Summary of the content on the page No. 1
Operator’s Manual
Rear-tine PTO Tiller Models
TM
682J—Horse
TM
E686N—Horse
TM
E682L—Horse
Model 682J Shown
IMPORTANT:READ SAFETY RULES AND INSTRUCTIONS CAREFULLY
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintaine
Summary of the content on the page No. 2
Section 6 Parts List WHEELS/TINES/PTO DRIVE LEVER & YOKE ASSEMBLY See Page 52 REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 GW-2555 Lever–Wheels/Tines/PTO Drive ..... 1 10 GW-2164 Link–yoke pivot, left & right, 2 1908156 Spring–clutch pawl........................ 1 6-7/8" long ................................. 2 3 710-0805 Bolt–hex hd., 5/16-18 x 1-1/2"....... 3 11 710-0514 Bolt–hex hd., 3/8-16 x 1" ............... 6 4 GW-2447 Bushing–3/8" ................................
Summary of the content on the page No. 3
Parts List MODELS 682J &, E682L FORWARD INTERLOCK SYSTEM See Page 48 REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 GW-2552 Engine Wire Harness Assy–forward 2 GW-9971 Lockwasher–external tooth, 7/16" ......1 interlock system (Incl. one red 3 1186246 Nut–hex, 7/16"-20 ....................... 1 and one black wire, plug con- 6 GW-9205 Clip–for plug connector............... 1 nector, neutral switch and PVC 7 725-0157 Tie–plastic ................................... 2 tubing.
Summary of the content on the page No. 4
Parts List MODELS 682J &, E682L HANDLEBAR ASSEMBLY REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 GW-9548 Bolt–Hex hd., flanged self-locking 16 1909286 Throttle Control & Cable................ 1 Grade 5, 1/2-13 x 3-1/2" ............ 1 17 777I20946 Decal–Forward Interlock Lever ...... 2 2 GW-9119 Knob–handlebar height adjustment 1 18 725-0157 Tie–plastic ..................................... 2 3 GW-9120 Ring–retaining (tolerance ring)...... 1 19 GW-9219 Plug–wire harness r
Summary of the content on the page No. 5
Parts List MODELS 682J &, E682L DEPTH REGULATOR & TINE HOOD ASSEMBLIES See Page 54 REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 710-3005 Bolt–hex hd., 3/8-16 x 1-1/4" ........ 2 12 GW-9929 Washer–flat, 5/16"......................... 2 2 GW-1113-1 Bushing–19/64" (.300" lg.) ............ 2 13 GW-2468 Hood ............................................. 1 3 736-0169 Lockwasher–spring lock, 3/8" ....... 2 14 777S32000 Decal–hood, operating instructions. 1 4 712-0798 Nut–hex,
Summary of the content on the page No. 6
Parts List MODELS 682J &, E682L WHEEL SPEED LEVER, BELT DRIVE SYSTEM, ENGINES, WHEELS See Page 62 See Page 52 48
Summary of the content on the page No. 7
Parts List MODELS 682J &, E682L REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. WHEEL SPEED LEVER ENGINES AND ENGINE MOUNT 1 GW-9362 Pin–spring, 1/8"................................ 1 28 710-0376 Bolt–hex hd., 5/16-18 x 1", Grade 5.. .... 2 2 GW-9838 Nut–castle (slotted), 1/2"-20 ............ 1 29 712-0267 Nut, hex, 5/16-18.............................. 1 3 GW-9934 Washer–shoulder, 1/2"..................... 1 30 GW-1034 Bar–engine mounting....................... 2 4 GW-9932
Summary of the content on the page No. 8
Parts List MODELS 682J &, E682L POWER UNIT TRANSMISSION ASSEMBLIES See Page 50 ,16A 50
Summary of the content on the page No. 9
Parts List MODELS 682J &, E682L REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. TRANSMISSION COVER & SHIFT LEVER 35 GW-9301 Key–3/16 sq. x 1" .......................... 3 BRACKET ASSEMBLIES 36 1100004 Bolt–hex hd., 5/16-24 x 3/4", self- 1 1186299 Bolt–hex hd., #10-32 x 3/8", locking flange, Grade 5.............. 1 self-locking flange ..................... 3 37 GW-9944 Washer–disc spring (concave)...... 1 2 GW-9463 Knob–tines/PTO clutch lever, 38 GW-2107 Pulley–transmission d
Summary of the content on the page No. 10
Parts List MODELS 682J & E682L POWER UNIT TRANSMISSION ASSEMBLIES (Continued from page 53) See Page 50 52
Summary of the content on the page No. 11
Parts List MODELS 682J & E682L REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. (continued from page 53) 75 611-04003 Eccentric Shaft–wheel speed WHEEL SHAFT ASSEMBLY shifting ...................................... 1 61 GW-9621 Seal–oil, wheel shaft ..................... 2 76 GW-1441 Spring–eccentric shaft .................. 1 62 1909950 Retaining ring–external ................. 2 63 GW-1166-1 Shim–wheel shaft, 1-1/64" inner TRANSMISSION HOUSING dia., .062" thick............
