Alvin Parallel Straightedge 1101 user manual

Summary of the content on the page No. 1

Parallel Straightedge Assembly Instructions
For Models 1101 and 2201
Parts List
Front Wire Connectors (2)
Straightedge with Wire and Spring (1)
wire
Left Rear Right Rear Rear Pulleys Rear Brake 1/2" Brake 3/4" 5/8" 3/8"
Wire Connector Wire Connector Knob Stud Screw Screws* Screws* Washers
(2)
(1) (1) (1) (1) (6) (2) (2)
*NOTE: Only six screws total are required for installation. We have included
1
Tools Required: Phillips screwdriver and ⁄16" drill or awl
two extra screws to acc

Summary of the content on the page No. 2

4. Mark screw positions for front and rear Figure 2 Figure 3 connectors and pre-drill pilot holes about ¼" deep Front connector 1 using a ⁄16" drill bit. TIP: Wrap masking ¾ " Screw tape ¼" from drill tip to set drilling depth. Rear Brake Use care not to drill through tabletop. Knob 3 ⁄8" 5. Fasten front connectors to front edge of board Washer ¾ " Screw* as shown in Figure 2 using ¾" screws. Fasten ¾ " screws half way. Do not fully tighten. Screw Pulley 6. Assemble right r

Summary of the content on the page No. 3

ADJUSTMENTS To Adjust Parallel Position: 1. Be sure all three brake knobs are free and loose. (See Figure 5 on previous page for brake locations.) 2. Grasp one end of straightedge and hold firmly against drawing board. 3. Gently pivot other end of straightedge up or down until desired parallel position is reached. 4. Secure wire under thumbscrew brake in upper right corner to maintain parallel. To Lock Straightedge In Place: 1. With straightedge in desired position, gently tighten both left an

Summary of the content on the page No. 4

ALVIN Replacement Parts #HD4 Straightedge Hardware Kit for Models 1101, 1102, and 2201 Contains: 2 Front wire connectors 2 Rear pulley assemblies 3 5 8 Screws (6x ⁄ " and 2x ⁄ ") 4 8 Wire not included and must be ordered separately. #PEP-2 #KN3 Straightedge Rewiring Kit for Replacement Brake Knobs for Models 1101, 1102, and 2201 Models 1101, 1102, and 2201 Contains: 1 Spring 2 Eyelets Contains: 2 Front wire connectors 3 Thumbscrew brake knobs 30 Feet of wire to string straightedges from 2