Addonics Technologies RCHDSAES user manual

Summary of the content on the page No. 1

Enclosure Overview





top cover










Addonics

shock
T E C H N O L O G I E S

absorbers




2.5” SATA


hard drive switch



Ruby Combo Hard Drive



RCHDSAES & RCHDSAEU

PCB



bottom cover










User’s Guide
Step 1 Separate the top from the bottom cover of the drive enclosure by
loosening the screw as shown on the photo.
Version 1.0










FCC Warning Statement



This equipment has been tested and found

Summary of the content on the page No. 2

Step 4 Turn over the PCB and secure the hard drive to the PCB with the Ruby Enclosure mounting screws that come with the kit. Switch Power LED and Drive Access LED Switch: INT: This mode is used when the enclosure is placed inside a drive cradle. For mobile rack kits, this is the mode used. EXT: This mode is used if the enclosure is used as an external hard Step 5 Mount the board to the bottom cover. drive. Ruby Drive Cradle

Summary of the content on the page No. 3

Model: RCHDSAES Model: RCHDSAEU *Note: The Ruby combo hard drive with the eSATA interface must be connected For External Application: to a SATA controller with hot swap capability in order to add and remove drive cartridge without rebooting. Please consult your motherboard or the add-in card manufacturer to determine hot swap support on your SATA controller. All of the Addonics SATA Host Controllers are hot swap capable. For External Application: eSA

Summary of the content on the page No. 4

For Internal Application: (Applies to both models) Technical Support If you need assistance to get your unit functioning properly, please call Addonics Technical Support. Our technical staff will be happy to assist you, but they will need your help to do so. Calling the technical support staff without all the proper Drive information can be both time consuming and frustrating. Here are some tips to enclosure help you out: MODEL NUMBER – Please have this number on hand. Dr