Summary of the content on the page No. 1
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
STANDARD SERIES
36" B-VENTED GAS APPLIANCES
P/N 725,008M REV. F 05/2004
MODELS
Millivolt Models Electronic Models
B-40RMN B-40REN
B-40RMP B-40REP
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE
WH Report No. J20006722
LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE POUR
RÉDUIRE AU MINIMUM LE RISQUE D'INCENDIE OU
POUR ÉVITER TOUT DOMMAGE MATÉRIEL, TOUTE
BLESSURE OU LA MORT.
WARNING: IF THE INFORMATION IN THIS MANUA
Summary of the content on the page No. 2
S'assurer que le brùleur et le compartiment CONGRATULATIONS! des commandes sont propres. Voir les in- structions d'installation et d'utilisation qui In selecting this SUPERIOR B-vented gas appliance you have chosen the finest and most accompagnent l'apareil. dependable fireplace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fireplace. Welcome to a Family of tens of thousands of satisfied SUPERIOR Provide adequate clearances around air open- Fireplace Owners. in
Summary of the content on the page No. 3
Millivolt appliances may be fitted at time of Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to manufacture with either a Honeywell millivolt Gas Controls the flu with headaches, dizziness and/or nau- gas control valve or as SIT millivolt gas control on Valve valve. Both valves have been tested with and sea. If you have these signs, obtain fresh air immediately. Turn off the gas supply to the approved for use with these appliances and appliance and have it servi
Summary of the content on the page No. 4
T O O O L I P N IGNITER OFF ON CONTROL O T N WARNING: FIREPLACES EQUIPPED WITH OPTIONAL ACCESSORY DOORS SHOULD BE OPERATED ONLY WITH THE DOORS FULLY OPEN OR FULLY CLOSED (FIGURE 4 ). THIS APPLI- IN OUT ANCE MAY ONLY BE FITTED WITH DOORS CERTIFIED FOR USE WITH SIT Millivolt Valve Gas Control Knob THE APPLIANCE. Spark Ignitor AVERTISSEMENT: POUR UTILISATION Spark Ignitor Gas Control Knob UNIQUEMENT AVEC LES PORTES EN VERRE CERTIFIÊES AVEC L'APPAREIL. Honeywell Millivolt Valve Figure 2 4. Always t
Summary of the content on the page No. 5
Combustion Air Actuator Manual Remove Locking Screw Reset and “Pop” Actuator to the Limit Left Before Initial Use Limit Switch Switch Bracket Lintel Extension Bracket Screw Pull Forward to Open, Push Back to Close Figure 7 Figure 6 MANUALLY-RESET BLOCKED FLUE SAFETY If your screw is not removed and you have Maintenance SWITCH reason to believe that you have a complete outside combustion system, contact your dis- The appliance and venting system should be This appliance is equipped with a manuall
Summary of the content on the page No. 6
Millivolt Appliance Checkout The pilot flame should be steady, not lifting or floating. Flame should be blue in color with traces of orange at the outer edge. The top ³⁄₈" (9 mm) at the pilot generator (ther- mopile) should be engulfed in the pilot flame. The flame should project 1" (25 mm) beyond the hood at all three ports (Figure 8 ). Electronic Appliance Checkout Light the burner, refer to the Lightilng Instruc- tions in this manual. Ensure the ignitor lights the pilot. The pilot flame sho
Summary of the content on the page No. 7
Maintenance Schedule Annually (Before the onset of the Burning Season) Maintenance Task Accomplishing Person Procedure Inspecting/Cleaning Burner, Logs Qualified Service Technician Inspect valve and ensure it is properly operat- and Controls ing. Check piping for leaks. Vacuum the control compartment, fireplace logs and burner area. Check Flame Patterns and Flame Height Qualified Service Technician Refer to Figure 9 and verify the flame pattern and height displayed by the appliance con- forms
Summary of the content on the page No. 8
* TH TH TP TP WIRING DIAGRAMS Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics found on pullout labels attached to the gas valve located within the control compartment. Two Millivolt wiring diagrams are provided here, one each for both Honeywell and SIT equipped systems. Honeywell Millivolt Wiring Diagram Electronic Wiring Diagram (Honeywell) SIT Millivolt Wiring Diagram If any of the original wire as supplied must be replaced, (Opt
