Summary of the content on the page No. 1
Enregistrez votre produit et bénéficiez d’une assistance à l’adresse suivante
www.philips.com/welcome
AT940, AT893, AT890, AT753, AT752, AT750
Summary of the content on the page No. 2
Summary of the content on the page No. 3
1 I
Summary of the content on the page No. 4
Summary of the content on the page No. 5
English 6 FrAnçAis (CAnAd A) 23 AT940, AT893, AT890, AT753, AT752, AT750
Summary of the content on the page No. 6
6 English introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. general description (Fig. 1) A Protection cap B Shaving unit C Shaving unit release button D Shaver on/off button (AT893/AT890/AT753/ AT752/A
Summary of the content on the page No. 7
English 7 important Read this user manual carefully before you use the appliance and the charging stand (AT940 only). Save it for future reference. danger - Make sure the adapter does not get wet. Warning - The adapter contains a transformer. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience an
Summary of the content on the page No. 8
8 English and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. - Do not use the shaver, adapter or charging stand (AT940 only) if it is damaged, as this may cause injury. Always replace a damaged adapter or charging stand with one of the original type. - Charge and store the appliance at a temperature between 10°C and 35°C. - Always place and use the shaver and the charging stand (AT940 only) on a surface that is fluid- resistant. - Only use the
Summary of the content on the page No. 9
English 9 Charging Note: The shaver cannot be used directly from the mains. AT940/AT893/AT890 only: It takes approx. 1 hour to fully charge the shaver. AT753/AT752/AT750: It takes approx. 8 hours to fully charge the shaver. When you charge the shaver for the first time or after a long period of disuse, let it charge until the white battery symbol lights up continuously (AT940) or the charging light lights up green continuously (AT893/AT890/AT753/AT752/AT750. A fully charged shaver prov
Summary of the content on the page No. 10
10 English Quick charging (AT940/AT893/AT890 only) - AT940: When you start charging the empty battery, both the white battery symbol and the plug symbol flash. After approx. 3 minutes, the orange plug symbol goes out, while the battery symbol continues to flash. The shaver now contains enough energy for a 5-minute shave. - AT893/AT890: When you start charging the empty battery, the charging light alternately flashes orange and green. After approx. 3 minutes the charging light continues t
Summary of the content on the page No. 11
English 11 - AT893/AT890/AT753/AT752/AT750: When the battery is fully charged, the charging light lights up green continuously. Note: After approx. 30 minutes, the charging light goes out to save energy. Charging with the adapter 1 Put the small plug in the shaver. 2 Put the adapter in the wall socket. , The charging light shows the charging status of the shaver (see section ‘Charge indications’ in this chapter). Charging in the charging stand (AT940 only) 1 Put the small plug in
Summary of the content on the page No. 12
12 English Note: We advise you to use the shaver with shaving gel or foam when you use it for a wet shave. Do not use thick shaving cream or shaving oil with this shaver. - For optimal shaving results, make circular movements during use. - The shaver is waterproof and can be used in the bath or shower. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Wet shaving 1 Apply some water to your skin. 2 Apply shaving foam or shaving gel to your skin. 3
Summary of the content on the page No. 13
English 13 Note: Make sure you rinse all foam or shaving gel off the shaver. dry shaving 1 Press the on/off button once to switch on the shaver. 2 Move the shaving heads in circular movements over your skin. 3 After shaving, press the on/off button once to switch off the shaver. 4 Clean the shaver (see chapter ‘Cleaning and maintenance’). Trimming (AT940/AT893/AT890 only) You can use the trimmer to groom your sideburns and moustache. 1 Push the trimmer slide downwards to open t
Summary of the content on the page No. 14
14 English or acetone to clean the shaver and the charging stand (AT940 only). Always unplug the shaver before you clean it under the tap. - Clean the shaver after every shave for optimal shaving performance. - Regular cleaning guarantees better shaving performance. - For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110). - Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. Note: Water may leak
Summary of the content on the page No. 15
English 15 - Rinse the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Be careful not to hit the shaving unit against anything while shaking off excess water. Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving unit. 5 Open the shaving unit again and leave it open to let the shaver dry completely. Cleaning the shaving unit with the cleaning brush 1 Switch off the shaver. 2 Press the release button
Summary of the content on the page No. 16
16 English 5 Remove and clean one shaving head at a time. Each shaving head consists of a cutter and a guard. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. - Remove the cutter from the shaving guard and clean it with the brush. - Clean the inside and outside of the shaving guard with the brush. 6 Put the shaving
Summary of the content on the page No. 17
English 17 Cleaning the trimmer with the cleaning brush (AT940/AT893/AT890 only) Clean the trimmer every time you have used it. 1 Switch off the shaver. 2 Push the trimmer slide downwards to open the trimmer. 3 Clean the trimmer with the short-bristled side of the cleaning brush. Brush up and down along the trimmer teeth. 4 Close the trimmer (‘ click’). Tip: For optimal trimming performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage T
Summary of the content on the page No. 18
18 English Only replace the shaving heads with original HQ9 Philips Shaving Heads (for AT940) or HQ8 Philips Shaving Heads (for AT893/AT890/AT753/AT752/ AT750). 1 Switch off the shaver. Disconnect the shaver from the mains or remove it from the charging stand (AT940 only). 2 Press the release button to open the shaving unit. 3 Pull the shaving unit off the shaver. 4 Turn the lock anticlockwise (1) and remove the retaining frame (2). 5 Remove the shaving heads and place new ones
Summary of the content on the page No. 19
English 19 shaving heads - We advise you to replace your shaving heads every year. Always replace with HQ9 Philips Shaving Heads (for AT940) or HQ8 Philips Shaving Heads (for AT893/AT890/AT753/AT752/ AT750). Cleaning - Use Cleaning spray (HQ110) to clean the shaving heads thoroughly. Environment - Do not throw away the appliance with the normal household waste at the end of their life, but hand them in at an official collection point for recycling. By doing this, you help to preserve th
Summary of the content on the page No. 20
20 English 1 Disconnect the shaver from the mains or remove it from the charging stand (AT940 only). 2 Let the shaver run until it stops. 3 Undo the screws in the back of the shaver and in the hair chamber. 4 Remove the front panel and the back panel. 5 Bend the 6 hooks aside and take out the power unit. Be careful, the hooks are sharp. 6 Remove the battery. Be careful, the battery strips are sharp. Do not connect the shaver to the mains again or put it back into the plugged-in
