Summary of the content on the page No. 1
TM
OWNER’S MANUAL
Read and understand this entire manual before riding!
Item Number:
Español .............Página 14
Bistro 15130640
Bella 15130662
Français ............Page 29
Betty 15130661
Summary of the content on the page No. 2
CONTENTS Safety Warnings ............................................................ 1 Troubleshooting Guide ................................................ 7-8 Before You Begin ........................................................... 2 Pocket Mod Parts ..................................................... 9-10 Assembly and Set-Up .................................................... 3 Safety Reminders ........................................................ 12 Repair and Maintenance ...
Summary of the content on the page No. 3
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during WARNING: shipping. Because the Pocket Mod was 95 percent assembled and packed at the factory, there should not be any DO NOT USE NON-RAZOR problems, even if the box has a few scars or dents. PRODUCTS WITH YOUR RAZOR POCKET MOD. The Pocket Mod ha
Summary of the content on the page No. 4
ASSEMBLY AND SET-UP Charging the Battery WARNING: Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use. Rechargeable batteries are only to • Initial charge time: 12 hours • Run time: up to 40 minutes be charged under adult supervision. • Recharge time: up to 8 hours • Average battery life: 250 charge/discharge cycles Always disconnect your Pocket Mod depending on the level of depletion from the charger before clea
Summary of the content on the page No. 5
ASSEMBLY AND SET-UP Testing the Brakes WARNING: The brake To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fitted with a cable adjuster is capable of skidding the tire and to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not engaging throwing an unsuspecting rider. properly, follow instructions for adjusting the brakes outlined on the next page. Practice in an open area free from obst
Summary of the content on the page No. 6
REPAIR AND MAINTENANCE ❑ Chain and Rear Tire Replacement Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches. 1 With a Phillips screwdriver, 2 With a 10mm wrench, loosen 3 With two 8mm wrenches, remove the screws that secure the loosen brake housing anchor and the brake cable anchor and chainguard. Remove chainguard. disconnect the cable. disconnect. Keep the spacer and washers together. 5 Pull the wheel out. Note the 6 Install the new ch
Summary of the content on the page No. 7
REPAIR AND MAINTENANCE ❑ Replacing the Fuse WARNING: To prevent shock or short circuit, please follow the instructions accordingly and do not skip or combine any steps. 1 Make sure the power switch is 2 lift up the seat and unscrew the 3 Remove seat/storage turned off. four corner screws in storage compartment. compartment. Amperage number 4 Locate fuse cover on 5 Remove the fuse and replace 6 Close the fuse cover. Replace top of battery assembly. Open the with a new one of e
Summary of the content on the page No. 8
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Vehicle does not run Undercharged battery Charge the battery. A new battery should have been charged for at least 12 hours before using the vehicle for the first time and up to 8 hours after each subsequent use. Check all connections. Make sure the charger port is tightly plugged into the charging port on the Pocket Mod, and that the charger is plugged into the wall. Make sure power flow to the wall outlet is on. Charger is not working You
Summary of the content on the page No. 9
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Check all wires around the motors and all connectors to make sure they are Sometimes the vehicle Loose wires or connectors doesn’t run, but other times tight. it does Motor or electrical switch damage Contact your local Razor authorized service center for diagnosis and repair. Charger gets warm during Normal response to charger use No action required. This is normal for some chargers and is no cause for concern. If your charger does not ge
Summary of the content on the page No. 10
POCKET MOD PARTS Keep your Pocket Mod running for years with genuine Razor parts. Visit our web site or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 43. Chain for Pocket Mod 1. Screw, self-threading for faux head lamp cover 2. Faux head lamp cover 44. Rear sprocket for Pocket Mod 45. Chain guide for rear sprocket, inside 3. fairing, front 46. Spacer 4. Grip, left side 5. Brake lever, left side w cut-off switch 47. Rear wheel assemb
Summary of the content on the page No. 11
POCKET MOD PARTS 10
Summary of the content on the page No. 12
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC VEHICLE. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 11
Summary of the content on the page No. 13
SAFETY REMINDERS PRE-RIDE CHECKLIST Loose Parts Tire Inflation Check and secure all fasteners before every ride. Make sure Periodically inspect the tires for excess wear, and regularly check ❑ ❑ steering stem clamp bolts are locked properly in place. There the tire pressure and re-inflate as necessary. If you get a flat tire, should not be any unusual rattles or sounds from loose parts the inner tube can be patched or a new tube can be purchased or broken components. If you are not sure, ask a
Summary of the content on the page No. 14
