Makita 1002BA user manual

Summary of the content on the page No. 1

ENGLISH (Original instructions)

INSTRUCTION MANUAL
Curved Planer
1002BA

002539
DOUBLE INSULATION
IMPORTANT: Read Before Using. 1

Summary of the content on the page No. 2

ENGLISH (Original instructions) SPECIFICATIONS Model 1002BA Planing width 110 mm Planing depth 4 mm -1 No load speed (min) 15,000 Overall length 339 mm Net weight 5.2 kg Safety class II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-5 Save all warnings and Symbols The following show the symbols us

Summary of the content on the page No. 3

9. If operating a power tool in a damp location is accessories, or storing power tools. Such unavoidable, use a residual current device preventive safety measures reduce the risk of (RCD) protected supply. Use of an RCD reduces starting the power tool accidentally. the risk of electric shock. 21. Store idle power tools out of the reach of 10. Use of power supply via a RCD with a rated children and do not allow persons unfamiliar residual current of 30mA or less is always with the power too

Summary of the content on the page No. 4

7. Be sure the blade installation bolts are FUNCTIONAL DESCRIPTION securely tightened before operation. 8. Hold the tool firmly with both hands. 9. Keep hands away from rotating parts. CAUTION: 10. Before using the tool on an actual workpiece, • Always be sure that the tool is switched off and let it run for a while. Watch for vibration or unplugged before adjusting or checking function on wobbling that could indicate poor installation the tool. or a poorly balanced blade. Adjusti

Summary of the content on the page No. 5

For tool without lock button and lock-off button 1 1. Bolts To start the tool, simply pull the switch trigger. Release 2. Drum the switch trigger to stop. 3. Planer blade For tool with lock button 4. Drum cover To start the tool, simply pull the switch trigger. Release 5. Adjusting plate 2 the switch trigger to stop. 3 For continuous operation, pull the switch trigger and then 4 push in the lock button. 5 To stop the tool from the locked position, pull the switch 002555 trigger

Summary of the content on the page No. 6

1. Screwdriver 1. Sharpening 2. Chip cover holder 2 1 1 002593 002588 Use a screwdriver to remove the brush holder caps. Take First, loosen the two wing nuts on the holder and insert out the worn carbon brushes, insert the new ones and the blades (A) and (B), so that they contact the sides (C) secure the brush holder caps. and (D). Then tighten the wing nuts. 1. Brush holder cap 1. Wing nut 1 2. Blade (A) 3. Blade (B) 4. Side (D) 5. Side (C) 5 2 1 4 3 002594 002589

Summary of the content on the page No. 7

7

Summary of the content on the page No. 8

Makita Corporation Anjo, Aichi, Japan 8 884054A3 www.makita.com