Summary of the content on the page No. 1
SIERRA UV36OFP
OUTDOOR GAS
FIREPLACE
INSTALLATION AND OPERATING INSTRUCTIONS
WARNING: If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury, or loss of life.
- Do not store gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
C Do not try to light any appliance.
C Do not touch any electrical switch; do not use any phone
in your building.
Summary of the content on the page No. 2
SAFETY INFORMATION 11. Do not use this fireplace to cook food or burn paper Appliance for Use with Propane Gas: Propane gas has no odor. An odor-making agent is added to the gas. The or other objects. odor aids you in detecting a gas leak. However, the odor added to the gas can fade. Gas may be present even 12. Never place any objects in the fireplace or on logs. though no odor exists. Use only propane gas. Do not convert the fireplace to use 13. Fireplace front and screen become very hot when d
Summary of the content on the page No. 3
for area separation and can also be ideal as an addition to Installation and repair should be done by a qualified an existing wall. service person. The appliance should be inspected before use and at least annually by a professional IMPORTANT: Make sure the fireplace is level. If the service person. More frequent cleaning may be fireplace is not level moisture may collect in areas causing required due to excessive lint from carpeting, corrosion. bedding material, etc. It is imperative that contr
Summary of the content on the page No. 4
Figure 3 - Projection Clearance FIG. 6 - Optional Remote (MV only) OPTIONAL REMOTE CONTROL UNIT Note: Be sure to read the instructions included with remote control unit prior to installing. 1. Install the remote control unit into remote control bracket and using (2)#8 Phillips screws. Be sure that the word "TOP" is on the left-hand side of the unit. Tighten screws to a point where 2-3 threads are visible from the rear of the bracket. This will allow enough clearance for the remote cover to slide
Summary of the content on the page No. 5
BUILT-IN FIREPLACE INSTALLATION Built-in installation of this fireplace involves installing a fireplace into a framed-in enclosure. This makes the front of the fireplace flush with the wall. Best outdoor enclosure construction includes metal stud with tile or concrete board as an overlay. Additions of ceramic tile and acrylic stucco finishes provide good service. To install the fireplace in this manner, use the following instructions: Figure 10 - Rough opening for Framing Installing in Corner 1.
Summary of the content on the page No. 6
C external regulator LP gas only (supplied by installer) C piping (check local codes) C sealant (resistant to propane gas) C manual shutoff valve* C test gauge connection* C sediment trap C tee joint C pipe wrench C approved flexible gas line with gas connector (if allowed by local codes) (not provided) * An CSA design-certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional CSA design-certified manual shutoff valve from your
Summary of the content on the page No. 7
1. Disconnect the fireplace and its individual manual shutoff valve from gas supply piping system. Pressures in excess of ½ psig will damage the fireplace gas regulator. 2. Cap off the open end of gas pipe where manual shutoff valve was connected. 3. Pressurize supply piping system by either using compressed air or opening main gas valve located on or near gas meter. 4. Check all joints of gas supply piping system. Apply a mixture of liquid soap and water to gas joints. Bubbles forming show a le
Summary of the content on the page No. 8
Figure 18 - Setting logs and lava rock Figure 19 - Control and Ignitor Access burner and pilot burner area for dust or carbon build-up. PLACING LOGS AND LAVA ROCKS This may be removed from the burner or logs with a soft Assemble ceramic logs by placing the large base log to bristle brush. A visual inspection of the pilot burner and the rear of grate assembly (Figure 18). Add front logs main burner flame should be performed to verify proper with “burned through” features to front left and right.
Summary of the content on the page No. 9
OPERATING INSTRUCTIONS FOR MANUAL SAFETY VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. When lighting pilot follow these instructions exactly. B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle o
Summary of the content on the page No. 10
Item Qty Description P/N Item Qty Description P/N 1 1 Outer Surround 202181 11 1 Venturi w/ gasket 110299 2 1 Firebox 202183 12 1 Fireplace Hood SS 200740 3 1 SS Optional Trim (top piece) 200760 13 1 Access Door SS 202185 4 1 SS Optional Trim (left hand) 200761 14 2 Fireplace Screen 110388 5 1 SS Optional (right hand) 200762 15 2 Fireplace Screen Rod 200746 6 1 Refractory Left Side 200749 16 1 Remote Control - (MV Assy) 10649 7 1 Refractory Right Side 200753 17a 1 Natural Gas Control Assy. 30051
Summary of the content on the page No. 11
SIERRA OUTDOOR GAS FIREPLACE LIMITED THREE & ONE, YEAR LIMITED WARRANTY Sierra Products, Inc. (SPI), warrants to the original consumer this stove will be free of defective materials and workmanship for the following periods: Outer structure - Outer Structure, Interior metal construction - Three Years, All other items - One Year from the date of purchase. This warranty does not extend to any parts worn or damaged through normal ware, abuse, accident, or neglect or warpage due to over-firing; no