Summary of the content on the page No. 12
Parts List MODELS 682J & E682L TILLER ATTACHMENT TRANSMISSION ASSEMBLIES NOTE 1: THESE SCREWS HAVE A SPECIAL SEALING DESIGN THAT CAN NOT BE REUSED WITHOUT RISKING THE LOSS OF TRANSMISSION OIL. IF THESE SCREWS ARE LOOSENED OR REMOVED, THEY MUST BE REPLACED WITH NEW HARDWARE. 54
Summary of the content on the page No. 13
Parts List MODELS 682J & E682L REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 1915068 Screw–self-sealing,1/4"-20 x 5/8" 5 17 GW-1224-2 Shim–same as above, .030" As 2 GW-20873 Cover–tiller housing ..................... 1 thick...........................................Req'd 3 GW-1129-1 Gasket–tiller housing cover, .010". As 17 GW-1224-3 Shim–same as above, .005" As thick...........................................Req’d thick................................
Summary of the content on the page No. 14
Parts List MODELS 682J & E682L BOLO TINE ASSEMBLIES 56
Summary of the content on the page No. 15
Parts List MODELS 682J & E682L REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. STANDARD TILLING TINES CUSTOM TILLING TINES 1 1901975 Tine Holder–welded steel, fits Special hard-faced, high-chrome carbon alloy tines that are left or right sides...................... 2 thicker than standard Bolo Tines. These tines better resist the 2 1982612 Bolt–hex hd., 3/8-16 x 2" ............. 4 abrasive action of rocky, gritty or sandy soil as compared to 6 GW-1270-1 Bolo Tine–single, lef
Summary of the content on the page No. 16
Parts List MODEL E682L ELECTRIC START SYSTEM 58 ➨ ➨ ➨ ➨ ➨ ➨ ➨ ➨ ➨ ➨
Summary of the content on the page No. 17
Parts List MODEL E682L REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. 1 GW-96515 Cable–battery, positive and negative 14 GW-96514 Solenoid–starter, includes nuts and terminals.................................. 2 washers for cables and wires... 1 2 GW-97020 Boot–terminal insulating ............. 3 15 736-0119 Lockwasher–5/16" ....................... 3 3 GW-9552 Screw–self-threading, 16 1186211 Nut–hex, 5/16"-24 ....................... 2 1/4-20 x 1/2" .........................
Summary of the content on the page No. 18
Parts List MODELS 682J & E682L BUMPER ATTACHMENT 9 11 10 8 7 6 5 4 3 2 1 REF PART REF PART No. No. DESCRIPTION QTY. No. No. DESCRIPTION QTY. --- 290-255-081 Bumper Attachment. Includes 6 736-0119 Lockwasher - spring lock, 5/16" .. 2 Ref. Nos. 1 through 11) ........... 1 7 712-0267 Nut - hex, 5/16"-18 ...................... 2 1 1910730 Brace - bumper bottom ............... 1 8 1910731 Bumper wraparound.................... 1 2 710-3181 Bolt - hex hd., 1/2-13 x 1-1/2" ..... 1 9 710-0514 Bolt - he
Summary of the content on the page No. 19
Appendix B: Attachments & Accessories ® Troy-Bilt PTO Log Splitter Row Marker Attachment Wheel Weights 290-258-081 290-257-081 290-266-081 ® The Troy-Bilt PTO Log Splitter provides Do you like very straight, even, neat rows Help increase traction by putting extra you with a convenient and easy means of in your garden? If so, the Row Marker is weight directly on the wheels. They splitting about a half a cord of wood per a must attachment. Hooks quickly to the reduce bucking and jumping when d
