ParaBody 827102 user manual

Summary of the content on the page No. 1

827102
LAT MACHINE
ASSEMBLY
INSTRUCTIONS
1
12/20/95

Summary of the content on the page No. 2

827102 LAT MACHINE ASSEMBLY INSTRUCTIONS SORT AND COUNT ALL PARTS BEFORE BEGINNING A~SEMBLY HARDWARE: ITEM NAME/DESCRIPTION QTY 3/8 IN WASHER ..................................................................................................................... 3 1/2 IN WASHER ..................................................................................................................... 4 3. 3/8 IN LOCK WASHER ..................................................................................

Summary of the content on the page No. 3

827102 LAT MACHINE ASSEMBLY INSTRUCTIONS NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT. BOLT LENGTH BOLT LENGTH RULER: 1/2 I 1/2 I 1/2 [ 1/2 I 1/2 1 1/2 1 2 3 4 5 6 Insert One (1) 2" END CAP and two (2) 2-1/2" OD END CAPS into the open ends of the BASE. 2. Apply two (2) 2-1/2" X 5-t/2" NON SKID STRIPS to the BASE as shown on drawing, 3. Insert two (2) 2" END CAPS into the open ends of the FRONT UPRIGHT, 4. Insert one (1) 3 X 2" END CAP into front end &the BOOM and slid

Summary of the content on the page No. 4

827102 LAT MACHINE ASSEMBLY INSTRUCTIONS Ill I I I I I Slide four (4) 1 X 8" GRIPS over the ends of the LAT BAR and the LOW ROW BAR. (NOTE: COATING INSIDE OF THE GRIP WITH RUBBING ALCOHOL WILL FACILITATE EASIER INSTALLATION. I Attach eight (8) CARRIAGE GLIDES to the WEIGHT CARRIAGE as shown in (DFTAIL B) using following steps: A. Thoroughly clean all inside surfaces where the CARRIAGE GLIDES are to be attached. Remove the paper backing fi’om the CARRIAGE GLIDES and firmly apply them to the WEI

Summary of the content on the page No. 5

iO-I ,,~130EtVl~fd ’73BV-I (£) AlOe

Summary of the content on the page No. 6

....... REVISIONS . I -~ SEE D-~TAIL A .4 WLDMT. CARRIAGE F CARRIAGE :~I’OP 1-1/4- IN SO RUBBER BUMPER SNAPHOOK LAT BAR 1 X 8 IN GRIP LOW’ ROW BAR CHAIN SER~L NUMBER CABLE ROUTING, DIAGRAM PARABO D~’, INC. RAMSEY, MINNESOTA ~ASSY IN’T, 827102 ~,,.

Summary of the content on the page No. 7

IN FLANGE LABEL., LAT.~R WARNING gUIDES (~,) BOTH ENDS scN WNYL SLEEVES (~) 3 X 2 IN END CAP’--~ ~ 3/8 X 2-3/4 IN BOLT (g) ~~.~~.. DETAIL A 3-1/’2 x I IN PULLEY m~(/.,,,--3/B X 2 ~N BOLT (2) FRONT UPRIGH]~ WLDMT. ROLLER PADS LOOK N~ (13) _WLDMT. LABEL, PARABODY LOG L .--. END ~P (21 ~~~~ I/2 X 3 IN BOLT ~~~