Summary of the content on the page No. 1
OUTDOOR GAS
FIREPLACE
OWNER’S OPERATION AND INSTALLATION MANUAL
AL500HYLA
50,000 BTU/Hr
Manually Controlled
IMPORTANT: Read this
WARNING: If the information in this manual is
owner's manual carefully and
not followed exactly, a fire or explosion may result
completely before trying to
causing property damage, personal injury, or loss
assemble, operate, or service
of life.
this heater.
FOR YOUR SAFETY:
Do not store or use gasoline or other flammable
WARNI
Summary of the content on the page No. 2
SAFETY INFORMATION PRODUCT IDENTIFICATION 1. Check the heater completely and thoroughly for damage. DO NOT run a damaged heater. 2. DO NOT alter the heater or operate a heater that has been modified from its original condition. 3. Use only propane gas. 4. Use only vapor withdrawal propane gas. If any question, contact your LP dealer. 5. Do not use this heater as a wood-burning heater. Use only the logs provided with the heater. 6. Inspect hose assembly before each
Summary of the content on the page No. 3
PRODUCT FEATURES Caution: Some of the steel edges may SAFETY PILOT be sharp. Please use caution when The heater has a pilot with a safety shutoff system. assembling the unit. The safety pilot is a required feature for outdoor heaters. It shuts off the heater if flame is extinguished INSTALLATION INSTRUCTIONS: by rough wind. 1. Remove grate out of base and set flat on floor. 2. Take log foam package out of base. Please note PIEZO IGNITION SYSTEM This heater has a piezo igniter. This sy
Summary of the content on the page No. 4
INSTALLATION INSTRUCTIONS 7. Attach the four columns to the burner plate with Continued M4 10 screws provided. Do not tighten at this time. (See FIG.7) 5. Install logs 1,2,3,4,5 by inserting each log screw into holes of corresponding grate branch . Make sure each log is placed in proper sequence.(See FIG 5.) Note: If the log is too loose or the screw can’t be pulled down after inserting the log screw, screw the nuts to adjust the clearance between nuts and logs.
Summary of the content on the page No. 5
8. Set the top panel in place on the columns and 12. From the outer side, use M5 10 screws to secure with M4 10 screws provided. Do not fasten the fixing hoop on the right and left support. Fasten the other side of the fixing hoop after the tighten at this time. (See FIG.8) cylinder is in place. (See FIG.11) Figure 11-The fixing hoop installation Figure 8-Top panel installation CONNECTING TO GAS SUPPLY 9. Attach the screens to columns with M4 10 Note: The installer must supply a
Summary of the content on the page No. 6
CONNECTING TO GAS SUPPLY OPERATING HEATER Continued Continued TO TURN OFF HEATER: FUEL REQUIREMENTS: 1. Turn gas control knob to the “OFF” position. Connect regulator/hose with standard 20-pound 2. If heater is not to be used, shut off cylinder valve. LP cylinder coupler. 3. Do not attempt to relight heater within 5 minutes Call the LP gas supplier to inspect the cylinder. after the propane cylinder valve has been closed. Do not use a damaged LP gas cylinder. RESTART
Summary of the content on the page No. 7
PILOT AND BURNER: MAINTENANCE AND STORAGE Clean dust with a vacuum cleaner. Continued 11. Spiders and insects can nest and live in outdoor BURNER AIR INLET HOLE: appliances, especially in the burners and orifices. We recommend that you clean the unit every three This will interrupt the normal flow of LP gas to the months or after 2500 hours operation. We also heater and can be a very dangerous situation. recommend that you keep the burner tube and pilot Inspect for insect infiltration o
Summary of the content on the page No. 8
PARTS NOT UNDER WARRANTY: SERVICE INDICATIONS: A hazardous condition may result if a heater has Contact authorized dealers of this product or Parts Central if been modified or is not functioning properly. When they can't supply original replacement part(s) Call PRO-COM's the heater is working properly: Parts Department at 1-877-886-5989 for referral information. 1. The flame is contained within the heater. When calling PRO-COM, have ready 2. The flame is essentially yellow. Mod
Summary of the content on the page No. 9
PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 7 of this manual. HP500MA KEY PART DESCRIPTION QTY. NO. NUMBER AB01001 Top Panel 1 1 2 AB29001 Mesh Screen 2 3 Mesh Screen 2 AB29002 4 AL002-01 Column 6 Burner Fixing Plate 6 5 AL009-01 6 6 AL01002 MID Base 7 Support Part 1 AL033-01 8 AL013-01 Support 1 AL011-01 Door 2 9 AB01004 Base 1 10 AB0100
Summary of the content on the page No. 10
ILLUSTRATED PARTS BREAKDOWN AL500HYLA 10 AL058-01
Summary of the content on the page No. 11
PARTS LIST This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 7 of this manual. HP500MA KEY PART DESCRIPTION QTY. NUMBER NO. 1 1 NBY50-200A1 Burner NDW-L600×4 Safety Pilot 1 2 1 3 AB31002 Safety Pilot Inlet Tube ASM Control Valve 1 4 NV2020-1217 AL031-01 Washer 1 5 6 AB31001 Gas Outlet Tube ASM 1 Control Valve Main Inlet Nut 1 7 AL030-01 8 AL016-01 Control Cabi
Summary of the content on the page No. 12
ILLUSTRATED PARTS BREAKDOWN AL500HYLA 12 AL058-01
Summary of the content on the page No. 13
This list contains replaceable parts used in your heater. When ordering parts, follow the LOGS LIST instructions listed under Replacement Parts on page 7 of this manual. AL500HYLA KEY PART DESCRIPTION QTY. NUMBER NO. 1 1 AL057-01 Log 1 AL057-02 Log 2 1 2 1 3 AL057-03 Log 3 Log 4 1 4 AL057-04 Log 5 1 5 AL057-05 6 AL057-06 Log 6 1 AL057-07 Log 7 1 7 8 AL057-08 Log 8 1 1 9 AL057-09 Log 9 1 10 AL057-10 Log 10 13
Summary of the content on the page No. 14
LOGS LIST AL500HYLA NANJING PRO-COM ELECTRIC APPLIANCE CO.,LTD. #6 CHUANGYE ROAD, HIGH NEW TECH. ZONE, NANJING, 210061, CHINA PRO-COM Toll-Free number: 1-877-886-5989 14 AL058-01
