Vision Fitness E3600iNetTV user manual

Summary of the content on the page No. 1

Assembly
Guide
E3600iNetTV
COMMERCIAL FITNESS BIKE

Summary of the content on the page No. 2

Assembly Guide E3600iNetTV COMMERCIAL FITNESS BIKE To avoid possible damage to this Fitness Bike, please follow these assembly steps in the correct order. Before proceeding, find your new Fitness Bike’s serial number located on the front axle tube, and enter here: Refer to this number when calling for service, and enter this serial number on your Warranty Card and in your own records. Be sure to read your Owner’s Guide before using your new Fitness Bike. If any parts, hardware or tools are missi

Summary of the content on the page No. 3

TOOLS & PARTS INCLUDED MM Screwdriver 15 Pedal Wrench MM 5 Allen Wrench PARTS BOX Console Mast Cover, Qty: 1 Water Bottle & Cage, Qty: 1 CONSOLE BOX Heart Rate Chest Strap, Qty: 1 Color-coded Hardware Bags iNetTV Console Assembly Guide Owner’s Guide Warranty Card

Summary of the content on the page No. 4

HARDWARE INCLUDED ORANGE BAG PINK BAG M8 x 65L Screw M8 x 20L Screw Quantity: 2 Quantity: 2 M8 Lock Washer M8 x 20L Screw Quantity: 4 M8 Lock Washer Quantity: 2 Quantity: 2 BLUE BAG M8 Lock Washer M8 x 15L Screw Quantity: 6 Quantity: 7

Summary of the content on the page No. 5

STEP 1 ORANGE BAG • Install the rear foot with the four lock washers (M8), two inside screws (M8x65L), and two outside screws STEP 1 MM (M8x20L). Tighten with the 5 Allen wrench. 5

Summary of the content on the page No. 6

STEP 2 BLUE BAG STEP 2 • Slide the rubber boot onto the console mast. • Locate the bundle of wires that comes from the bracket on top of the bike frame. Wrap these wires with the wire tie coming from the bottom of the console mast. Pull the wire tie and bundle of wires up through the top of the console mast while simultaneously sliding the mast into the frame bracket. • Secure the console mast to the frame bracket with six lock washers (M8) and six screws (M8x15L). MM Tighten with the 5 Allen

Summary of the content on the page No. 7

STEP 3 PINK BAG • Feed the heart rate wires from the handlebars through the small hole located in the front of the console STEP 3 mast. Pull these wires up through the hole at the top of the console mast. Attach the handlebar to the console mast using two lock washers (M8) and two screws (M8x20L). Tighten MM with the 5 Allen wrench. 7

Summary of the content on the page No. 8

STEP 4 CONSOLE • Remove the six mounting screws from the back of the console with the Phillips screwdriver. Set the console in place and secure it to the console mast with the screws you just STEP 4 removed. Connect all the wires to the proper locations in the back of the console (see diagram). • With the Phillips screwdriver remove the two screws located half way up the console mast. Attach the water bottle bracket to the console mast with the two screws. Insert the water bottle. 1 - Co-Axial C