2008 Édition Standard x64 est préinstallé sur votre système. REMARQUE : pour obtenir les informations les plus récentes sur les systèmes d'exploitation pris en charge, rendez-vous sur le site support dell.com. 18 Guide de mise en route
