Summary of the content on the page No. 1
GAS GRIDDLE
INSTALLATION & OPERATION
MANUAL
MKG24, MKG36, MKG48, MKG60 & MKG72
Built After June 1, 2003
MAILING - P.O. BOX 501, CONCORD, NH 03302-0501
SHIPPING - 10 FERRY ST. CONCORD, NH 03301
TEL: 800-258-3708 • 603-225-6684 • FAX: 603-225-8497
www.magikitchn.com
L25-050 Rev. 0
Summary of the content on the page No. 2
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE FOR YOUR SAFETY DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WARNING Improper installation, alteration, service or maintenance can cause property damage, injury or death. Read the installation, operating and maintenance instructions thorou
Summary of the content on the page No. 3
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION Table of Contents 1. INSTALLATION SECTION:................................................................................................................................................... 1 1.1. CHECKING YOUR NEW GRIDDLE: ......................................................................................................................... 1 1.2. INSTA
Summary of the content on the page No. 4
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1. INSTALLATION SECTION: 1.1. CHECKING YOUR NEW GRIDDLE: Your new griddle has been carefully packed into one crate. Every effort has been made to ensure that your new griddle is delivered to you in perfect condition. As you unpack your new appliance, inspect each of the pieces for damage. If something is damaged, Contact the shipper immediately; the shippe
Summary of the content on the page No. 5
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION WARNING NEVER supply the appliance with a gas that is not indicated on the data plate. Using the incorrect gas type will cause improper operation. If you need to convert the appliance to another type of fuel, contact your dealer. 1.3.1. Fuel Types: Each appliance is equipped to work with one type of fuel. The type of fuel with which the appliance is intend
Summary of the content on the page No. 6
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.5. INSTALLATION, SET UP: The installation of this appliance MUST conform to local codes. In the absence of local codes, the installation must conform to the National Fuel Gas Code, ANSI Z223.1; Natural Gas Installation Code, CAN/CGA-B149.1; or Propane Installation Code, CAN/CGA-B149.2 as applicable. A. Uncrate appliance and locate installation accessorie
Summary of the content on the page No. 7
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.5.3. For Use on Optional Equipment Stand: ATTENTION Rear mounting brackets should be installed to the Equipment Stand prior to placing griddle on the stand. CAUTION Only two of the four supplied casters are equipped with a locking feature. Install the griddle so that the two locking casters are at the front of the unit. The casters should be LOCKED befor
Summary of the content on the page No. 8
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.6. FINAL GAS CONNECTION: A properly installed gas supply system will deliver adequate pressure (7 to 8 inches w.c. for natural gas, 11 to 12 inches w.c. for propane) to all appliances connected to the line, operating at full demand. 1.6.1. Regulator Assembly: An adequate gas supply is important for the appliance to operate properly. Undersized lines or l
Summary of the content on the page No. 9
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 1.6.2. Gas Settings: Orifices are sized to provide proper gas flow to the rated BTU/hr for each model. Regulator pressure must be measured and adjusted before the unit goes into service, following installation and when operational performance is in question. Gas Type BTU/hr(kW) Manifold Manifold Per Burner Pressure Pressure WC" WC" (Matchless) (All Others)
Summary of the content on the page No. 10
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 2.2. INITIAL STARTUP: NOTICE: New griddles should be carefully tempered and cared for in order to avoid possible damage. To break in a new griddle, do the following: Wipe the griddle surface clean. A mild soapy water solution may be used to clean the surface, if this solution is used be sure to rinse thoroughly with fresh water to eliminate any soap residu
Summary of the content on the page No. 11
5 0 0 2 6 0 5 0 0 2 6 0 2 4 0 2 4 0 4 5 0 4 5 0 8 0 8 0 2 2 0 2 2 0 1 5 0 1 5 0 4 0 0 4 0 0 2 0 0 2 0 0 ° C ° C 1 8 0 1 8 0 MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 3. THERMOSTAT CALIBRATION SECTION: Each control typically operates a pair of burners with a Snap action, Electric or Solid State. The controls were set at the factory. However, if the griddle’s surface temperature varies greatly from
Summary of the content on the page No. 12
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 4. BASIC OPERATION: 4.1. OPERATIONAL HELPFUL HINTS: A. Each thermostat controls 12" of griddle surface, whenever possible, use the leftmost or rightmost thermostats for the lowest cooking temperatures. The adjacent thermostats set at higher temperatures will effect centrally located thermostats. B. For quicker thermostat response during heavy loading of th
Summary of the content on the page No. 13
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION 5. CLEANING & MAINTENANCE SECTION: 5.1. DAILY CLEANING: A. Clean the griddle surface often to prevent sticking and poor quality of food product. Scrape the griddle plate regularly with a scraper intended for your type of griddle surfaces to remove all surface grease and food debris. NOTICE: Do not use Grill Bricks, Grill Screens, or any other type of abras
Summary of the content on the page No. 14
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION F. Check to see that the ventilation hood and make up air systems are working properly. Any make up air system should not be directed as to impede the flow of combustion air to the griddle, or flue exhaust from the griddle. G. Inspect griddle surface for proper cleanliness. 5.4. TROUBLESHOOTING CHART: The following chart may help to eliminate any basic ope
Summary of the content on the page No. 15
MKG SERIES GAS GRIDDLE INSTALLATION & OPERATION Using MagiKitch'n chrome griddle accessories are important to maintaining the life of the griddle's chrome surface. 5.5.2. Optional: To order accessories for your griddle, call your local MagiKitch’n dealer for prices and availability. Accessories by Model MKG24 MKG36 MKG48 MKG60 MKG72 Service Shelf 8" 5125-1511601-C 5125-1511602-C 5125-1511603-C 5125-1511
Summary of the content on the page No. 16
MAILING ADDRESS - P.O. BOX 501, CONCORD, NH 03302-0501 SHIPPING ADDRESS - 10 FERRY ST. CONCORD, NH 03301 PHONE- 800-258-3708 • 603-225-6684 • FAX: 603-225-8497 www.magikitchn.com
