Omega TT300 user manual

Summary of the content on the page No. 1

User’s Guide
Shop online at
www.omega.com
e-mail: info@omega.com
TT 300
Adhesive Kit

Summary of the content on the page No. 2

DESCRIPTION TT300 Adhesive Kits are designed for trouble - free preparation and bonding of strain gauges to most surfaces. TT300 adhesives are also specially formulated for highest performance under the recommended environmental conditions and are packaged to provide the user with maximum control in mixing and application. Each adhesive is dated to ensure freshness of contents, together with details for proper handling, storage, mixing and application. PLEASE NOTE It is usually false eco

Summary of the content on the page No. 3

5. A clean piece of PTFE should now be placed over the gauge. A thin piece 1/8" to 1/4" of silicon rubber and metal back plate should be placed over the PTFE and a pressure of 15-50 psi applied, using spring clamps or deadweight. The rubber pad will ensure uniform distribution of the clamping pressure. 6. The clamped installation should be heated slowly to cure temperature at approximately 10 degrees Celsius per minute and cured as detailed in the Curing Cycle. 7. If post curing is required

Summary of the content on the page No. 4

Where Do I Find Everything I Need for Process Measurement and Control? OMEGA…Of Course! Shop online at www.omega.com TEMPERATURE
 Thermocouple, RTD & Thermistor Probes, Connectors, Panels & Assemblies
 Wire: Thermocouple, RTD & Thermistor
 Calibrators & Ice Point References
 Recorders, Controllers & Process Monitors
 Infrared Pyrometers PRESSURE, STRAIN AND FORCE
 Transducers & Strain Gages
 Load Cells & Pressure Gages
 Displacement Transducers
 Instrumentation & Acc