Summary of the content on the page No. 1
FRANÇAIS
ENGLISH ESPAÑOL
R
Instruction Manual
Manual de Instrucciones
Manuel d’Instructions
PPB2000 LE
IMPORTANT MANUAL -- Do not throw away
MANUAL IMPORTANTE -- No lo descarte
MANUEL IMPORTANT -- À Conserver
WARNING:
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual de instrucciones y siga todas las advertencias e
instrucciones de seguridad. El no hacerlo puede resultar en le-
siones g
Summary of the content on the page No. 2
SAFETYRULES D Mix and pour fuel in an outdoor area; store WARNING: Failure to follow all fuel in a cool, dry, well ventilated place; use Safety Rules and Precautions can result in an approved, marked container for all fuel serious injury. purposes. D Do not smoke while handling fuel or while KNOW YOUR UNIT operating the unit. S Read your instruction manual carefully until D Make sure the unit is properly assembled you completely understand and can follow and in good operating condition. all warn
Summary of the content on the page No. 3
disconnected. Keep vents and discharge SPECIAL NOTICE: Exposure to vibra- tubes free of debris which can accumulate tions through prolonged use of gasoline pow- and restrict proper air flow. ered hand tools could cause blood vessel or D Never place any object in the air intake open- nerve damage in the fingers, hands, and ing as this could restrict proper air flow and joints of people prone to circulation disorders cause damage to the unit. or abnormal swelling. Prolonged use in cold D Never use
Summary of the content on the page No. 4
4. Hold the vacuum inlet cover open until up- NOTE: Make sure edge of the small opening per vacuum tube is installed. is flush against the flared area of the elbow tube, and the rib on the elbow tube is on the bottom. Vacuum Inlet 3. Close the zipper on the bag. Make sure the zipper is closed completely. 4. Remove blower tube from engine. Retaining Post Vacuum Inlet Cover Rib 5. Place the hooks of the upper vacuum tube on the retaining posts of the unit. 6. Pivot the tube until it is secured to
Summary of the content on the page No. 5
SHOULDER STRAP ADJUSTMENT 1. Hold the unit as shown with the muffler side facing away from your body and clothes. 2. Pass the shoulder strap over your head and onto your right shoulder. 3. Extend your left arm toward the rear of the vacuum bag. 4. Adjust shoulder strap until the vacuum bag/shoulder strap seam lies between your thumb and index finger. 5. Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly. OPERATION KNOW YOUR BLOWER READ T
Summary of the content on the page No. 6
This engine is certified to operate on OPERATING POSITION unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil Eye designed to be mixed at a ratio of 40:1. Protection Poulan/Weed Eater! brand synthetic oil is recommended. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3.2 ounces (95 ml) of oil with 1 gallon (4 liters) of unleaded gasoline. DO NOT USE automotive oil or marine oil. These oils will cause
Summary of the content on the page No. 7
STARTING POSITION NOTE: If engine attempts to start before the th 5 pull, go to next step immediately. 5. Move the choke lever to the HALF CHOKE position. 6. Pull the starter rope sharply until the en- gine runs, but no more than 5 pulls (below 30_ F, 10 pulls). 7. After a 5 second warm--up, move the Blower choke lever to the RUN position. 8. Allow the unit to run for 30 more seconds at the RUN position before moving the throttle lever to the position. Vacuum If engine has not started after 5 pu
Summary of the content on the page No. 8
INSPECT AND CLEAN UNIT AND DECALS S After each use, inspect complete unit for loose or damaged parts. Clean the unit and Fuel Line decals using a damp cloth with a mild deter- gent. S Wipe off unit with a clean dry cloth. CLEAN AIR FILTER Fuel Filter Air Filter CHECK MUFFLER MOUNTING Cover SCREWS Once each year, ensure muffler mounting screws are secure and tightened properly to prevent damage. Mounting Screw Holes Muffler Cover Screws Air Filter Screws Cleaning the air filter: A dirty air filte
Summary of the content on the page No. 9
NOTE: Do not attempt to clean the spark ar- NOTE: If any part of the muffler is cracked, resting screen. broken or damaged, we recommend that the muffler be replaced. 1. Loosen and remove the 2 screws from the muffler cover. Remove the muffler cover. CARBURETOR ADJUSTMENTS 2. Loosen and remove both screws from the There is no screw for idle adjustment on your exhaust diverter. blower. The throttle lever is used to control 3. Remove the exhaust diverter and spark engine speed. The throttle lever
Summary of the content on the page No. 10
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not 1. See “Starting a Flooded Engine” 1. Engine flooded. in Operation section. start. 2. Fill tank with correct fuel mixture. 2. Fuel tank empty. 3. Install new spark plug. 3. Spark plug not firing. 4. Check for dirty fuel filter; replace. 4. Fuel not reaching Check for kinked or
Summary of the content on the page No. 11
LIMITED WARRANTY ELECTROLUX HOME PRODUCTS, INC., cover predelivery setup or normal adjustments warrants to the original purchaser that each explained in the instruction manual. new Poulan PRO brand gasoline tool or at- r THIS WARRANTY GIVES YOU SPECIFIC tachment is free from defects in material and LEGAL RIGHTS, AND YOU MAY HAVE workmanship and agrees to repair or replace OTHER RIGHTS WHICH VARY FROM under this warranty any defective gasoline STATE TO STATE. product or attachment as follows from
Summary of the content on the page No. 12
ELECTROLUX HOME PRODUCTS, INC., at cover failures of warranted parts caused by the 1--800--554--6723 WARRANTY PERIOD: Any use of add--on or modified parts. HOW TO FILE warranted part which is not scheduled for re- ACLAIM: If you have any questions regarding placement as required maintenance, or which is your warranty rights and responsibilities, you scheduled only for regular inspection to the ef- should contact your nearest authorized service fect of “repair or replace as necessary” shall be ce
