Summary of the content on the page No. 1
FOR YOUR SAFETY
If you smell gas:
1. Open windows.
®
2. DO NOT try to light any appliance.
3. DO NOT use electrical switches.
4. DO NOT use any telephone in
your building.
Blackheat HE
5. Extinguish any open flame.
6. Leave the building.
7. Immediately call your local gas
supplier after leaving the building.
Vacuum Assisted
Follow the gas supplier’s
instructions.
8. If you cannot reach your gas Linear, Double Linear,
supplier, call the Fire Department.
U-Tube, and Multi-Bur
Summary of the content on the page No. 2
Summary of the content on the page No. 3
TABLE OF CONTENTS SECTION 1: Heater Safety............................................2 10.5 Sports Hall Guard Installation.........................46 1.1 Manpower Requirements ....................................2 10.6 Undershield Installation ..................................47 1.2 IP55 Protection....................................................2 10.7 Wall Mounting.................................................48 1.3 Safety Labels and Their Placement ....................2 SECTION 11: Ven
Summary of the content on the page No. 4
Summary of the content on the page No. 5
TABLE OF FIGURES Figure 1: Bottom and Back Panel Label Placement ........2 Figure 2: Control Side Label Placement..........................3 Figure 3: Linear & Double Linear, Horizontal Mounts......6 Figure 4: Linear & Double Linear, One Side Reflector ....6 Figure 5: Linear & Double Linear, Two Side Reflectors ...6 Figure 6: Linear & Double Linear, 45° Mount ..................6 Figure 7: Linear & Double Linear, 2 Foot Deco Grille, Protective Grille .............................................
Summary of the content on the page No. 6
Summary of the content on the page No. 7
Product Approval
!
"#
$
%& !'
%
(
#
#
&) !
%
!# * #
#
+ * $
#, -
Summary of the content on the page No. 8
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL SECTION 1: HEATER SAFETY 1.1 Manpower Requirements Your Safety is Important to Us! To prevent personal injury and damage to the heater, two persons will be required for installation. This symbol is used throughout the manual to notify you of possible fire, electrical or burn 1.2 IP55 Protection hazards. Please pay special attention when The burner is certified to protection class of IP55. This reading and following the warnings in the
Summary of the content on the page No. 9
SECTION 1: HEATER SAFETY Figure 2: Control Side Label Placement Description Part Number Logo Label 91033200 Wiring Diagram Label 91031404 3 of 73
Summary of the content on the page No. 10
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL SECTION 2: INSTALLER RESPONSIBILITY 2.2 Corrosive Chemicals • To install the heater, as well as the gas and electrical CAUTION supplies, in accordance with applicable specifications and codes. Roberts-Gordon LLC recommends the installer contact a local Building Inspector or Fire Marshal for guidance. • To use the information given in a layout drawing and in the manual together with the cited codes and regulations to perform the insta
Summary of the content on the page No. 11
SECTION 3: CLEARANCES TO COMBUSTIBLES • Consult local Building Inspector, Fire Insurance SECTION 3: CLEARANCES TO COMBUSTIBLES Carrier or other authorities for approval of proposed installation when there is a possibility of exposure to WARNING combustible airborne materials or vapours. • Hang heater in accordance to the minimum suspension requirements on Page 11, Section 5. Fire Hazard Keep all flammable objects, liquids and vapors the minimum required clearances to combustibles away from
Summary of the content on the page No. 12
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL 3.2 Clearances Data - Linear and Double Linear NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. FIGURE 3: LINEAR & DOUBLE LINEAR, HORIZONTAL MOUNTS A 150 150 150 150 150 150 200 200 B 890 970 970 1020 1170 1220 1280 1330 C 1570 1650 1650 1780 1930 1970 201
Summary of the content on the page No. 13
SECTION 3: CLEARANCES TO COMBUSTIBLES NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. FIGURE 7: LINEAR & DOUBLE LINEAR, 2 FOOT DECO GRILLE, PROTECTIVE GRILLE A 150 150 150 150 150 150 200 200 B 890 970 970 1020 1170 1220 1280 1330 C 1570 1650 1650 1780 1930 1970 2010 2080 D 890 970 970 1020 1170 1220 12
Summary of the content on the page No. 14
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL 3.3 Clearances Data - U-Tube NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. 4. Add 60 mm clearance to uncovered u-tube. . FIGURE 10: U-TUBE, HORIZONTAL MOUNT $ A 150 150 150 150 150 150 200 200 B 890 970 970 1020 1170 1220 1270 1380 C 1580 1730 173
Summary of the content on the page No. 15
SECTION 3: CLEARANCES TO COMBUSTIBLES NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, tees, elbows and crosses. 2. Clearances B, C and D can be reduced by 50% after 7500 mm of tubing downstream from the burner. 3. All measurements are in millimeters. 4. Add 60 mm clearance to uncovered u-tube. FIGURE 14: U-TUBE, OPPOSITE 45° TILT $ A 200 200 200 250 250 275 300 300 B 1370 1530 1530 1630 1780 1830 1880 1930 C 1500 1650 1650 1860 1960 2040 2110 2160 D 560 560 560 560 5
Summary of the content on the page No. 16
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL SECTION 4: MAJOR COMPONENT DESCRIPTIONS Burner (shown with Tube Reflector Gasket) (Aluminium or Must be installed with the Stainless Steel) flame observation window Alternate overlap as facing down. shown on overview. Minimum overlap is 160 mm. Burner Tube Fan Tube with Internal Swirler Tube Supplied in 3000 mm lengths. Supplied in 3000 mm lengths. Fan Heat treated aluminised tube Burner tube is always the first tube is always the
Summary of the content on the page No. 17
SECTION 5: GENERAL SUSPENSION DETAILS SECTION 5: GENERAL SUSPENSION DETAILS WARNING Severe Injury Hazard Secure burner to burner tube with bolts and lockwashers. Hang heater with materials with a minimum working load of 75 lbs (33 kg). Failure to follow these instructions can result in death, injury or property damage. WARNING Cut/Pinch Hazard Wear protective gear during installation, operation and service. Edges are sharp. Failure to follow these instructions can result in injury. To ensur
Summary of the content on the page No. 18
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL Figure 17: Critical Hanger Placement % !
,
#$
"
! "
#$ )$$ + ! *$$ !
%! &!
' !
(
-./
#$$ 0 Description Part Number Burner Tube 03051100 S-hook 91907302 Spring Hook 91903300 Bow Sh
Summary of the content on the page No. 19
SECTION 6: LINEAR & DOUBLE LINEAR HEATER INSTALLATION SECTION 6: LINEAR & DOUBLE LINEAR HEATER INSTALLATION The figures in this section provide a general overview of component placement in a Linear and Double Linear WARNING system. The location of some components such as supports and couplings is crucial for proper installation. Assemble the heater components as shown on Page 14, Figure 18. For optional reflector configurations for linear heaters see Page 6, Figure 3 through Page 7, Figur
Summary of the content on the page No. 20
® BLACKHEAT HE INSTALLATION OPERATION AND SERVICE MANUAL Figure 18: Linear General Assembly Overview 14 of 73
$ '
# # #
)
/
## #
3
# #2
# +-
# 6
! 2
$ 4 , 3
. 4 5&
!
!
$ ,"# (##. #6)78
*