Summary of the content on the page No. 9
NOTES: NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 9
Summary of the content on the page No. 10
I O T O O L O I P L I T P O N it TPTH TP TH L O I P F L F O LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo • Do not use any phone in your building. ignitor. When lighting the pilot, follow these instructions • Immediately call your gas
Summary of the content on the page No. 11
I O T O O L O I L P I T P N O it TPTH TP TH L O I P F L F O INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Cet appareil est muni d’une veilleuse qui doit être allumée avec un • Appelez immédiatement votre compagnie
Summary of the content on the page No. 12
IGNITER OFF ON CONTROL LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions • Immediately call your gas supplier from a neighbor’s exactly. phone. • If your gas supplier cannot be reached, call the fire B. BEFORE OPERATING smell all around the appliance area department. for g
Summary of the content on the page No. 13
IGNITER OFF ON CONTROL INSTRUCTIONS D’ALLUMAGE — ELECTRONIC POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT: SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Lorsque vous allumez l’appareil, suivez exactement ces instruc- • Appelez immédiatement votre compagnie de gaz en utilisant tions. le téléphone du voisin. • S’il vous est
Summary of the content on the page No. 14
TROUBLESHOOTING THE MILLIVOLT GAS CONTROL SYSTEM Note: Before troubleshooting the gas control system, be sure external gas shut off valve (located at gas supply inlet) is in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1. Spark ignitor will not light A. Defective ignitor Check for spark at electrode and pilot; if no spark and pilot after repeated (no spark at electrode). electro
Summary of the content on the page No. 15
TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM Note: Before troubleshooting, be sure that the appliance main line gas shut-off valve, the gas control valve and the wall switch are in the “ON” position. Important: Valve system troubleshooting should only be accomplished by a qualified service technician. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1. Burner will not light. A. Faulty Valve System. See Below. B. Faulty limit switch. Reset the limit switch button. If still not working, remove wire nut
Summary of the content on the page No. 16
REPLACEMENT PARTS LIST Natural Propane No. DESCRIPTION Part No. Qty. Part No. Qty. Gas Fireplace Assembly –– – – 1. Firescreen 161116 2 161116 2 2. Rod, Screen 498169 2 498169 2 3. Front Log LB-97316A 1 LB-97316A 1 4. Rear Log LB-97317A 1 LB-97317A 1 5. Burner 75L1101 1 75L1101 1 6. Log Grate LB-97307 1 LB-97307 1 7. Burner Orifice 21L8201 1 75L1001 1 8. Limit Switch 75L2301 1 75L2301 1 GAS CONTROLS — MILLIVOLT Natural Propane No. DESCRIPTION Part No. Qty. Part No. Qty. *10. Gas Valve - SIT H165
Summary of the content on the page No. 17
REPLACEMENT PARTS 4 2 7 3 1 5 6 10 8 11 16 15 20 21 14 13 22 12 23 17 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 17
Summary of the content on the page No. 18
ACCESSORY COMPONENTS Remote Control System (Standard) H0249 RCL 86L26 36 ABF Twin Pane Doors 86L29 36 TPA-BB Standard Remote Control System 86L27 36 ABF-BB (Model RCL) 86L28 36 ABF-BS Twin Pane Doors 12M01 36BF Bi-Fold Doors 12M02 36BF-BB The Model RCL (Standard) Remote Control Your fireplace can be fitted with beautiful twin System, features a simplistic on/off control pane doors. Model TPA doors are available for Bi-Fold Doors function for the fireplace. This model includes use with these f
Summary of the content on the page No. 19
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 19
Summary of the content on the page No. 20
The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2001 by Lennox Hearth Products LHP P/N 725,008M REV. F 05/2004 1110 West Taft Avenue • Orange, CA 92865 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 20
