Summary of the content on the page No. 1
LAWN SWEEPER
Model LS340
Starting Serial No. 1001
Owner/Operator's Manual
& Illustrated Parts List
CAUTION
Avoid injuries. Read and understand Operator’s manual
before operating tractor or equipment.
It contains instructions for safe operation.
Form # 09-164
Summary of the content on the page No. 2
CAUTION • READ AND UNDERSTAND OPERATORS MANUAL BEFORE OPERATING OR SERVICING. OBEY ALL SAFETY INSTRUCTIONS. FAILURE TO DO SO MAY RESULT IN INJURY TO YOU OR OTHERS. BE SURE MACHINE IS IN SAFE OPERATING CONDITION BEFORE USE. INSPECT MACHINE DAILY. REPLACE ALL WORN OR DAMAGED PARTS. KEEP ALL GUARDS AND SHIELDS IN PLACE. CHECK OPERATION OF ALL SAFETY INTERLOCK SWITCHES DAILY. DO NOT OVERRIDE INTERLOCK SYSTEM, IT IS FOR YOUR PROTECTION. DO NOT ALLOW MINORS OR THE INEXPERIENCED TO OPERAT
Summary of the content on the page No. 3
TABLE OF CONTENTS INTRODUCTION SECTION 1 page Description ..........................................2 Specifications.........................................3 SAFETY SECTION 2 General Safety.........................................4 Operator Safety........................................4 OPERATION SECTION 4 Operating Instructions ....................................5 SERVICE SECTION 5 Service Schedule .......................................6 PARTS SECTION 6 Parts List and Illustrations Index ..
Summary of the content on the page No. 4
INTRODUCTION section 1.1 Description The Steiner Lawn Sweeper is designed to give a “clean sweep” in your lawn sweeping operations. The unit is ground-driven so it can be pulled by any lawn and garden tractor. It can be used to trail behind with offset hitch while mowing, or regular hitch to clean-up after you've finished mowing. The packing action allows you to put much more material into the unit before it is necessary to unload. There is a transport position for the sweeper and clutch levers
Summary of the content on the page No. 5
INTRODUCTION section 1.2 Specifications Overall width ______________62" Overall height ______________52" Overall length to hitch___________66" Width of pick up _____________40" Brush _________________3 paddle, staggered Depth wheels ______________ Semi-pneumatic Hitch__________________ Right, left or center pull adjustment Carrying capacity ____________24cu.ft. Weight _________________530lb. 3
Summary of the content on the page No. 6
SAFETY section 2.1 BE ALERT! ATTENTION: This symbol identifies potential health and safety hazards. It marks safety precautions. ATTENTION: Your safety is involved. GENERAL SAFETY 4. Do not leave equipment unattended. STOP 1. Read and understand the owner's manual, the engine and remove the key. before attempting to operate this machine. 5. Do not allow minors or the inexperienced to 2. Operate all controls from the operator's operate this machine. seat. NO RIDERS. 6. Keep people and pets a safe
Summary of the content on the page No. 7
OPERATION section 4.1 Operating Instructions › 1. Determine hitch position for offset or straight pull position. › 2. Transport to clean-up site with the clutches disengaged and sweeper in transport position. › 3. Lower the sweeper housing and adjust sweeper height on right side of sweeper housing by choosing the pin location to regulate gauge wheel height. NOTE: Operation is best when the sweeper is approximately 1/2" below the tips of the grass, but does not “scrub” the lawn. › 4. Adjust the f
Summary of the content on the page No. 8
SERVICE Section 5.1 Maintenance Daily Visually check chain drive - it should not run “dry”. Lube with chain lube or 30W oil Weekly or 50 Hours Grease all bearings and wheels. Check tire pressure (12 lbs.) rev 6/00 6 09-164
Summary of the content on the page No. 9
PARTS Section 6.1 Parts Index GROUP FIGURE PAGE Main Parts................. Fig. 1.......................8 Brush Parts................ Fig. 2.......................10 7
Summary of the content on the page No. 10
PARTS section 6.2 Main Parts Figure 1 rev 6/00 8 09-164
Summary of the content on the page No. 11
PARTS section 6.3 Parts List for Figure 1 Ref Part no. Description Quantity 1 62-602 Main Frame 1 2 60-187 Door 1 3 42-205 Hinge Rod 1 4 02-CP0406 Cotter Pin, 1/8 x 3/4 2 5 41-010 Spring, 5" 2 6 40-114 Latch, Right 1 40-115 Latch, Left 1 7 83-407016 Sprocket 1 8 41-013 Spring 2 9 86-020 Clutch Pawl, Right 1 86-021 Clutch Pawl, Left 1 10 85-K0410 Key, 1/4 x 1-1/4 3 11 86-043 Clutch 2 12 50-030 Wheel & Tire Assembly 2 53-089 Tire, 16 x 7.50 x 8, Turfsaver 1 50-101 Rim 1 55-IB-1 Bearing 1 * 29-053
Summary of the content on the page No. 12
PARTS section 6.4 Brush Parts Figure 2 rev 6/00 10 09-164
Summary of the content on the page No. 13
PARTS section 6.5 Parts List for Figure 2 Ref Part no. Description Quantity 1 62-385 Housing, Brush 1 2 92-08 Nut, 1/2 3 3 92-06 Nut, 3/8 8 4 42-209 Adjuster, Spring Tension 2 5 41-010 Spring, 5" 3 6 95-10 Flat Washer, 5/8 SAE 12 7 53-104 Wheel, 10.25 x 3.25 Caster (Serial No. 1001 - 1559) 2 55-G527 Ball Bearing for 53-104 2 55-107 Bearing, 5/8 ID x 1-3/8 OD (Optional, Heavy Duty) 2 53-186 Wheel, 10.25 x 3.25 Caster (Serial No. 1560 - ) 2 55-112 Bearing, Roller 5/8 ID X 1-3/8 1 53-187 Retainer,
Summary of the content on the page No. 14
